Di Qinfeng, Peng Zhangzhu, Luo Dakun, et al. In-depth enhancement mechanism of pre-bending dynamic vertical and fast drilling technology[J]. ACTA PETROLEI SINICA, 2026, 47(6): 1258-1266.
Di Qinfeng, Peng Zhangzhu, Luo Dakun, et al. In-depth enhancement mechanism of pre-bending dynamic vertical and fast drilling technology[J]. ACTA PETROLEI SINICA, 2026, 47(6): 1258-1266.DOI: 10.7623/syxb202606010.
In-depth enhancement mechanism of pre-bending dynamic vertical and fast drilling technology
摘要
预弯曲动力学防斜打快技术(PBDVD)是一种使用广泛的低成本防斜提速钻井技术
通过带预弯结构底部钻具组合(PB-BHA)的有序涡动
在钻头上形成较大的防斜力
从而实现防斜和提速双重目的。对这种技术的深层次提速机制进行了研究
在建立和求解PB-BHA动力学模型的基础上
重点分析PB-BHA的涡动特征
研究弯角这一关键参数对钻头上的动态侧向力和动态轴向力的影响
进一步深层次探明PBDVD的提速机制。研究结果表明
对于所给算例和常用的螺杆钻具(弯角<1.5°)
钻头上的动态防斜力会随着弯角的增大呈现出增大的趋势
但当弯角超过一定值后
防斜力的变化逐步趋于平缓;随着弯角的增大
钻头上的动态轴向力的平均值呈现线性增大趋势
也即弯角越大
钻头对井底的动态钻压愈大
而且其不均匀度逐渐增加
尤其当弯角超过0.7° 时
这种不均度随着弯角的增大而增加
并且在0.7°~0.9° 弯角范围内有一个快速增加。因此
PBDVD的提速机制一方面是由于防斜力提高
允许使用较大的钻压
进而实现提速;另一方面动态钻压的平均值和不均度也得到提高
这有益于钻头对井底岩石的破坏
进一步实现提速。
Abstract
Pre-bending dynamic vertical and fast drilling (PBDVD) technology is a widely adopted
cost-effective drilling technique for deviation control and rate-of-penetration (ROP) enhancement. By facilitating the ordered whirling motion of a pre-bent bottom hole assembly (PB-BHA)
the technology generates a substantial restoration force at the bit
thereby achieving the dual objectives of verticality control and accelerated drilling. This paper explores the underlying ROP enhancement mechanisms of PBDVD. Following the development and numerical solution of a PB-BHA dynamic model
the research focuses on analyzing the whirl behaviors of the assembly and the influence of the bent angle
a very important key parameter
on the dynamic lateral and axial bit forces. Particular emphasis is placed on the effect of the bent angle of PB-BHA on bit lateral and axial forces to further elucidate the enhancement mechanisms of PBDVD. Results indicate that for the specified case study and commonly utilized PDM (with bent angles less than 1.5°)
the dynamic anti-deviation force on the bit tends to increase with the bent angle
but gradually plateaus when the bent angle exceeds a certain threshold. Concurrently
the mean dynamic axial force on the bit exhibits a linear increase relative to the bent angle; specifically
a larger bent angle results in a greater dynamic weight-on-bit (WOB) exerted on the bottom hole. Furthermore
the heterogeneity of the dynamic axial force progressively enhances with increasing bent angle
particularly when the bent angle exceeds a critical value (0.7°)
with a rapid surge observed within the 0.7°-0.9° range. Based on the research findings
the ROP enhancement mechanism of PBDVD can be expanded into two aspects: (1) The improvement of the anti-deviation force allows for the application of a higher WOB
thereby increasing the ROP; and (2) Enhanced mean dynamic WOB and intensified force heterogeneity also promote rock fragmentation at the bottom hole
WANG Wenchang,ZHANG He,LI Ning,et al.The dynamic deviation control mechanism of the prebent pendulum BHA in air drilling[J].Journal of Petroleum Science and Engineering,2019,176:521-531.
HU Yibao,DI Qinfeng,ZHU Weiping,et al.Dynamic characteristics analysis of drillstring in the ultra-deep well with spatial curved beam finite element[J].Journal of Petroleum Science and Engineering,2012,82-83:166-173.
DYKSTRA M W.Nonlinear drill string dynamics[D].Tulsa:The University of Tulsa,1996.
WANG Chunsheng,MIN Chuanzhong,ZHANG Hao,et al.Analysis of secondary makeup characteristics of drill collar joint and prediction of downhole equivalent impact torque of Well SDTK1[J].Petroleum Exploration and Development,2024,51(3):697-705.
CHRISTOFOROU A P,YIGIT A S.Dynamic modelling of rotating drillstrings with borehole interactions[J].Journal of Sound and Vibration,1997,206(2):243-260.
HOHL A,KUECK A,KULKE V,et al.The nature of the interaction between bit-whirl and high-frequency torsional oscillations[R].IPTC 23989,2024:1-15.