金属氢化物储氢反应器内反应死区优化对储氢性能影响的数值模拟

陈泽祺; 闫素英; 张伟; 杨利冬; 周少斌; 高明

doi:10.19805/j.cnki.jcspe.2025.240472

欢迎来到能源电力期刊网！

English Version 读者登录期刊登录

您当前的位置：

首页 >

文章列表页 >

金属氢化物储氢反应器内反应死区优化对储氢性能影响的数值模拟

氢能技术专题 | 更新时间：2026-02-02

- 金属氢化物储氢反应器内反应死区优化对储氢性能影响的数值模拟
- Numerical Simulation on Effect of Reaction Dead Zone Optimization on Hydrogen Storage Performance in Metal Hydride Hydrogen Storage Reactor
- 动力工程学报 2025年45卷第3期页码：474-480
- 作者机构：
  
  1. 山东大学核科学与能源动力学院, 高效储能及氢能利用山东省工程研究中心,山东,济南,250061
  2. 内蒙古国龙能源管理有限责任公司,内蒙古,呼和浩特,010000
- 作者简介：
  
  [ "陈泽祺(1998—),男,黑龙江大庆人,硕士研究生,研究方向为固态储氢技术" ]
  [ "高明(通信作者),男,教授,博士,E-mail:gm@sdu.edu.cn" ]
- 基金信息：
  
  山东省自然科学基金资助项目(ZR2023ME025);内蒙古自治区中央引导地方科技发展资金资助项目(2024ZY0125)
- DOI：10.19805/j.cnki.jcspe.2025.240472
  中图分类号： TK91
- 网络出版：2025-03-15，
  
  纸质出版：2025
- 稿件说明：
移动端阅览
陈泽祺,闫素英,张伟,杨利冬,周少斌,高明. 金属氢化物储氢反应器内反应死区优化对储氢性能影响的数值模拟动力工程学报, 2025, 45(3): 474-480 https://doi.

org/10.19805/j.cnki.jcspe.2025.240472
陈泽祺,闫素英,张伟,杨利冬,周少斌,高明. 金属氢化物储氢反应器内反应死区优化对储氢性能影响的数值模拟动力工程学报, 2025, 45(3): 474-480 https://doi. DOI： 10.19805/j.cnki.jcspe.2025.240472.

org/10.19805/j.cnki.jcspe.2025.240472 DOI：

摘要

针对金属氢化物储氢的热效应问题

建立了储氢反应器的二维仿真模型

研究了在反应死区内增设换热管束对储氢性能的影响

获得了不同尺寸反应器死区的管束优化布置方式。结果表明:在半径为45 mm的反应器中增设15根换热管后

反应死区内金属氢化物温度由339 K降至297.6~311.4 K

反应分率由0.2~0.5升至0.89以上;当反应器半径分别为35、45和55 mm时

反应死区的最优管数分别为6、15和18

与未优化前相比

储氢时间分别缩短了8.53%、9.95%和9.68%

而换热管束体积分数仅增加了0.49%、0.74%和0.60%

且优化后不同尺寸反应器储氢时间的最大变化幅度小于2.43%

因此增设管束可有效消除反应死区对储氢性能的影响。

Abstract

In order to solve the problem of the thermal effect of hydrogen storage in metal hydride

a two-dimensional simulation model of the hydrogen storage reactor was developed

and the influence of adding heat exchange tube bundles in the reaction dead zone on the hydrogen storage performance was studied. The optimal arrangement of the tube bundles in the dead zone of the reactor with different sizes was obtained. Results show that when 15 tubes are added in the dead zone of 45 mm radius reactor

the temperature of the metal hydride in the dead zone decreases from 339 K to 297.6-311.4 K

and the reaction fraction increases from 0.2-0.5 to above 0.89. When the reactor radius is 35

45 and 55 mm

the optimal number of dead zone tubes is 6

15 and 18

respectively

which results in a reduction of hydrogen storage time by 8.53%

9.95% and 9.68% compared with that before optimization. The volume fraction of the tube bundles only increases by 0.49%

0.74% and 0.60%

respectively

and the maximal variation in hydrogen storage time across reactors of varying sizes is less than 2.43% after optimization. Therefore

the addition of tubes can effectively eliminate the effect of the dead zone on the hydrogen storage.

