1. 太原理工大学 电气与动力工程学院,山西,太原,030024
2. 上海锅炉厂有限公司,上海,200245
李律通(2000—),男,山西长治人,硕士研究生,研究方向为化学链燃烧。冯于川(通信作者),男,副教授,博士,E-mail:fengyuchuan@tyut.edu.cn。
纸质出版:2026
移动端阅览
李律通, 冯于川, 向祖林, 闫凯, 韩志江, 王娜娜. 循环流化床粉煤灰作为惰性载体的免烧铁基载氧体造粒成型及性能[J]. 动力工程学报, 2026, 46(6): 44-52.
李律通, 冯于川, 向祖林, 闫凯, 韩志江, 王娜娜. 循环流化床粉煤灰作为惰性载体的免烧铁基载氧体造粒成型及性能[J]. 动力工程学报, 2026, 46(6): 44-52. DOI: 10.19805/j.cnki.jcspe.2026.250081.
DOI: 10.19805/j.cnki.jcspe.2026.250081
以循环流化床(CFB)粉煤灰作为惰性载体
以Fe2O3作为活性组分
采用挤出-滚圆法制备了系列免烧Fe2O3/CFB粉煤灰载氧体颗粒
并测试了其力学性能及反应性能。研究发现
碱激发剂Ca(OH)2对CFB粉煤灰的活性效果优于NaOH
Ca(OH)2质量分数为5%时
活化效果最佳
载氧体颗粒抗压强度可以达到16.92 MPa
破碎载荷近似服从正态分布
平均破碎载荷达到53.1 N。活性组分Fe2O3与Ca(OH)2活化后的CFB粉煤灰质量比为1.5 ∶1时
载氧体颗粒抗压强度可以达到17.38 MPa
磨损率仅为0.92%
力学性能最好
且兼具良好的反应性能
综合性能最佳。CFB粉煤灰作为惰性载体的载氧体颗粒的性能与Al2O3作为惰性载体相当
验证了CFB粉煤灰作为惰性载体的可行性。
A series of non-calcined Fe2O3/circulating fluidized bed (CFB) fly ash oxygen carrier particles were prepared by CFB fly ash as the inert support and Fe2O3 as the active component via the extrusion-spheronization method
and their mechanical and reactive properties were tested. It was found that the activation effect of Ca(OH)2 on CFB fly ash is superior to that of NaOH. When the mass fraction of Ca(OH)2 is 5%
the optimal activation effect can be achieved
with the compressive strength of the oxygen carrier particles reaching 16.92 MPa. The crushing load distribution is approximately found to follow a normal pattern
with an average crushing load of 53.1 N. When the mass ratio of Fe2O3 to Ca(OH)2-activated CFB fly ash is set at 1.5∶1
the compressive strength of the oxygen carrier particles could reach 17.38 MPa
and the wear rate is only 0.92%
indicating the best mechanical properties. Moreover
good reactivity and the best comprehensive performance are also observed. The performance of oxygen carrier particles with CFB fly ash as the inert support is found to be similar to that with Al2O3 as the inert support
verifying the feasibility of using CFB fly ash as an inert support.
ZHANG Yanan, HAN Hongjing, ZHU Nini, et al. Chemical looping combustion for coupling with efficient CO2 capture and utilization: stable oxygen carriers and carbon cycle[J]. Industrial & Engineering Chemistry Research, 2025, 64(4): 1933-1967.
金红光, 王宝群. 化学能梯级利用机理探讨[J]. 工程热物理学报, 2004, 25(2): 181-184.JIN Hongguang, WANG Baoqun. Principle of cascading utilization of chemical energy[J]. Journal of Engineering Thermophysics, 2004, 25(2): 181-184.
李振山, 韩海锦, 蔡宁生. 化学链燃烧的研究现状及进展[J]. 动力工程, 2006, 26(4): 538-543.LI Zhenshan, HAN Haijin, CAI Ningsheng. Research status and progress of chemical-looping combustion[J]. Journal of Power Engineering, 2006, 26(4): 538-543.
