十字交叉型微通道内液滴形成的数值模拟研究

罗钧午; 李冬梅; 梁帅; 王帅超; 肖曙红

doi:10.12052/gdutxb.200005

欢迎来到能源电力期刊网！

English Version 期刊登录

您当前的位置：

首页 >

文章列表页 >

十字交叉型微通道内液滴形成的数值模拟研究

综合研究 | 更新时间：2026-05-27

- 十字交叉型微通道内液滴形成的数值模拟研究
- A Research on Numerical Simulation of Droplet Generation in Crossing Microchannels
- 广东工业大学学报 2020年37卷第5期页码：68-74
- 作者机构：
  
  1. 广东工业大学机电工程学院,广东,广州,510006
  2. 广东顺德创新设计研究院,广东,佛山,528300
- 作者简介：
  
  罗钧午(1988–)，男，硕士研究生，主要研究方向为微流控液滴技术、多相流的仿真研究
  肖曙红(1968–)，男，教授，主要研究方向为精密机械CAE技术、高效精密制造装备，E-mail：shxiao@gdut.edu.cn
- 基金信息：
  
  国家自然科学基金资助项目(50975051)
- DOI：10.12052/gdutxb.200005
  中图分类号： TH776
- 网络首发：2020-09-17，
  
  纸质出版：2020
- 稿件说明：
移动端阅览
罗钧午, 李冬梅, 梁帅, 王帅超, 肖曙红. 十字交叉型微通道内液滴形成的数值模拟研究[J]. 广东工业大学学报, 2020, 37(5): 68-74.

Luo Jun-wu, Li Dong-mei, Liang Shuai, et al. A Research on Numerical Simulation of Droplet Generation in Crossing Microchannels[J]. 2020, 37(5): 68-74.
罗钧午, 李冬梅, 梁帅, 王帅超, 肖曙红. 十字交叉型微通道内液滴形成的数值模拟研究[J]. 广东工业大学学报, 2020, 37(5): 68-74. DOI： 10.12052/gdutxb.200005.

Luo Jun-wu, Li Dong-mei, Liang Shuai, et al. A Research on Numerical Simulation of Droplet Generation in Crossing Microchannels[J]. 2020, 37(5): 68-74. DOI： 10.12052/gdutxb.200005.

摘要

基于Fluent软件的流体体积分数（Fluid Volume Fraction

VOF）模型

针对十字交叉型微通道内液滴的形成过程开展了三维数值模拟研究

分别研究了连续相黏度、分散相黏度、两相界面张力系数、壁面接触角对液滴形成的影响

为实际应用提供参考。研究表明随着连续相流速的增加

液滴生成直径减少

生成频率增大; 增加连续相黏度时

液滴生成直径变小

生成频率的变化则相反; 当分散相黏度超过连续相黏度时

出现射流现象而不能生成液滴; 液滴生成直径随两相界面张力系数的增加而增大

生成频率降低; 增大壁面接触角有利于液滴的产生

且两相流速为0.01 m/s和0.02 m/s时

接触角应分别取到150°和120°才能正常生成液滴。

Abstract

Based on the fluid volume fraction (VOF) model of Fluent software

the droplet generation process in crossing microchannel was investigated by three-dimensional numerical simulation study

and the influences of continuous phase viscosity

dispersed phase viscosity

two-phase interfacial tension and wall contact angle on droplet generation were researched respectively

providing reference for practical applications. The simulation results showed that the droplet size decreased and the generation frequency increased with the increasing flow velocity of continuous phase. When the continuous phase viscosity was increased

the droplet size would decrease and the generation frequency change was opposite. If the dispersed phase viscosity exceeded the continuous phase viscosity

the jet flow phenomenon would occur and the droplets could not be generated. With the increase of the interfacial tension coefficient of two phases

the droplet size would increase

and the formation frequency would decrease. Increasing wall contact angle is beneficial to droplet generation

and when the two-phase flow rate was 0.01 m/s and 0.02 m/s

the contact angle should be set to 150° and 120° respectively to generate droplets normally.

关键词

Keywords

references

GONG Y, HU J, GAO B, et al . Advances in real-time detection of cardiovascular diseases [J ] . Science in China: Technical Science, 2016, 46(11): 1116-1134.

LIN Y Y, WU J B. High throughput material synthesis, characterization and testing platform based on microfluidic technology [J]. Chinese Journal of Nature, 2017, 39(2): 103-114.

WU J, HUANG L H, WANG Y H, et al . Application of microfluidic chip electrophoresis in food safety and environmental pollution detection [J ] . Journal of Analytical Testing, 2015, 34(3): 283-288.

GAO K X, FAN Y Q, JIN Z M, et al . Application of microfluidic chip in enhanced oil recovery [J ] . Fault Block Oil and Gas Field, 2018, 25(2): 269-272.

DONG L, HUO D Q, ZHOU J, et al . Application progress of microfluidic chip in food safety analysis [J ] . Journal of Analytical Testing, 2015, 34(4): 483-487.

ZHAO C X, MILLER E, COOPER-WHITE J J, et al . Effects of fluid-fluid interfacial elasticity on droplet formation in microfluidic devices [J ] . Aiche Journal, 2011, 57(7): 1669-1677.

TUCKERMAN D B, PEASE R. High-performance heat sinking for VLSI [J]. IEEE Electron Device Letters, 1981, 2(5): 126-129.

林炳承. 微纳流控芯片实验室[M]. 北京: 科学出版社, 2013.

CHEN B, GUO F, LI G J, et al . Three-dimensional simulation of bubble formation through a microchannel t-junction [J ] . Chemical Engineering Technology, 2013, 36(12): 1-15.

RAJ R, MATHUR N, BUWA V V, et al . Numerical simulations of liquid-liquid flows in microchannels [J ] . Industrial Engineering Chemistry Research, 2010, 49(21): 10606-10614.

SOMASEKHARA G S, ARNAB A. CFD analysis of microfluidic droplet formation in non–newtonian liquid [J]. Chemical Engineering Journal, 2017, 330: 245-261.

WANG W M, MA Y P, CHEN B. Numerical simulation of droplet formation in crossing micro-channels [J]. Journal of Chemical Engineering, 2015, 66(5): 1633-1641.

YANG L, ZHOU W, WANG X H, et al . Microdroplet formation mechanism based on flow focusing structure [J ] . Micro-electronic Technology, 2015, 52(9): 576-580.

CHEN M R, QIAN J Y, LI X J, et al . Numerical analysis of droplet formation at unsteady dispersed phase velocity in crossing microchannels [J ] . Journal of Chemical Engineering of University of China, 2008, 32(3): 522-528.

吴梁玉. 双乳液的制备及其流体动力学行为研究[D]. 南京: 东南大学, 2016.

吴平. 液滴微流控的实验应用和理论研究[D]. 合肥: 中国科学技术大学, 2014.

ZHONG Y C, TAN X Q, YANG Y M. Discussion on several Issues in microfluid mechanism [J]. Journal of Guangdong University of Technology, 2001, 18(3): 46-48.

浏览量

下载量

CSCD

文章被引用时，请邮件提醒。

提交

工具集

关联资源

扭转式叶轮对阻力式管道水轮机的性能影响研究

湿热地区城市街道植物形态特征对交通源PM2.5质量浓度分布特性的影响研究

静压钢板桩贯入阻力试验与数值仿真

循环流化床锅炉风室内流动特性及优化研究

天然气掺氢燃烧技术在旋流式燃气灶上的数值模拟研究