预弯曲动力学防斜打快技术深层次提速机制

狄勤丰; 彭章祝; 骆大坤; 刘湘华; 于洋; 王文昌; 陈锋

doi:10.7623/syxb202606010

欢迎来到能源电力期刊网！

English Version 期刊登录

您当前的位置：

首页 >

文章列表页 >

预弯曲动力学防斜打快技术深层次提速机制

石油工程 | 更新时间：2026-07-10

- 预弯曲动力学防斜打快技术深层次提速机制
- In-depth enhancement mechanism of pre-bending dynamic vertical and fast drilling technology
- 石油学报 2026年47卷第6期页码：1258-1266
- 作者机构：
  
  1. 上海大学力学与工程科学学院,上海,200444
  2. 上海市应用数学和力学研究所,上海,200444
  3. 中国石油化工股份有限公司西北油田分公司,新疆,乌鲁木齐,830011
  4. 上海大学机电工程与自动化学院,上海,200444
- 作者简介：
- 基金信息：
- DOI：10.7623/syxb202606010
  中图分类号： TE242
- 网络首发：2026-07-02，
  
  纸质出版：2026
- 稿件说明：
移动端阅览
狄勤丰, 彭章祝, 骆大坤, 刘湘华, 于洋, 王文昌, 陈锋. 预弯曲动力学防斜打快技术深层次提速机制[J]. 石油学报, 2026, 47(6): 1258-1266,1277.

Di Qinfeng, Peng Zhangzhu, Luo Dakun, et al. In-depth enhancement mechanism of pre-bending dynamic vertical and fast drilling technology[J]. ACTA PETROLEI SINICA, 2026, 47(6): 1258-1266.
狄勤丰, 彭章祝, 骆大坤, 刘湘华, 于洋, 王文昌, 陈锋. 预弯曲动力学防斜打快技术深层次提速机制[J]. 石油学报, 2026, 47(6): 1258-1266,1277. DOI： 10.7623/syxb202606010.

Di Qinfeng, Peng Zhangzhu, Luo Dakun, et al. In-depth enhancement mechanism of pre-bending dynamic vertical and fast drilling technology[J]. ACTA PETROLEI SINICA, 2026, 47(6): 1258-1266. DOI： 10.7623/syxb202606010.

摘要

预弯曲动力学防斜打快技术(PBDVD)是一种使用广泛的低成本防斜提速钻井技术

通过带预弯结构底部钻具组合(PB-BHA)的有序涡动

在钻头上形成较大的防斜力

从而实现防斜和提速双重目的。对这种技术的深层次提速机制进行了研究

在建立和求解PB-BHA动力学模型的基础上

重点分析PB-BHA的涡动特征

研究弯角这一关键参数对钻头上的动态侧向力和动态轴向力的影响

进一步深层次探明PBDVD的提速机制。研究结果表明

对于所给算例和常用的螺杆钻具(弯角＜1.5°)

钻头上的动态防斜力会随着弯角的增大呈现出增大的趋势

但当弯角超过一定值后

防斜力的变化逐步趋于平缓;随着弯角的增大

钻头上的动态轴向力的平均值呈现线性增大趋势

也即弯角越大

钻头对井底的动态钻压愈大

而且其不均匀度逐渐增加

尤其当弯角超过0.7° 时

这种不均度随着弯角的增大而增加

并且在0.7°~0.9° 弯角范围内有一个快速增加。因此

PBDVD的提速机制一方面是由于防斜力提高

允许使用较大的钻压

进而实现提速;另一方面动态钻压的平均值和不均度也得到提高

这有益于钻头对井底岩石的破坏

进一步实现提速。

Abstract

Pre-bending dynamic vertical and fast drilling (PBDVD) technology is a widely adopted

cost-effective drilling technique for deviation control and rate-of-penetration (ROP) enhancement. By facilitating the ordered whirling motion of a pre-bent bottom hole assembly (PB-BHA)

the technology generates a substantial restoration force at the bit

thereby achieving the dual objectives of verticality control and accelerated drilling. This paper explores the underlying ROP enhancement mechanisms of PBDVD. Following the development and numerical solution of a PB-BHA dynamic model

the research focuses on analyzing the whirl behaviors of the assembly and the influence of the bent angle

a very important key parameter

on the dynamic lateral and axial bit forces. Particular emphasis is placed on the effect of the bent angle of PB-BHA on bit lateral and axial forces to further elucidate the enhancement mechanisms of PBDVD. Results indicate that for the specified case study and commonly utilized PDM (with bent angles less than 1.5°)

the dynamic anti-deviation force on the bit tends to increase with the bent angle

but gradually plateaus when the bent angle exceeds a certain threshold. Concurrently

the mean dynamic axial force on the bit exhibits a linear increase relative to the bent angle; specifically

a larger bent angle results in a greater dynamic weight-on-bit (WOB) exerted on the bottom hole. Furthermore

the heterogeneity of the dynamic axial force progressively enhances with increasing bent angle

particularly when the bent angle exceeds a critical value (0.7°)

with a rapid surge observed within the 0.7°-0.9° range. Based on the research findings

the ROP enhancement mechanism of PBDVD can be expanded into two aspects: (1) The improvement of the anti-deviation force allows for the application of a higher WOB

thereby increasing the ROP; and (2) Enhanced mean dynamic WOB and intensified force heterogeneity also promote rock fragmentation at the bottom hole

further contributing to ROP increase.

