To enhance the operational flexibility of coal-fired power plants
a molten salt thermal energy storage system that utilizes electric heaters for heat storage and an additional steam turbine for heat release
including heat release schemes A (additional steam turbine exhaust entering the condenser) and B (additional steam turbine exhaust entering the deaerator)
were designed. The thermodynamic performance of the integrated system was analyzed based on a 660 MW supercritical coal-fired power plant (CFPP) case study. Results show that in scheme B
the maximum net output power increment of the CFPP is 9.67% of the rated load
while in scheme A
the net output power increment of the CFPP is 11.04% of the rated load. Under the condition of maximum boiler feedwater split mass flow rate
the total energy efficiency of schemes A and B decreases from 43.61% to 43.05% and 42.81%
respectively
while their total energy efficiencies could increase from 42.83% to 44.90% and 44.47%
respectively. When boiler feedwater split mass flow rate is less than 60 kg/s
the equivalent round-trip efficiency of scheme B is higher than that of scheme A
with a maximum value of 48.47%.
关键词
Keywords
references
孙月巧, 郑宏飞, 孔慧. 碳中和背景下煤电转型关键技术研究与展望[J]. 动力工程学报, 2022, 42(11): 1013-1023. SUN Yueqiao, ZHENG Hongfei, KONG Hui. Key technologies and prospects of coal power transformation under carbon neutrality background[J]. Journal of Chinese Society of Power Engineering, 2022, 42(11): 1013-1023.
张智刚, 康重庆. 碳中和目标下构建新型电力系统的挑战与展望[J]. 中国电机工程学报, 2022, 42(8): 2806-2818. ZHANG Zhigang, KANG Chongqing. Challenges and prospects for constructing the new-type power system towards a carbon neutrality future[J]. Proceedings of the CSEE, 2022, 42(8): 2806-2818.
包哲, 李薇, 张潇方, 等. 计及"源荷"双侧多重不确定性的虚拟电厂运行优化研究[J]. 动力工程学报, 2023, 43(12): 1665-1674. BAO Zhe, LI Wei, ZHANG Xiaofang, et al. Study on operational optimization of virtual power plant considering "source and load" uncertainties[J]. Journal of Chinese Society of Power Engineering, 2023, 43(12): 1665-1674.
SUN Yang, WANG Ligang, XU Cheng, et al. Enhancing the operational flexibility of thermal power plants by coupling high-temperature power-to-gas[J]. Applied Energy, 2020, 263: 114608.
YIN Junjie, LIU Ming, ZHAO Yongliang, et al. Dynamic performance and control strategy modification for coal-fired power unit under coal quality variation[J]. Energy, 2021, 223: 120077.
SUN Yang, XU Cheng, XIN Tuantuan, et al. A comprehensive analysis of a thermal energy storage concept based on low-rank coal pre-drying for reducing the minimum load of coal-fired power plants[J]. Applied Thermal Engineering, 2019, 156: 77-90.
周熙宏, 毕凌峰, 杨浩昱, 等. 燃煤机组锅炉深度调峰性能计算分析[J]. 动力工程学报, 2021, 41(10): 809-817. ZHOU Xihong, BI Lingfeng, YANG Haoyu, et al. Calculation and analysis of depth peak regulation performance of a coal-fired power plant[J]. Journal of Chinese Society of Power Engineering, 2021, 41(10): 809-817.
吕为智, 赵旭, 何翔, 等. 燃煤机组灵活性改造后燃烧优化试验研究[J]. 动力工程学报, 2023, 43(11): 1406-1412. L Weizhi, ZHAO Xu, HE Xiang, et al. Experimental study on combustion optimization of coal-fired unit after flexible modification[J]. Journal of Chinese Society of Power Engineering, 2023, 43(11): 1406-1412.
WANG Baigong, MA Huan, REN Shaojun, et al. Effects of integration mode of the molten salt heat storage system and its hot storage temperature on the flexibility of a subcritical coal-fired power plant[J]. Journal of Energy Storage, 2023, 58: 106410.
庞力平, 张世刚, 段立强. 高温熔盐储能提高二次再热机组灵活性研究[J]. 中国电机工程学报, 2021, 41(8): 2682-2690. PANG Liping, ZHANG Shigang, DUAN Liqiang. Flexibility improvement study on the double reheat power generation unit with a high temperature molten salt thermal energy storage[J]. Proceedings of the CSEE, 2021, 41(8): 2682-2690.
王辉, 李峻, 祝培旺, 等. 应用于火电机组深度调峰的百兆瓦级熔盐储能技术[J]. 储能科学与技术, 2021, 10(5): 1760-1767. WANG Hui, LI Jun, ZHU Peiwang, et al. Hundred-megawatt molten salt heat storage system for deep peak shaving of thermal power plant[J]. Energy Storage Science and Technology, 2021, 10(5): 1760-1767.
WEI Haijiao, LU Yuanwei, YANG Yanchun, et al. Research on influence of steam extraction parameters and operation load on operational flexibility of coal-fired power plant[J]. Applied Thermal Engineering, 2021, 195: 117226.
WEI Haijiao, LU Yuanwei, YANG Yanchun, et al. Flexible operation mode of coal-fired power unit coupling with heat storage of extracted reheat steam[J]. Journal of Thermal Science, 2022, 31(2): 436-447.
付立, 樊雪, 侯宏娟, 等. 槽式太阳能辅助燃煤发电系统热性能研究[J]. 动力工程学报, 2016, 36(8): 645-650. FU Li, FAN Xue, HOU Hongjuan, et al. Thermal performance analysis of a coal-fired power system aided by parabolic trough solar collectors[J]. Journal of Chinese Society of Power Engineering, 2016, 36(8): 645-650.
ZHANG Kezhen, LIU Ming, ZHAO Yongliang, et al. Design and performance evaluation of a new thermal energy storage system integrated within a coal-fired power plant[J]. Journal of Energy Storage, 2022, 50: 104335.
MIAO Lin, LIU Ming, ZHANG Kezhen, et al. Energy, exergy, and economic analyses on coal-fired power plants integrated with the power-to-heat thermal energy storage system[J]. Energy, 2023, 284: 129236.
CAO Ruifeng, LU Yue, YU Daren, et al. A novel approach to improving load flexibility of coal-fired power plant by integrating high temperature thermal energy storage through additional thermodynamic cycle[J]. Applied Thermal Engineering, 2020, 173: 115225.
苗林, 刘明, 张可臻, 等. 集成电制热熔盐储热的燃煤发电系统热力性能研究[J]. 工程热物理学报, 2023, 44(11): 2999-3007. MIAO Lin, LIU Ming, ZHANG Kezhen, et al. Thermodynamic analysis on the coal-fired power plant integrated with power-to-heat molten salt thermal energy storage system[J]. Journal of Engineering Thermophysics, 2023, 44(11): 2999-3007.
DING Wenjin, BAUER T. Progress in research and development of molten chloride salt technology for next generation concentrated solar power plants[J]. Engineering, 2021, 7(3): 334-347.
徐二树, 黄钰琛, 孔艳强, 等. 塔式太阳能光热发电系统蒸发器动态特性研究[J]. 动力工程学报, 2023, 43(6): 710-716. XU Ershu, HUANG Yuchen, KONG Yanqiang, et al. Study on dynamic characteristics of steam generator in solar tower power generation system[J]. Journal of Chinese Society of Power Engineering, 2023, 43(6): 710-716.