the modal characteristics of a molten salt storage tank in a commercial 50 MW tower-type concentrated solar power (CSP) plant were simulated. The influence of anchoring methods on the sloshing characteristics of molten salt storage tanks under full liquid level conditions was investigated
and the effects of parameters such as different liquid levels and operating temperatures on the modal frequencies of unanchored molten salt storage tanks were explored. Results show that the first three orders of unanchored molten salt storage tanks under full liquid level are prone to rigid-body displacement modes
and the sloshing frequency values of the 3rd to 20th orders differ significantly from those of anchored tanks. Therefore
the unanchored configuration is more suitable for modal analysis of molten salt storage tanks. The sloshing frequency of the tank increases with the rise of liquid level under different liquid level conditions
and the sloshing frequency of each order is lower than the natural frequency of the empty tank. The natural vibration period of the empty tank ranges from 0.06-0.1 s
while the sloshing period is as long as 2-15 s
indicating that the sloshing frequency of the tank in the salt-filled state is highly susceptible to resonance under the excitation of long-period seismic waves. Operating temperature has little effect on the sloshing frequency of molten salt
but preheating temperature has a significant impact on the natural frequency of the empty tank. When the operating temperature increases by 100 K
the highest-order natural frequency of the empty tank only decreases by 2.5%. To avoid instability of large-capacity molten salt tanks under the action of high-frequency seismic waves in the preheated state
the influence of preheating temperature on the frequency of empty tanks should be taken into account in the seismic design of molten salt tank structures in practical engineering.
关键词
Keywords
references
周凡宇, 曾晋珏, 王学斌. 碳中和目标下电化学储能技术进展及展望[J]. 动力工程学报, 2024, 44(3):396-405.ZHOU Fanyu, ZENG Jinyu, WANG Xuebin. Progress and prospect of electrochemical energy storage for carbon neutralization[J]. Journal of Chinese Society of Power Engineering, 2024, 44(3):396-405.
徐二树, 黄钰琛, 孔艳强, 等. 塔式太阳能光热发电系统蒸发器动态特性研究[J]. 动力工程学报, 2023, 43(6):710-716.XU Ershu, HUANG Yuchen, KONG Yanqiang, et al. Study on dynamic characteristics of steam generator in solar tower power generation system[J]. Journal of Chinese Society of Power Engineering, 2023, 43(6):710-716.
杜保存, 黄丽娟, 雷勇刚, 等. 填充床熔盐蓄热器的动态温度与应力特性[J]. 储能科学与技术, 2022, 11(7):2141-2150.DU Baocun, HUANG Lijuan, LEI Yonggang, et al. Dynamic study on the thermal and stress performances of the molten salt packed-bed thermal storage tank[J]. Energy Storage Science and Technology, 2022, 11(7):2141-2150.
赵鹤锦. 大型储液罐在地震作用下的响应分析[D]. 大连:大连理工大学, 2021.
TURSUNKULULY T, ZHANGABAYN, SULEIMENOV U, et al. Analysis of strength and eigenfrequencies of a steel vertical cylindrical tank without liquid, reinforced by a plain composite thread[J]. Case Studies in Construction Materials, 2023, 18:e02019.
樊海龙. 大型立式储油罐地震响应及隔震研究[D]. 天津:河北工业大学, 2020.
张美玲. 大型非锚固储油罐抗震性能研究[D]. 成都:西南交通大学, 2018.
吴济航. 基础不均匀沉降下储液罐地震动力响应分析[D]. 杭州:浙江大学, 2021.
崔双双, 何青, 李京浩, 等. 太阳能热发电系统熔盐储罐模态特性分析[J]. 太阳能学报, 2021, 42(10):124-128.CUI Shuangshuang, HE Qing, LI Jinghao, et al. Modal analysis of molten salt storage tank in solar thermal power system[J]. Acta Energiae Solaris Sinica, 2021, 42(10):124-128.
尹家聪. 模态分析的自动多重子结构法与动力重分析研究[D]. 北京:北京大学, 2012.
PETROVI AC'G K, DOBRI AC'G D, GOTI AC'G I, et al. Comparison of empty and oil-filled transformer tank mode shapes using experimental and FEM modal analysis[J]. Energies, 2024, 17(3):589.
潘传禹. 双金属LNG储罐的地震响应分析[D]. 北京:中国石油大学, 2022.
DU Baocun, GUO Yifan, XU Chao, et al. Dynamic creep and stress performances of the packed-bed thermal energy storage tank with molten salt EPCM particles[J]. Applied Thermal Engineering, 2023, 225:120247.
LUBBERS J, GRAAFF R. A simple and accurate formula for the sound velocity in water[J]. Ultrasound in Medicine & Biology, 1998, 24(7):1065-1068.
ASME Boiler and Pressure Vessel Committee on Materials. ASME boiler and pressure vessel code, section II-materials part D properties (metric)[S]. New York:American Society of Mechanical Engineers, 2013.