西北工业大学 翼型叶栅空气动力学国家级重点实验室,西安,710072
郝礼书*(1980—),男,四川威远人,博士,副教授,研究方向:流动控制. E-mail:haolishu@nwpu.edu.cn
纸质出版:2023
移动端阅览
郝礼书, 林梓佳, 屈昊阳, 等. 缝道几何构型对翼型气动特性的影响[J]. 空气动力学学报, 2023, 41(11): 36−45.
HAO Lishu, LIN Zijia, QU Haoyang, et al. Influence of slot geometry configuration on airfoil aerodynamic characteristics[J]. 2023, 41(11): 36-45.
郝礼书, 林梓佳, 屈昊阳, 等. 缝道几何构型对翼型气动特性的影响[J]. 空气动力学学报, 2023, 41(11): 36−45. DOI: 10.7638/kqdlxxb-2022.0188
HAO Lishu, LIN Zijia, QU Haoyang, et al. Influence of slot geometry configuration on airfoil aerodynamic characteristics[J]. 2023, 41(11): 36-45. DOI: 10.7638/kqdlxxb-2022.0188.
为深入研究翼型开缝抑制翼型吸力面流动分离的被动流动控制技术,在探讨开缝依据的基础上,针对NACA 4421翼型设计了7种缝道构型,并给出了缝道构型之间的几何联系,对比分析了曲线、折线及直线3种形式的缝道对翼型失速的控制效果,发现曲线缝道能够显著提高翼型的最大升力系数和失速迎角;分析了曲线缝道构型升力系数“双峰”现象的机理,提出了一种新型导流片缝道构型,该构型利用“科恩达效应”能够全面改善基准翼型的失速特性,失速迎角推迟可达14°,最大升力系数提高122%,达到2.785,可为增升装置设计提供新的思路和参考。
Airfoil slotted is a passive flow control technology that can effectively inhibit flow separation on the airfoil suction surface
and it has been widely studied by researchers domestically and abroad. In this study
slots on the airfoil NACA 4421 are investigated with numerical simulations. The selection of the slot location on the airfoil is first analyzed
and the influence of the geometry change of the slot on the stall characteristics of the airfoil is discussed. Seven slot configurations are designed
and the geometric relations among them are given. The flow control effects of slots with curve lines
polylines and straight lines
on the airfoil stall are compared. It is found that the curve-line slot can significantly improve the maximum lift coefficient and the stall angle of attack of the airfoil. The "double peak" phenomenon of the lift coefficient distribution of the curve-line slot airfoil is analyzed
and the design of a new deflector slot is proposed. This new slot configuration is based on the Coanda effect
and can improve the stall characteristics of the baseline airfoil comprehensively
with the stall angle of attack delayed by 14° and the maximum lift coefficient increased by 122% to 2.785. The deflector slot presented in this study provides a novel idea and reference for the design of high-lift devices.
ZHOU Y, LUO Z B, WANG L, et al. Plasma synthetic jet actuator for flow control: review[J]. Acta Aeronautica et Astronautica Sinica, 2022, 43(3): 025027. (in Chinese)
LI Y H, WU Y, LIANG H, et al. Exploration and outlook of plasma-actuated gas dynamics[J]. Advances in Mechanics, 2022, 52(1): 1-32. (in Chinese)
CHOI B, HONG Y, LEE B, et al. Adaptive flow separation control over an asymmetric airfoil[J]. International Journal of Aeronautical and Space Sciences, 2018, 19(2): 305-315. DOI: 10.1007/s42405-018-0029-z
XU H Y, MA C Y. Review of the Co-flow jet flow control method[J]. Advances in Aeronautical Science and Engineering, 2022, 13(6): 1-16 (in Chinese). doi: 10.16615/j.cnki.1674-8190.2022.06.01
ZHOU X L, WENG H P, GONG Y X, et al. Experimental study on effect of vortex generator design parameters on 40% thick airfoil[J]. Acta Energiae Solaris Sinica, 2022, 43(6): 212-218. (in Chinese)
HAO L S, GAO Y W, WEI B B. Experimental investigation of flow separation control over airfoil by upper surface flap with a gap[J]. International Journal of Aeronautical and Space Sciences, 2022, 23(5): 859-869. DOI: 10.1007/s42405-022-00488-x
YANG R, YANG S B, SUN X Y, et al. Effect of slits on aerodynamic characteristics of wind-driven airfoil[J]. Chinese Journal of Applied Mechanics, 2021, 38(1): 70-77. (in Chinese)
WEICK F E, SHORTAL J A. The effect of multiple fixed slots and a trailing-edge flap on the lift and drag of a Clark Y airfoil[R]. NACA Report No. 427, , 1932
LIU Z Y, CHU H B, CHEN Y C, et al. Stall characteristics of high-lift device improved by slotting on leading-edge slat[J/OL ] . Acta Aerodynamica Sinica, 2022: 1-8. (2022-04-07). https://kns.cnki.net/kcms/detail/51.1192.TK.20220407.1028.002.html https://kns.cnki.net/kcms/detail/51.1192.TK.20220407.1028.002.html . doi: 10.7638/kqdlxxb-2021.0392 (in Chinese)
ZHU J Y , ZHU M K, ZHANG T, et al. Improvement of the power extraction performance of a semi-active flapping airfoil by employing two-sided symmetric slot airfoil[J]. Energy, 2021, 227: 120458. DOI: 10.1016/j.energy.2021.120458
YEO H, LIM J. Application of a slotted airfoil for UH-60A helicopter performance[C]// American Helicopter Society Aerodynamics, Acoustics, and Test and Evaluation Technical Specialist Meeting, San Francisco, CA, 2002.
