壁温对压缩拐角流动影响的数值模拟研究

刘亮; 邱波; 曾磊; 姚杰; 朱目成

doi:10.7638/kqdlxxb-2019.0134

欢迎来到能源电力期刊网！

English Version 期刊登录

您当前的位置：

首页 >

文章列表页 >

壁温对压缩拐角流动影响的数值模拟研究

研究论文 | 更新时间：2026-05-28

- 壁温对压缩拐角流动影响的数值模拟研究
- Numerical simulation of wall temperature effect on compressive corner flow
- 空气动力学学报 2021年39卷第2期页码：117-124
- 作者机构：
  
  1. 西南科技大学制造科学与工程学院,绵阳,621010
  2. 中国空气动力研究与发展中心,绵阳,621000
- 作者简介：
  
  刘亮（1995-），男，四川宜宾人，硕士研究生，研究方向：高超声速气动热与热防护. E-mail：1257332205@qq.com
  朱目成*（1964-），教授，研究方向：检测技术与自动化. E-mail：zhumucheng@swust.edu.cn
- 基金信息：
  
  国家自然科学基金（11702315，11972361）
- DOI：10.7638/kqdlxxb-2019.0134
  中图分类号： V211.3
- 纸质出版：2021
- 稿件说明：
移动端阅览
刘亮, 邱波, 曾磊, 等. 壁温对压缩拐角流动影响的数值模拟研究[J]. 空气动力学学报, 2021, 39(2): 117−124.

LIU Liang, QIU Bo, ZENG Lei, et al. Numerical simulation of wall temperature effect on compressive corner flow[J]. 2021, 39(2): 117-124.
刘亮, 邱波, 曾磊, 等. 壁温对压缩拐角流动影响的数值模拟研究[J]. 空气动力学学报, 2021, 39(2): 117−124. DOI： 10.7638/kqdlxxb-2019.0134

LIU Liang, QIU Bo, ZENG Lei, et al. Numerical simulation of wall temperature effect on compressive corner flow[J]. 2021, 39(2): 117-124. DOI： 10.7638/kqdlxxb-2019.0134.

摘要

压缩拐角是高超声速飞行器上的典型非连续区域，其分离/再附结构对局部热环境有较大影响。本文采用基于Navier-Stokes方程的自研程序，开展了典型压缩拐角外形的气动热环境数值模拟研究，分析了不同壁温条件下压缩拐角的热环境分布规律。计算结果表明：随着壁温升高，流场整体结构变化不大，但由于近壁面流体物性参数变化较大，导致拐角分离涡分离点向前移动、再附点向后移动，拐角处干扰区扩大；压缩拐角大部分区域的热流随着壁温的升高而减小，且干扰区内热流减小的幅度比无干扰区更大，但热流并不完全遵循随壁温升高而减小的规律。另外，通过对比变壁温计算热流和热壁修正公式修正热流，发现热壁修正公式在干扰区存在精度降低、适用性不足的问题。本文的研究进一步加深了壁温对压缩拐角流动影响的认识，缩小了热壁修正公式的适用范围。

Abstract

Compression corner is a typical discontinuous region on hypersonic vehicle

and its separation/ reattachment structure has a great influence on the local thermal environment. In this paper

a self-developed program in-house DNS code is used to simulate the aerodynamic thermal dynamics of a typical compression corner in different wall temperatures. The results show that: with the increase of the wall temperature

the overall structure of the flow field changes little

but due to the large changes of the physical parameters of the fluid near the wall

the separation point of the corner separation vortex moves forward and the reattachment point moves backward

and the interference area at the corner expands; the heat flow in most regions of the compression corner decreases with the increase of the wall temperature

and the decrease range of the heat flow in the interference area is greater than that in the non interference area. However

the heat flux does not completely follow the law of decreasing with the increase of wall temperature. In addition

by comparing the calculation of heat flux with variable wall temperature and the correction of heat flux with hot wall correction formula

it is found that the accuracy of hot wall correction formula is reduced and the applicability is insufficient in the interference area. The research in this paper further deepens the understanding of the influence of wall temperature on the corner flow

and reduces the application scope of the hot wall correction formula.

关键词

Keywords

references

DAVIS J P, STURTEVANT B. Separation length in high-enthalpy shock/boundary-layer interaction[J]. Physics of Fluids, 2000, 12(10): 2661-2687.

TONG F, YU C, TANG Z, et al. Numerical studies of shock wave interactions with a supersonic turbulent boundary layer in compression corner Turning angle effects[J]. Computers Fluids, 2017, 149: 56-69.

SIMEONIDES G, HAASE W, MANNA M. Experimental, analytical, and computational methods applied to hypersonic compression ramp flows[J]. AIAA Journal, 1994, 32(2): 301-310. DOI: 10.2514/3.11985.

JOHN, BIBIN, SURENDRANATH, et al. Analysis of dimensionality effect on shock wave boundary layer interaction in laminar hypersonic flows.[J]. International Journal of Heat Fluid Flow, 2016.