关键词

Keywords

references

WANG Di, WANG Yuqi, HUANG Zhuonan, et al. Design optimization and sensitivity analysis of the radiation mini-channel metal hydride reactor[J]. Energy, 2019, 173: 443-456.

刘康祥, 周家辉, 徐钢, 等. 面向高比例可再生能源消纳的光储氢醇一体化系统规划与调度[J]. 动力工程学报, 2023, 43(11): 1477-1486. LIU Kangxiang, ZHOU Jiahui, XU Gang, et al. Planning and scheduling of integrated system of light hydrogen storage and methanol for high proportion of renewable energy consumption[J]. Journal of Chinese Society of Power Engineering, 2023, 43(11): 1477-1486.

CHANDRA S, SHARMA P, MUTHUKUMAR P, et al. Modeling and numerical simulation of a 5 kg LaNi 5 -based hydrogen storage reactor with internal conical fins[J ] . International Journal of Hydrogen Energy, 2020, 45(15): 8794-8809.

NGUYEN H Q, SHABANI B. Review of metal hydride hydrogen storage thermal management for use in the fuel cell systems[J]. International Journal of Hydrogen Energy, 2021, 46(62): 31699-31726.

GARRISON S L, HARDY B J, GORBOUNOV M B, et al. Optimization of internal heat exchangers for hydrogen storage tanks utilizing metal hydrides[J]. International Journal of Hydrogen Energy, 2012, 37(3): 2850-2861.

姚莉, 张峰鸣, 赵明. 三套管相变蓄热器导热肋片的拓扑优化[J]. 动力工程学报, 2023, 43(4): 397-405. YAO Li, ZHANG Fengming, ZHAO Ming. Topology optimization of heat conduction fins in three-tube phase change heat accumulator[J]. Journal of Chinese Society of Power Engineering, 2023, 43(4): 397-405.

MOHAN G, PRAKASH M M, SRINIVASA M S. Performance simulation of metal hydride hydrogen storage device with embedded filters and heat exchanger tubes[J]. International Journal of Hydrogen Energy, 2007, 32(18): 4978-4987.

WANG Di, WANG Yuqi, WANG Feng, et al. Optimal design of disc mini-channel metal hydride reactor with high hydrogen storage efficiency[J]. Applied Energy, 2022, 308: 118389.

BAI Xiaoshuai, YANG Weiwei, TANG Xinyuan, et al. Hydrogen absorption performance investigation of a cylindrical MH reactor with rectangle heat exchange channels[J]. Energy, 2021, 232: 121101.

FENG Penghui, LIU Yang, AYUB I, et al. Optimal design methodology of metal hydride reactors for thermochemical heat storage[J]. Energy Conversion and Management, 2018, 174: 239-247.

RAJU N N, MUTHUKUMAR P, VIVEK S P, et al. Design methodology and thermal modelling of industrial scale reactor for solid state hydrogen storage[J]. International Journal of Hydrogen Energy, 2019, 44(36): 20278-20292.

YANG Fusheng, MENG Xiangyu, DENG Jianqiang, et al. Identifying heat and mass transfer characteristics of metal hydride reactor during adsorption: improved formulation about parameter analysis[J]. International Journal of Hydrogen Energy, 2009, 34(4): 1852-1861.

王兴国. 金属氢化物吸/放氢过程及储氢容器性能模拟研究[D]. 大连: 大连理工大学, 2021.

JEMNI A, NASRALLAH S B, LAMLOUMI J. Experimental and theoretical study of a metal-hydrogen reactor[J]. International Journal of Hydrogen Energy, 1999, 24(7): 631-644.

CHANG H, TAO Y B, WANG W Y. Numerical study on storage performance of metal hydride reactors with multiple spiral fins[J]. International Journal of Hydrogen Energy, 2023, 48(90): 35170-35184.

浏览量

下载量

CSCD

文章被引用时，请邮件提醒。

提交

工具集

关联资源

基于解耦方法探究N₂、CO₂对生物质气层流燃烧速度的影响

利用旋流效应强化太阳能PV/T系统性能研究

尾缘开裂对翼型气动性能及静力结构的影响研究

超临界电站锅炉末级过热器管屏汽固两相流动特性数值模拟研究

螺旋翅片和环形翅片对相变储能罐传热性能的影响