Flow control around a three dimensional square cylinder with free-end slot suction

ZENG Lingwei; WANG Hanfeng; PENG Si

doi:10.7638/kqdlxxb-2018.0205

English Version Journal Login

您当前的位置：

首页 >

文章列表页 >

Flow control around a three dimensional square cylinder with free-end slot suction

更新时间：2026-05-28

- Flow control around a three dimensional square cylinder with free-end slot suction
- Vol. 38, Issue 6, Pages: 1093-1101(2020)
- 作者机构：
  
  1. 中南大学土木工程学院,长沙,410075
  2. 中南大学高速铁路建造技术国家工程实验室,长沙,410075
- 作者简介：
- 基金信息：
- DOI：10.7638/kqdlxxb-2018.0205
  CLC： V211.3
- Published：2020
- 稿件说明：
移动端阅览
曾令伟, 王汉封, 彭思. 自由端狭缝吸气控制三维方柱绕流[J]. 空气动力学学报, 2020, 38(6): 1093-1101.

ZENG Lingwei, WANG Hanfeng, PENG Si. Flow control around a three dimensional square cylinder with free-end slot suction[J]. 2020, 38(6): 1093-1101.
曾令伟, 王汉封, 彭思. 自由端狭缝吸气控制三维方柱绕流[J]. 空气动力学学报, 2020, 38(6): 1093-1101. DOI： 10.7638/kqdlxxb-2018.0205.

ZENG Lingwei, WANG Hanfeng, PENG Si. Flow control around a three dimensional square cylinder with free-end slot suction[J]. 2020, 38(6): 1093-1101. DOI： 10.7638/kqdlxxb-2018.0205.

摘要

利用大涡模拟（LES）方法研究了顶部定常狭缝吸气对正方形截面有限长柱体的气动力与绕流特性的影响规律。对比了吸气系数

=0、1、3时的气动力特性及绕流情况，尤其是自由端附近的流动结构。

∞

，其中

为吸气狭缝入口风速，

∞

为自由来流速度。研究发现，顶部定常吸气可以有效地抑制三维柱体气动力，且

=1时抑制效果最为显著，相对于无控制工况，时均阻力$\overline{C_{D}}$、脉动阻力

和脉动升力

分别减少了3.92%、19.08%和40.88%。在

=1时，柱体自由端负压和压力脉动最为显著，有利于柱体两侧形成上升流；顶面压力脉动最强有利于自由端剪切流与尾流间的动量交换，可以有效地抑制柱体展向涡脱落，减小柱体气动力；同时柱体顶面流动出现再附分离现象；而在

=3时柱体顶面大部分区域流动分离被完全抑制。

Abstract

Large eddy simulation (LES) is used to study the influence of free-end steady slot suction on the aerodynamic forces and flow around a three dimensional finite-length square cylinder with a square cross-section. The aerodynamic forces and the flow around the cylinder have been compared systematically for the suction ratios

1 and 3. Special attention is paid on the flow around the free end of the cylinder. It is found that free-end steady slot suction can effectively suppress the aerodynamic forces of the model.

The Controlling result is the best when

=1. Relative to the none control case

the mean drag

fluctuating drag

and fluctuating lift are decreased by 3.92%

19.08%

and 40.88%

respectively. The mean negative pressure and fluctuating pressure on the free end are most significant at

which enhances the upwash flow along cylinder side faces and the momentum exchange between free-end shear flow and near wake flow. Thus

this behavior effectively suppresses the spanwise vortex shedding and the aerodynamic forces of the cylinder; at the same time

the flow separation and reattachment occurred on the top of the cylinder. When

the flow separation in most areas of the top surface of the cylinder is completely inhibited.