LI S X, NI Z Y. Investigation of Laminar interactive flowfield in hypersonic flow[J]. Journal of Astronautics, 2003, 24(6): 547-551, 573. (in Chinese) DOI: 10.3321/j.issn:1000-1328.2003.06.001.

CHEN S Y. Hypersonic compression corner air thermal environment research[D]. Mianyang: China Center for aerodynamic research and development, 2014(in Chinese).

ZHAO Y L. Modeling of separated flow in hypersonic inlet and study of inactivation mechanism[D]. Changsha: National University of Defense Science and Technology, 2014(in Chinese).

MARINI M. Analysis of hypersonic compression ramp laminar flows under sharp leading edge conditions[J]. Aerospace Science and Technology, 2001, 5(4): 257-271. DOI: 10.1016/S1270-9638(01)01109-9.

THOMAS N, HERBERT O. Influence of the wall temperature and the entropy layer effects on double wedge shock boundary layer interactions, AIAA-2006-8136[R]. Reston: AIAA, 2006.

REINARTZ B, BALLMANN J, BOYCE R. Numerical investigation of wall temperature and entropy layer effects on double wedge shock / boundary layer interactions[C ] // 14th AIAA/AHI Space Planes and Hypersonic Systems and Technologies Conference, Canberra, Australia. Reston, Virigina: AIAA, 2006. doi: 10.2514/6.2006-8137

SHANG Q, CHEN L, LI X, et al. Wall temperature effect on transition flow and separated flow in hypersonic flow around a blunt double wedge[J]. Acta Aeronautica et Astronautica Sinica, 2014, 35(11): 2958-2969. (in Chinese) DOI: 10.7527/S1000-6893.2014.0162.

NEUENHAHN T, OLIVIER H. Influence of the wall temperature and the entropy layer effects on double wedge shock boundary layer interactions[C]// AIAA/AHI Space Planes Hypersonic Systems Technologies Conference. 2011.

DAI G Y, JIA H Y, ZENG L, et al. Effects of fluid-thermal-structural coupling on inlet parameters of hypersonic intake[J]. Journal of Propulsion Technology, 2018, 39(6): 1267-1274. (in Chinese) DOI: 10.13675/j.cnki.tjjs.2018.06.009.

QIU B, GUO Y J, ZHANG H Y, et al. Free stream parameters' effects on vortexes and aerodynamic heating environment in thermal protection tile transverse gaps[J]. Acta Aeronautica et Astronautica Sinica, 2016, 37(3): 761-770. (in Chinese) DOI: 10.7527/S1000-6893.2015.0177.

ZHANG H Y, ZONG W G, GUI Y W. Numerical investigation of flow in leading-edge gap of hypersonic vehicle[J]. Journal of Astronautics, 2014, 35(8): 893-900. (in Chinese) DOI: 10.3873/j.issn.1000-1328.2014.08.005.

MENTER F R. Zonal two equation k-ω models for aerodynamic flows: AIAA-93-2906 [R ] . Reston: AIAA, 1993.

ZHOU Y, QIAN W Q, DENG Y Q, et al. Preliminary analysis of the influence of parameters in K - ω SST two equation turbulence model[J]. Acta aerodynamics Sinica, 2010 (02): 213-217(in Chinese).

中国人民解放军总装备部. 高超声速气动热和热防护[M]. 张志成, 主编. 北京: 国防工业出版社. 2003.

童秉纲, 尹协远, 朱克勤. 涡运动理论[M]. 合肥: 中国科学技术大学出版社, 2009: 10-13.

WANG Z F, BAI H C, GUI Y W. Analysis of factors affecting flow separation of compression wedge[C]// Fourteenth National Conference on shock wave and shock tube. 2010. (in Chinese)

CHEN Y, HENLINE W. Chemical nonequilibrium Navier-Stokes solutions for hypersonic flow over an ablating graphite nosetip[C ] // 28th Thermophysics Conference, Orlando, FL, USA. Reston, Virigina: AIAA, 1993. doi: 10.2514/6.1993-2836

GUI Y W, LIU L, DAI G Y, et al. Research status and software development of fluid thermal solid coupling for hypersonic vehicles[J]. Acta Aeronautica Sinica, 2017, 38 (07): 92-110.

ZENG L, QIU B, LI Y, et al. Influence of sensor surface temperature on heat flux measurement[J]. Acta Aeronautica et Astronautica Sinica, 2018, 39(6): 121940. (in Chinese) DOI: 10.7527/S1000-6893.2018.21940.

浏览量

下载量

CSCD

文章被引用时，请邮件提醒。

提交

工具集

关联资源

安装效应对螺旋桨纯音噪声的影响

类HyTRV升力体阻尼/交叉动导数特性分析

大展弦比飞行器突风响应数值计算

离心通风机降噪研究进展

基于LBM方法的LAGOON起落架噪声预测与降噪方法研究