ZHAO Yifan, LIU Dunyu, FENG Yongcheng, et al. Behavior and design of Fe-based oxygen carriers in chemical looping combustion: a review[J]. Chemical Engineering Journal, 2024, 499: 156582.
WANG Jingquan, ZHENG Min, WANG Hua, et al. Inert supports enhanced sulphur-resistant of iron-based oxygen carriers in chemical looping combustion of element sulphur[J]. Chemical Engineering and Processing -Process Intensification, 2024, 196: 109672.
LI Yu, WANG Li, CHEN Daifen, et al. Experimental and theoretical study on performance of Cu-Fe spinel supported with certain inerts during chemical looping combustion[J]. Chemical Engineering Journal, 2024, 495: 153591.
刘玉楼, 郑敏, 蒲思旭. Fe2O3/MgO载氧体反应性能的研究[J]. 动力工程学报, 2020, 40(9): 757-764, 780.LIU Yulou, ZHENG Min, PU Sixu. Study on reaction properties of Fe2O3/MgO oxygen carrier[J]. Journal of Chinese Society of Power Engineering, 2020, 40(9): 757-764, 780.
赵一凡, 刘敦禹, 金晶. 化学链燃烧中载氧体结构设计对抗磨性的影响研究[J]. 动力工程学报, 2024, 44(4): 509-519.ZHAO Yifan, LIU Dunyu, JIN Jing. Study on effect of structure design of oxygen carriers in chemical looping combustion on abrasion resistance[J]. Journal of Chinese Society of Power Engineering, 2024, 44(4): 509-519.
KUANG Cao, WANG Shuzhong, LV Song, et al. Comparison of metallic oxide, natural ore and synthetic oxygen carrier in chemical looping combustion process[J]. International Journal of Hydrogen Energy, 2021, 46(34): 18032-18041.
KWONG K Y, HARRISON A R P, GEBERS J C, et al. Chemical looping combustion of a biomass char in Fe2O3-, CuO-, and SrFeO3-δ-based oxygen carriers[J]. Energy & Fuels, 2022, 36(17): 9437-9449.
DANESHMAND-JAHROMI S, SEDGHKERDAR M H, MAHINPEY N. A review of chemical looping combustion technology: fundamentals, and development of natural, industrial waste, and synthetic oxygen carriers[J]. Fuel, 2023, 341: 127626.
YU Zhongliang, LI Chunyu, JING Xuliang, et al. Catalytic chemical looping combustion of carbon with an iron-based oxygen carrier modified by K2CO3: catalytic mechanism and multicycle tests[J]. Fuel Processing Technology, 2015, 135: 119-124.
AISYAH L, ASHMAN P J, KWONG C W. Performance of coal fly-ash based oxygen carrier for the chemical looping combustion of synthesis gas[J]. Applied Energy, 2013, 109: 44-50.
石司默, 董长青, 覃吴, 等. Fe2O3/粉煤灰载氧体化学链燃烧实验与机理研究[J]. 化工学报, 2012, 63(12): 4010-4018.SHI Simo, DONG Changqing, QIN Wu, et al. Experimental and theoretical study of Fe2O3/coal ash oxygen carrier in CLC system[J]. CIESC Journal, 2012, 63(12): 4010-4018.
SKULIMOWSKA A, DI FELICE L, KAMI AN' SKA-PIETRZAK N, et al. Chemical looping with oxygen uncoupling (CLOU) and chemical looping combustion (CLC) using copper-enriched oxygen carriers supported on fly ash[J]. Fuel Processing Technology, 2017, 168: 123-130.
HUANG Xin, FAN Maohong, WANG Xingjun, et al. A cost-effective approach to realization of the efficient methane chemical-looping combustion by using coal fly ash as a support for oxygen carrier[J]. Applied Energy, 2018, 230: 393-402.
MA Zhong, ZHANG Shuai, XIAO Rui. Insights into the relationship between microstructural evolution and deactivation of Al2O3 supported Fe2O3 oxygen carrier in chemical looping combustion[J]. Energy Conversion and Management, 2019, 188: 429-437.
0
浏览量
0
下载量
0
CSCD
关联资源
相关文章
相关作者
相关机构
京公网安备11010802024621