关键词

Keywords

references

SATTARI P, BOURGEOIS J A, MARTINUZZI R J. On the vortex dynamics in the wake of a finite surface-mounted square cylinder[J]. Experiments in Fluids, 2012, 52(5):1149-1167. DOI:10.1007/s00348-011-1244-6

KAWAI H, OKUDA Y, OHASHI M. Near wake structure behind a 3D square prism with the aspect ratio of 2.7 in a shallow boundary layer flow[J]. Journal of Wind Engineering and Industrial Aerodynamics, 2012, 104-106:196-202. DOI:10.1016/j.jweia.2012.04.019

WANG H F, PENG S, ZHOU Y, et al. Transition along a finite-length cylinder in the presence of a thin boundary layer[J]. Experiments in Fluids, 2016, 57(5):66. DOI:10.1007/s00348-016-2160-6

WANG H F, ZHOU Y, CHAN C K, et al. Effect of initial conditions on interaction between a boundary layer and a wall-mounted finite-length-cylinder wake[J]. Physics of Fluids, 2006, 18(6):065106. DOI:10.1063/1.2212329

WANG H F, ZHOU Y. The finite-length square cylinder near wake[J]. Journal of Fluid Mechanics, 2009, 638:453-490. DOI:10.1017/s0022112009990693

PORTEOUS R, MOREAU D J, DOOLAN C J. A review of flow-induced noise from finite wall-mounted cylinders[J]. Journal of Fluids and Structures, 2014, 51:240-254. DOI:10.1016/j.jfluidstructs.2014.08.012

SAKAMOTO H, ARIE M. Vortex shedding from a rectangular prism and a circular cylinder placed vertically in a turbulent boundary layer[J]. Journal of Fluid Mechanics, 1983, 126:147-165. DOI:10.1017/s0022112083000087

PATTENDEN R J, TURNOCK S R, ZHANG X. Measurements of the flow over a low-aspect-ratio cylinder mounted on a ground plane[J]. Experiments in Fluids, 2005, 39(1):10-21. DOI:10.1007/s00348-005-0949-9

TANAKA S, MURATA S.An investigation of the wake structure and aerodynamic characteristics of a finite circular cylinder. Time-averaged wake structures behind circular cylinders with various aspect ratios[J]. JSME International Journal Series B, 1999, 42(2):178-187. DOI:10.1299/jsmeb.42.178

GU M, QUAN Y. Across-wind loads of typical tall buildings[J]. Journal of Wind Engineering and Industrial Aerodynamics, 2004, 92(13):1147-1165. DOI:10.1016/j.jweia.2004.06.004

QUAN Y, GU M. Across-wind equivalent static wind loads and responses of super-high-rise buildings[J]. Advances in Structural Engineering, 2012, 15(12):2145-2155. DOI:10.1260/1369-4332.15.12.2145

KIM Y C, BANDI E K, YOSHIDA A, et al. Response characteristics of super-tall buildings-Effects of number of sides and helical angle[J]. Journal of Wind Engineering and Industrial Aerodynamics, 2015, 145:252-262. DOI:10.1016/j.jweia.2015.07.001

TANAKA H, TAMURA Y, OHTAKE K, et al. Experimental investigation of aerodynamic forces and wind pressures acting on tall buildings with various unconventional configurations[J]. Journal of Wind Engineering and Industrial Aerodynamics, 2012, 107-108:179-191. DOI:10.1016/j.jweia.2012.04.014

KWOK K C S, BAILEY P A. Aerodynamic devices for tall buildings and structures[J]. Journal of Engineering Mechanics, 1987, 113(3):349-365. DOI:10.1061/(asce)0733-9399(1987)113:3(349)

ZHANG H F, XIN D B, OU J P. Steady suction for controlling across-wind loading of high-rise buildings[J]. The Structural Design of Tall and Special Buildings, 2016, 25(15):785-800. DOI:10.1002/tal.1283

ZHENG C R, ZHANG Y C. Computational fluid dynamics study on the performance and mechanism of suction control over a high-rise building[J]. The Structural Design of Tall and Special Buildings, 2012, 21(7):475-491. DOI:10.1002/tal.622

ZHENG C R, ZHANG Y C. Numerical investigation of the wind-load reduction for a high-rise building by suction[J]. Journal of Basic Science and Engineering, 2010, 18(1):80-90.(in Chinese) DOI:10.1631/jzus.A0900593.

