
网络出版:2025-10-14,
纸质出版:2025
移动端阅览
孙秀秀, 温盼奇, 张前, 等. 考虑GDL压缩变形的PEMFC综合性能评价分析[J]. 太阳能学报, 2025,46(9):375-381.
孙秀秀, 温盼奇, 张前, 等. 考虑GDL压缩变形的PEMFC综合性能评价分析[J]. 太阳能学报, 2025,46(9):375-381. DOI: doi:10.19912/j.0254-0096.tynxb.2024-0733.
在质子交换膜燃料电池(PEMFC)装配过程中
装配力会导致气体扩散层(GDL)出现压缩变形。为确定最佳装配力以提高燃料电池性能
通过试验和数值模拟方法
对PEMFC在不同装配力下GDL变形、电流密度分布和氧浓度分布进行分析。并通过综合考虑压降、功率密度和电流密度分布等多参数对PEMFC性能进行综合评价。研究结果表明:装配力导致GDL在肋下发生非线性应力-应变压缩
其中在2.0 MPa装配力下
压缩率达到61%。在0.95 A/cm2电流密度时
1.0 MPa下PEMFC的功率密度相比0.5 MPa提高装配力4.57%。而且根据熵权法评价发现1.0 MPa装配力下PEMFC综合性能最佳。
The compression deformation of the GDL is caused by assembly force. To determine the optimal assembly force for improving fuel cell performance
the GDL deformation
current density distribution
and oxygen concentration distribution of the PEMFC under different assembly forces were analyzed based on experimental and numerical simulation methods. The PEMFC performance was comprehensively evaluated by considering multiple parameters such as pressure drop
power density
and current density distribution. The results show that the assembly force resulted in nonlinear stress-strain compression of the GDL under the rib
with compression reaching 61 % at the assembly force of 2.0 MPa. The power density of PEMFC at 1.0 MPa increased by 4.57 % compared to the results of 0.5 MPa under 0.95 A cm. Moreover
the overall performance of PEMFC at 1.0 MPa was the best by using the entropy weighting method.
赵洪山, 潘思潮, 吴雨晨, 等. 基于深度确定性策略梯度的PEMFC的水泵和散热器联合控制研究[J]. 太阳能学报, 2024, 45(6): 92-101.
陈永辉, 苏建徽, 解宝, 等. 基于HHO-FA的PEMFC电堆辨识建模[J]. 太阳能学报, 2024, 45(3): 282-289.
陈宇轩, 陈涛, 刘士华, 等. 装配扭矩对PEMFC性能的影响[J]. 电池, 2020, 50(3): 215-219.
周怡博, 王建建. 装配压力对燃料电池扩散层影响的研究[J]. 系统仿真学报, 2016, 28(4): 991-996.
JING G X, HU C B, QIN Y Z, et al.Complex mechanisms of PEMFC performance variations influenced by both structural deformation and contact resistance under the clamping force[J]. International journal of hydrogen energy, 2024, 58: 137-148.
MOVAHEDI M, RAMIAR A, RANJBER A A.3D numerical investigation of clamping pressure effect on the performance of proton exchange membrane fuel cell with interdigitated flow field[J]. Energy, 2018, 142: 617-632.
JIANG W, ZHANG K, HUANG X, et al.Influence of clamping pressure on contact pressure uniformity and electrical output performance of proton exchange membrane fuel cell[J]. Applied energy, 2024, 353: 122021.
曹爱红, 王来华, 代世勋. 基于装配力的燃料电池性能数值解析[J]. 电源技术, 2021, 45(7): 844-847, 801.
蔡永华, 胡健平, 罗子贤. PEMFC船形堵块阴极流场的性能[J]. 电池, 2024, 54(1): 14-18.
张拴羊, 杨其国, 徐洪涛, 等. 不同流场结构对PEMFC性能影响的模拟研究[J]. 太阳能学报, 2023, 44(8): 62-67.
JIAO K, PARK J, LI X G.Experimental investigations on liquid water removal from the gas diffusion layer by reactant flow in a PEM fuel cell[J]. Applied energy, 2010, 87(9): 2770-2777.
ZAMEL N, LI X G, SHEN J, et al.Estimating effective thermal conductivity in carbon paper diffusion media[J]. Chemical engineering science, 2010, 65(13): 3994-4006.
TAMAYOL A, MCGREGOR F, BAHRAMI M.Single phase through-plane permeability of carbon paper gas diffusion layers[J]. Journal of power sources, 2012, 204: 94-99.
ZAMEL N, LI X G, SHEN J.Numerical estimation of the effective electrical conductivity in carbon paper diffusion media[J]. Applied energy, 2012, 93: 39-44.
RADHAKRISHNAN V, HARIDOSS P.Differences in structure and property of carbon paper and carbon cloth diffusion media and their impact on proton exchange membrane fuel cell flow field design[J]. Materials & design, 2011, 32(2): 861-868.
KELLER N, VON UNWERTH T.Advanced parametric model for analysis of the influence of channel cross section dimensions and clamping pressure on current density distribution in PEMFC[J]. Applied energy, 2022, 307: 118132.
WEI L, DAFALLA A M, JIANG F M.Effects of reactants/coolant non-uniform inflow on the cold start performance of PEMFC stack[J]. International journal of hydrogen energy, 2020, 45(24): 13469-13482.
0
浏览量
1
下载量
0
CSCD
关联资源
相关文章
相关作者
相关机构
京公网安备11010802024621