流体推力矢量技术验证机研制及飞行试验研究

曹永飞; 顾蕴松; 韩杰星

doi:10.7638/kqdlxxb-2017.0202

欢迎来到能源电力期刊网！

English Version 期刊登录

您当前的位置：

首页 >

文章列表页 >

流体推力矢量技术验证机研制及飞行试验研究

研究论文 | 更新时间：2026-05-28

- 流体推力矢量技术验证机研制及飞行试验研究
- Development and flight testing of a fluidic thrust vectoring demonstrator
- 空气动力学学报 2019年37卷第4期页码：593-599
- 作者机构：
  
  1. 中国航空工业空气动力研究院,沈阳,110034
  2. 南京航空航天大学航空宇航学院,南京,210016
- 作者简介：
  
  曹永飞(1985-), 男, 河南开封人, 工程师, 博士, 主要从事飞行器动力模拟风洞实验、推力矢量喷管技术、流体测量、流动控制等研究.E-mail:cyffb1@163.com
- 基金信息：
- DOI：10.7638/kqdlxxb-2017.0202
  中图分类号： V211.7
- 纸质出版：2019
- 稿件说明：
移动端阅览
曹永飞, 顾蕴松, 韩杰星. 流体推力矢量技术验证机研制及飞行试验研究[J]. 空气动力学学报, 2019, 37(4): 593-599.

CAO Yongfei, GU Yunsong, HAN Jiexing. Development and flight testing of a fluidic thrust vectoring demonstrator[J]. 2019, 37(4): 593-599.
曹永飞, 顾蕴松, 韩杰星. 流体推力矢量技术验证机研制及飞行试验研究[J]. 空气动力学学报, 2019, 37(4): 593-599. DOI： 10.7638/kqdlxxb-2017.0202.

CAO Yongfei, GU Yunsong, HAN Jiexing. Development and flight testing of a fluidic thrust vectoring demonstrator[J]. 2019, 37(4): 593-599. DOI： 10.7638/kqdlxxb-2017.0202.

摘要

为验证被动二次流推力矢量技术的有效性，评估其飞行控制能力，研制了一架基于被动二次流推力矢量动力装置的验证机模型并开展了飞行试验研究。以完成筋斗机动动作的时间和半径作为流体推力矢量控制性能的评估参数。采用微型航姿传感器记录了验证机模型在有无流体矢量作用时完成筋斗动作的俯仰角和俯仰角速度数据，并通过无线数据传输装置传回地面加以储存和分析。飞行试验结果显示，在使用流体矢量情况下，验证机完成筋斗机动动作的半径由单独舵面控制时的约9倍机身长度减小为2倍机身长度、平均时间由4.93 s降为2.28 s、最大俯仰角速度的均值由114.5°/s提高到了270.3°/s。该结果证实了被动二次流推力矢量技术在急剧飞行状态下能够发挥作用，且具有较强的姿态控制效能。

Abstract

A demonstrator model based on passive secondary flow thrust vector power device was developed and the flight test was carried out

in order to verify the effectiveness of the passive secondary flow thrust vectoring technique and to evaluate its ability to change the attitude. The maneuvering time and radius of the loop maneuver were chosen as evaluation parameters of fluidic thrust vectoring control performance. The pitch angle and pitch rate data of the demonstrator model completed loop maneuver with and without vectors were recorded by micro-attitude sensors

and the data were sent back to the ground through the wireless data transmission device to store and analyze. The results show that

after employing the fluidic vectoring

the radius of the loop maneuver is reduced from 9 times the length of the fuselage to 2 times

the average time is reduced from 4.93s to 2.28s

and the mean value of maximum pitch rate is increased from 114.5°/s to 270.3°/s

compared with only rudder control. The results confirm that the passive secondary flow thrust vectoring technique can work in the rapid flight state and has a strong attitude control efficiency.

关键词

Keywords

references

WANG Q, WANG Q. Computational analysis on static internal flow field of shock vector controlled vectoring exhaust nozzles[J]. Journal of Aerospace Power, 2006, 21(4):681-685. (in Chinese)

MILLER D, YAGLE P, HAMSTRA J. Fluidic throat skewing for thrust vectoring in fixed-geometry nozzles[R]. AIAA 1999-0365, 1999.

WANG F, E R Q T, LI J J, et al. Numerical simulation of two-dimensional fluidic throat skewing vector nozzle[J]. Journal of Beijing University of Aeronautics and Astronautics, 2010, 36(4):388-392. (in Chinese)

FLAMM J D, DEERE K A, BERRIER B L, et al. Experimental study of a dual-throat fluidic thrust-vectoring nozzle concept[R]. AIAA 2005-3503, 2005.

LI Y H, LI J Q, YANG D G, et al. Numerical study of a dual-throat fluidic thrust vectoring nozzle[J]. Acta Aerodynamica Sinica, 2015, 33(2):211-217. (in Chinese)

STRYKOWSKI P J, KROTHAPALLI A, FORLITI D J. Counterflow thrust vectoring of supersonic jets[R]. AIAA 1996-0115, 1996.

YANG J J. Research on Aerodynamic characteristics of counterflow thrust vector nozzle[D]. Master Dissertation, NanJing, Nanjing University of Aeronautics and Astronautics, 2007. (in Chinese)

MASON M S, CROWTHER W J. Fluidic thrust vectoring for low observable air vehicles[R]. AIAA 2004-2210, 2004.

SONG M J, PARK S H, CHANG H B, et al. Application of back-step conada flap for the supersonic co-flowing fluidic thrust vector control[R]. AIAA 2013-3951, 2013.

XIAO Z Y, GU Y S, JIANG X, et al. A new fluidic thrust vectoring technique based on ejecting mixing effects[J]. Acta Aeronautica et Astronautica Sinica, 2012, 33(11):1967-1974. (in Chinese)

CAO Y F, GU Y S, CHENG K M, et al. The proportion control of jet deflection with passive secondary flow[J]. Acta Aeronautica et Astronautica Sinica, 2015, 36(3):757-763. (in Chinese)

SONG Y F, GAO F, HE Z L. Fluidic thrust vectoring technique[J]. Aerodynamic Missile Journal, 2010, 11:71-75, 89. (in Chinese)

FIELDING J P, LAWSON C P, PIRES R M, et al. Design, build and flight of the demon demonstrator UAV[R]. AIAA 2011-6963.

BOUGAS L, HORNUNG M. Propulsion system integration and thrust vectoring aspects for scaled jet UAVs[J]. CEAS Aeronautical Journal, 2013, 4(3):327-343.

HUA Y G, XU H J, LIU L, et al. Routine maneuver performance evaluation of a fighter with thrust vector[J]. Flight Dynamics, 2006, 24(4):6-9. (in Chinese)

LIU X M, TIAN F L, YU Z G. Simulation research of flight test techniques for thrust vector aircraft[J]. Flight Dynamics, 2007, 25(3):1-4. (in Chinese)

CHENG C F. Analysis of super maneuverability of Su-37 fighter[J]. Jiangsu Aviation, 1998, 1:12-13. (in Chinese)

浏览量

下载量

CSCD

文章被引用时，请邮件提醒。

提交

工具集

关联资源

风扇叶片颗粒侵蚀特性的多因素分析与模拟

离心通风机降噪研究进展

某型电动跑车尾翼气动设计的仿真与试验研究

水滴撞击运动超疏水表面特性及其调控

基于LBM方法的LAGOON起落架噪声预测与降噪方法研究