ZHENG C R, REN K, WU Y, et al. Experimental research on the characteristics of mean wind loads of high-rise buildings controlled by upper-surface suction[J]. Journal of Wuhan University of Technology, 2015, 37(6):60-65.(in Chinese) DOI:10.3963/j.issn.1671-4431.2015.06.012

ZHENGC R, ZHANG J T, ZHANG Z D. Experimental investigation on characteristics of mean wind loads of high-rise buildings controlled by corner recession and air-suction[J]. Journal of Building Structures, 2016, 37(10):125-131.(in Chinese) DOI:10.14006/j.jzjgxb.2016.10.015

ZHANG D, CHENG L, AN H W, et al. Direct numerical simulation of flow around a surface-mounted finite square cylinder at low Reynolds numbers[J]. Physics of Fluids, 2017, 29(4):045101. DOI:10.1063/1.4979479

PARK C W, LEE S J. Effects of free-end corner shape on flow structure around a finite cylinder[J]. Journal of Fluids and Structures, 2004, 19(2):141-158. DOI:10.1016/j.jfluidstructs.2003.12.001

WANG H F, PENG S, LI Y, et al. Control of the aerodynamic forces of a finite-length square cylinder with steady slot suction at its free end[J]. Journal of Wind Engineering and Industrial Aerodynamics, 2018, 179:438-448. DOI:10.1016/j.jweia.2018.06.016

SMAGORINSKY J. General circulation experiments with the primitive equations[J]. Monthly Weather Review, 1963, 91(3):99-164. DOI:10.1175/1520-0493(1963)0910099:gcewtp2.3.co; 2

KRAJNOVIC S, DAVIDSON L. Large-eddy simulation of the flow around a bluff body[J]. AIAA Journal, 2002, 40:927-936. DOI:10.2514/3.15142

崔文诗.基于合成射流技术的汽车非定常流动控制研究[D].上海: 同济大学, 2017.

OGUNREMI A, SUMNER D. On the effects of incidence angle on the mean wake of a surface-mounted finite-height square prism[C ] //Proceedings of ASME/JSME/KSME 2015 Joint Fluids Engineering Conference, Seoul, South Korea, 2015. DOI: 10.1115/AJKFluids2015-15011

WANG H F, ZHAO D W, ZOU C, et al. Aerodynamic forces of a cantilevered square prism with aspect ratio of 5[J]. Journal of Experiments in Fluid Mechanics, 2015, 29(6):8-15.(in Chinese) DOI:10.11729/syltlx20150040

MCCLEAN J F, SUMNER D. An experimental investigation of aspect ratio and incidence angle effects for the flow around surface-mounted finite-height square prisms[J]. Journal of Fluids Engineering, 2014, 136(8):081206. DOI:10.1115/1.4027138

SAHA A K. Unsteady flow past a finite square cylinder mounted on a wall at low Reynolds number[J]. Computers Fluids, 2013, 88:599-615. DOI:10.1016/j.compfluid.2013.10.010

XIE L J, ZHANG S, ZHANG J F, et al. A feature-based data mining method for fluid dynamics[J]. Acta Aerodynamica Sinica, 2010, 28(5):540-546.(in Chinese) DOI:10.3969/j.issn.0258-1825.2010.05.010

Views

下载量

CSCD

Alert me when the article has been cited

提交

Tools

Publicity Resources

Numerical simulation of hypersonic magnetofluid control based on non-linear coupling constitutive relation

Influence of slotted track on aerodynamic characteristics of high-speed maglev train

Research status of aerodynamic design for integrated propulsion and airframe in near-space high-altitude long-endurance (HALE) UAVs

Preface to the special column on “UAV Aero-Propulsive Integration Design”

Influence of windbreak distance on the aerodynamic performance of high-speed trains by large eddy simulation

Related Author

Shi Hao

Xiao Hong

Zhou Li

Wang Zhanxue

Liu Feng

Yue Si

Wu Xiaolong

Li Xiao

Related Institution

Collaborative Innovation Center for Advanced Aero-Engine, Beijing

School of Power and Energy, Northwestern Polytechnical University, Xi'an

Key Laboratory of Traffic Safety on the Track of Ministry of Education, Central South University, Changsha

China Railway Siyuan Survey and Design Group Co., Ltd, Wuhan

School of Aeronautic Science and Engineering, Beihang University, Beijing

AI问答

⁰