关键词

Keywords

references

狄勤丰,骆大坤,周星,等. 横向主动控斜力作用下底部钻具组合动力学特征[J].石油学报,2023,44(9):1552-1561.

狄勤丰,吴玉禄,石向前.预弯曲动力学防斜打快技术初探[J].石油学报,2003,24(3):86-89.

DI Qinfeng,CHANG Y,ZHOU Hejun.The application and evaluation of a new vertical and fast drilling technology in Tuha oilfield[R].SPE 87969,2004.

狄勤丰,朱卫平,姚建林,等.预弯曲动力学防斜打快钻具组合动力学模型[J].石油学报,2007,28(6):118-121.

ZHU Weiping,DI Qinfeng.Effect of prebent deflection on lateral vibration of stabilized drill collars[J].SPE Journal,2011,16(1):200-216.

王清华,徐振平,张荣虎,等.塔里木盆地油气勘探新领域、新类型及资源潜力[J].石油学报,2024,45(1):15-32.

JANSEN J D.Non-linear rotor dynamics as applied to oilwell drillstring vibrations[J].Journal of Sound and Vibration,1991,147(1):115-135.

汝大军,李立昌,陆红,等.预弯曲钻具组合特性分析及其应用[J].石油钻采工艺,2003,25(4):14-16.

胥思平,狄勤丰,张新旭,等.预弯曲动力学防斜快钻技术的试验研究[J].天然气工业,2006,26(3):59-61.

周俊昌,余雄鹰,罗勇,等.复合钻井防斜打快技术研究与应用[J].中国海上油气,2007,19(3):188-191.

张进双,王春辉,张贤印.一种防斜打快钻井技术的提速机制及实践[J].西部探矿工程,2021,33(3):91-94.

WANG Wenchang,ZHANG He,LI Ning,et al.The dynamic deviation control mechanism of the prebent pendulum BHA in air drilling[J].Journal of Petroleum Science and Engineering,2019,176:521-531.

王文昌,冯大君,狄勤丰,等.预弯钟摆BHA在不同钻井介质中的动力学特征及其应用[J].石油学报,2021,42(9):1237-1246.

张鹤,狄勤丰,覃光煦,等.预弯底部钻具组合横向振动响应的快速求解[J].石油学报,2017,38(12):1441-1447.

刘科柔,张辉,王新锐,等.双稳定器预弯曲钻具组合防斜特性动力学评价方法[J].石油钻采工艺,2021,43(3):281-288.

苏前荣,刘伟,高蓬,等.预弯曲动力学防斜打快钻具组合优化研究[J].石油地质与工程,2025,39(4):116-121.

HU Yibao,DI Qinfeng,ZHU Weiping,et al.Dynamic characteristics analysis of drillstring in the ultra-deep well with spatial curved beam finite element[J].Journal of Petroleum Science and Engineering,2012,82-83:166-173.

DYKSTRA M W.Nonlinear drill string dynamics[D].Tulsa:The University of Tulsa,1996.

祝效华,刘清友,童华.三维井眼全井钻柱系统动力学模型研究[J].石油学报,2008,29(2):288-291.

WANG Chunsheng,MIN Chuanzhong,ZHANG Hao,et al.Analysis of secondary makeup characteristics of drill collar joint and prediction of downhole equivalent impact torque of Well SDTK1[J].Petroleum Exploration and Development,2024,51(3):697-705.

CHRISTOFOROU A P,YIGIT A S.Dynamic modelling of rotating drillstrings with borehole interactions[J].Journal of Sound and Vibration,1997,206(2):243-260.

HOHL A,KUECK A,KULKE V,et al.The nature of the interaction between bit-whirl and high-frequency torsional oscillations[R].IPTC 23989,2024:1-15.

冯建强,孙诗一.四阶龙格-库塔法的原理及其应用[J].数学学习与研究,2017(17):3-5.

刘清友,杨迎新,叶道辉,等.油气钻头技术演进历史与发展趋势[J].石油学报,2025,46(12):2389-2409.

祝效华,刘伟吉,石昌帅,等.重载冲击破岩提速机理实验[J].石油学报,2024,45(10):1529-1537.

祝效华,阳飞龙,刘伟吉.液柱压力下PDC齿切削破岩机理[J].石油学报,2025,46(10):1943-1959.

浏览量

下载量

CSCD

文章被引用时，请邮件提醒。

提交

工具集

关联资源

石油充注对储层成岩作用影响研究现状与展望

砂岩与碳酸盐岩储层油气成藏动力机制物理模拟

北极地区低温钻井液研究进展与发展方向

页岩气藏注气吞吐提高采收率作用机制与评价方法

2026年47卷第6期