华北水利水电大学能源与动力工程学院
纸质出版:2022
移动端阅览
徐启, 刘家森, 李书金, 等. 缠绕管式换热器流体流动换热性能分析[J]. 能源研究与管理, 2022,(4):122-128.
徐启, 刘家森, 李书金, et al. Analysis of Fluid Flow Heat Transfer Performance of Wound Tube Heat Exchangers[J]. 2022, (4): 122-128.
徐启, 刘家森, 李书金, 等. 缠绕管式换热器流体流动换热性能分析[J]. 能源研究与管理, 2022,(4):122-128. DOI: 10.16056/j.2096-7705.2022.04.020.
徐启, 刘家森, 李书金, et al. Analysis of Fluid Flow Heat Transfer Performance of Wound Tube Heat Exchangers[J]. 2022, (4): 122-128. DOI: 10.16056/j.2096-7705.2022.04.020.
为了深入了解缠绕管式换热器的特性,通过建立圆管缠绕管换热器的几何模型,采用Fluent仿真数值模拟软件对其管内流动进行模拟,并利用origin软件对各个工况下的管内模拟结果数据进行处理,分析了不同工况下圆管缠绕管对缠绕管换热器内流体流动的影响。结果表明:RNG k-ε湍流模型计算结果的平均误差为5.8%,与实验值的变化趋势基本一致;管程入口流量对壳程出口温度的影响小于管程出口流量对壳程出口温度的影响,壳程温度的分布情况随着管程流量的增大而变得更加均匀;对管程综合评价指标PEC指数分析表明,管程流量的增大会造成相对应的管程压降的增大,摩擦系数的变化则相反,两者的变化幅度均随着管程流量的增大而趋于平缓,换热效果强化显著。
In order to understand the characteristics of the winding heat exchanger
the influence of the winding tube on the fluid flow in the winding tube heat exchanger under different operating conditions was studied by establishing the geometric model of the round tube winding tube heat exchanger
using Fluent simulation numerical simulation software to simulate its in-tube flow
and using origin software to process the data of the in-tube simulation results under each operating condition.The results show that: the average error of the calculated results of the RNG k-ε turbulence model is 5.8%
which is basically consistent with the trend of the experimental value; the influence of the tube inlet flow rate on the shell outlet temperature is smaller than the influence of the tube outlet flow rate on the shell outlet temperature
and the distribution of the shell temperature becomes more uniform with the increase of the tube flow rate. The analysis of the PEC index
a comprehensive evaluation index of the tube process
shows that the analysis of the PEC index shows that the increase of the tube flow rate will cause the corresponding increase of the pressure drop in the tube process
while the change of the friction coefficient is the opposite
and the change amplitude of both tends to level off with the increase of the tube process flow rate
and the heat exchange effect is strengthened significantly.
缠绕管式换热器内流场模拟与传热过程强化[D]. 田杨.青岛科技大学,2017
螺旋缠绕管换热器传热数值模拟[D]. 马飞.郑州大学,2014
缠绕管式换热器计算方法研究[D]. 于清野.大连理工大学,2011
印刷电路板式换热器超临界二氧化碳传热特性分析[J]. 岳晓明;王为术;朱晓静.能源研究与管理,2022(01)
节能型换热设备与流程的一体化创新[J]. 陈永东;程沛;于改革;吴晓红;闫永超.流体机械,2018(10)
Numerical investigation on gas flow heat transfer and pressure drop in the shell side of spiral-wound heat exchangers[J]. TANG QiXiong;CHEN GaoFei;YANG ZhiQiang;SHEN Jun;GONG MaoQiong.Science China(Technological Sciences),2018(04)
可再生能源综合利用的研究现状与展望[J]. 吴利乐;郑源;王爱华;任岩.华北水利水电大学学报(自然科学版),2015(03)
螺旋缠绕管式换热器在石油化工中的应用[J]. 许胜军;盖小厂;王宁.山东化工,2015(04)
扭曲三叶管传热与流阻性能的数值研究[J]. 王定标;王宏斌;梁珍祥.化工学报,2012(07)
换热器的研究发展现状[J]. 支浩;汤慧萍;朱纪磊.化工进展,2009(S1)
高效缠绕管式换热器的节能分析与工业应用[J]. 张贤安.压力容器,2008(05)
缠绕管式换热器在加氢裂化装置的首次应用[J]. 何文丰.石油化工设备技术,2008(03)
Generalized air-side friction and heat transfer correlations for wavy-fin compact heat exchangers[J]. Naef A.A. Qasem;Syed M. Zubair.International Journal of Refrigeration,2018
Effects of spacing bars on the performance of spiral-wound heat exchanger and the fitting of empirical correlations[J]. Simin Wang;Guanping Jian;Xin Tong;Jian Wen;Jiyuan Tu.Applied Thermal Engineering,2018
Experimental analysis of heat transfer enhancement in shell and helical tube heat exchangers[J]. N. Jamshidi;M. Farhadi;D.D. Ganji;K. Sedighi.Applied Thermal Engineering,2013(1-2)
Fluid Flow and Heat Transfer Characteristics in Helical Tubes Cooperating with Spiral Corrugation[J]. Ya-xia Li;Jian-hua Wu;Hang Wang;Li-ping Kou;Xiao-hang Tian.Energy Procedia,2012(PA)
0
浏览量
12
下载量
0
CSCD
关联资源
相关文章
相关作者
相关机构
京公网安备11010802024621