RAMZI M, ABDERRAHMANE G. Passive control via slotted blading in a compressor cascade at stall condition[J]. Journal of Applied Fluid Mechanics, 2013, 6(4): 571-580. DOI: 10.36884/jafm.6.04.20670
LU Z S, CHEN X, ZHANG Z M. Research on wind tunnel test method of model of slit parafoil at upper edge[J]. Aviation Precision Manufacturing Technology, 2020, 56(6): 26-29, 58. (in Chinese)
BELAMADI R, DJEMILI A, ILICA A, et al. Aerodynamic performance analysis of slotted airfoils for application to wind turbine blades[J]. Journal of Wind Engineering and Industrial Aerodynamics, 2016, 151: 79-99. DOI: 10.1016/j.jweia.2016.01.011
XIE Y H, CHEN J H, QU H C, et al. Numerical and experimental investigation on the flow separation control of S809 airfoil with slot[J]. Mathematical Problems in Engineering, 2013, 2013: 1-14. DOI: 10.1155/2013/301748
WHITMAN N, SPARKS R, ALI S, et al. Experimental investigation of slotted airfoil performance with modified slot configurations[C]// 24th AIAA Applied Aerodynamics Conference, San Francisco, California. Reston, Virginia: AIAA, 2006: 3481. doi: 10.2514/6.2006-3481
CHEN G L, WANG L J, YAN X K, et al. Numerical simulation on effect of aerodynamic performance of airfoil with slot on reverse ventilation of axial-flow fan[J]. Journal of China Coal Society, 2010, 35(8): 1395-1400. (in Chinese)
MOHAMED O S, IBRAHIM A A, ETMAN A K, et al. Numerical investigation of Darrieus wind turbine with slotted airfoil blades[J]. Energy Conversion and Management: X, 2020, 5: 100026. DOI: 10.1016/j.ecmx.2019.100026
NI Z, DHANAK M, SU T C. Improved performance of a slotted blade using a novel slot design[J]. Journal of Wind Engineering and Industrial Aerodynamics, 2019, 189: 34-44. DOI: 10.1016/j.jweia.2019.03.018
NI Z, DHANAK M, SU T C. Performance characteristics of airfoils with leading-edge tubercles and an internal slot[J]. AIAA Journal, 2019, 57(6): 2394-2407. DOI: 10.2514/1.J058145
BEYHAGHI S, AMANO R S. A parametric study on leading-edge slots used on wind turbine airfoils at various angles of attack[J]. Journal of Wind Engineering and Industrial Aerodynamics, 2018, 175: 43-52. DOI: 10.1016/j.jweia.2018.01.007
BEYHAGHI S, AMANO R S. Improvement of aerodynamic performance of cambered airfoils using leading-edge slots[J]. Journal of Energy Resources Technology, 2017, 139(5): 051204. DOI: 10.1115/1.4036047
YANG K, WANG H S, XU J Z, et al. Stalling feature research of wind turbine with fin[J]. Journal of Engineering Thermophysics, 2008, 29(1): 32-35. (in Chinese)
ZHANG L J, MA D C, GU J W, et al. Influence of shape of slotted airfoil on aerodynamic performance of vertical axis wind turbine[J]. Journal of Central South University (Science and Technology), 2019, 50(8): 1848-1856. (in Chinese)
ZHANG Z H, LI D, YANG Y. Passive flow control of multi-element airfoils using slat mini-trailing edge device[J]. Acta Aeronautica et Astronautica Sinica, 2017, 38(5): 120650. (in Chinese)
WOOD N, NIELSEN J. Circulation control airfoils: Past, present, future[C]// 23rd Aerospace Sciences Meeting, Reno, NV. Reston, Virginia: AIAA, 1985: 204. doi: 10.2514/6.1985-204
0
浏览量
0
下载量
0
CSCD
关联资源
相关文章
相关作者
相关机构
京公网安备11010802024621