a carbon capture system model of high-temperature Ca-based adsorbent was established
and simulation study was carried out for CO
2
capture process of flue gas in a 1 000 MW coal-fired unit. Aiming at the problems of high energy consumption and pollutants emission in energy supply of oxygen-enriched coal combustion in calciner
external electric heating energy supply was proposed to provide heat for calciner. The changes in key performance parameters after flue gas entering the carbon capture system
were investigated in detail. On this basis
the conservation of energy and mass
as well as the effects of different operating parameters on system performance were analyzed. Results show that after the carbon capture system is added in the 1 000 MW coal-fired generating unit
the thermal efficiency of electricity generation will decrease by 26.11%. When the temperature of the carbonization furnace is maintained at 645 ℃
CO
2
capture efficiency will be 92.13%. CaCO
3
will be decomposed more thoroughly when the calcination furnace temperature is set at 900 ℃. The increase of temperature in carbonation furnace will reduce energy consumption of calcination and improve thermal efficiency of power generation
while the increase of calcination temperature will increase energy consumption and reduce thermal efficiency of power generation. The increase in calcium-carbon molar ratio leads to the increase of solid circulation in the calcium-based carbon capture system
while average carbon conversion of calcium-based adsorbents shows negative correlation.
关键词
Keywords
references
ZHENG Haonan, MIAO Zheng, XU Jinliang. Partial load operation characteristics of supercritical CO2 coal-fired power generation system[J]. Energy, 2024, 291: 130415.
KIM M W, KIM G M, JEON C H. Low-carbon fuel reburning for CO2 and NOx reduction in pulverized coal firing system[J]. Journal of the Energy Institute, 2024, 114: 101638.
XU Ruichang, SUN Jian, ZHANG Xiaoyu, et al. Strengthening performance of Al-stabilized, CaO-based CO2 sorbent pellets by the combination of impregnated layer solution combustion and graphite-moulding[J]. Separation and Purification Technology, 2023, 315: 123757.
潘怡, 刘敦禹, 金晶. CaO/CaCO3储能系统材料设计研究进展[J]. 动力工程学报, 2024, 44(5): 770-781. PAN Yi, LIU Dunyu, JIN Jing. Research progress on material design of CaO/CaCO3 energy storage system[J]. Journal of Chinese Society of Power Engineering, 2024, 44(5): 770-781.
李扬, 张扬, 刘文强, 等. 基于锂循环吸附CO2的燃煤发电系统热力特性研究[J]. 工程热物理学报, 2020, 41(11): 2876-2884. LI Yang, ZHANG Yang, LIU Wenqiang, et al. Study on thermodynamic characteristics of coal-fired power generation system based on lithium looping cycle for CO2 adsorption[J]. Journal of Engineering Thermophysics, 2020, 41(11): 2876-2884.
李英杰, 孙荣岳, 刘红玲, 等. 硫酸化反应对天然CO2载体CaO高温循环碳捕集的影响[J]. 煤炭学报, 2011, 36(7): 1206-1211. LI Yingjie, SUN Rongyue, LIU Hongling, et al. Effect of sulfation on carbon capture using natural CO2 carrier CaO looping cycle at high temperature[J]. Journal of China Coal Society, 2011, 36(7): 1206-1211.
GRECO-COPPI M, SEUFERT P, HOFMANN C, et al. Efficient CO2 capture from lime plants: techno-economic assessment of integrated concepts using indirectly heated carbonate looping technology[J]. Carbon Capture Science & Technology, 2024, 11: 100187.
HOSPITAL-BENITO D, LEMUS J, MOYA C, et al. Aspen plus supported design of pre-combustion CO2 capture processes based on ionic liquids[J]. Separation and Purification Technology, 2022, 290: 120841.
LI Yang, WANG Nini, GUAN Hongjun, et al. Optimization study of CO2 capture unit for subcritical coal-fired power generation unit based on Ebsilon and Aspen plus[J]. Energy Conversion and Management, 2022, 269: 116111.
闫润. 关键参数对钙基吸收剂捕集烟气中CO2性能的影响[J]. 华北电力大学学报, 2013, 40(6): 97-100. YAN Run. Influence of key parameters on the CO2 capture performance from flue gas using Ca-based sorbent[J]. Journal of North China Electric Power University, 2013, 40(6): 97-100.
李英杰. 基于钙循环的燃煤电站捕集CO2系统模拟[J]. 煤炭学报, 2011, 36(1): 118-123. LI Yingjie. System simulation of CO2capture for coal-fired power plant based on calcium looping cycle[J]. Journal of China Coal Society, 2011, 36(1): 118-123.
张学镭, 高沛. 钙基吸收剂捕集火电机组烟气中CO2的热力性能分析[J]. 动力工程学报, 2014, 34(1): 63-69. ZHANG Xuelei, GAO Pei. Thermodynamic analysis of CO2capture from coal-fired flue gas using Ca-based sorbent[J]. Journal of Chinese Society of Power Engineering, 2014, 34(1): 63-69.
李志新. 烟气钙基碳捕集技术实验和模拟研究[D]. 杭州: 浙江大学, 2022.
ZHANG Xuelei, LIU Yingguang. Performance assessment of CO2capture with calcination carbonation reaction process driven by coal and concentrated solar power[J]. Applied Thermal Engineering, 2014, 70(1): 13-24.
WANG W, RAMKUMAR S, WONG D, et al. Simulations and process analysis of the carbonation-calcination reaction process with intermediate hydration[J]. Fuel, 2012, 92(1): 94-106.
ZHOU Linfei, DUAN Lunbo, ANTHONY E J. A calcium looping process for simultaneous CO2 capture and peak shaving in a coal-fired power plant[J]. Applied Energy, 2019, 235: 480-486.
ORTIZ C, VALVERDE J M, CHACARTEGUI R, et al. The oxy-cal process: a novel CO2 capture system by integrating partial oxy-combustion with the calcium-looping process[J]. Applied Energy, 2017, 196: 1-17.
WANG W, RAMKUMAR S, FAN L S. Energy penalty of CO2 capture for the carbonation-calcination reaction (CCR) process: parametric effects and comparisons with alternative processes[J]. Fuel, 2013, 104: 561-574.
乔义书, 肖建洪, 于滨, 等. 基于双流化床模型的高温钙基碳捕集流程敏感性分析[J]. 能源化工, 2021, 42(3): 10-16. QIAO Yishu, XIAO Jianhong, YU Bin, et al. Sensitivity analysis of high-temperature calcium looping CO2 capture process based on dual fluidized bed model[J]. Energy Chemical Industry, 2021, 42(3): 10-16.
王华, 刘炳成. 高温钙基碳捕集间接加热过程模拟及分析[J]. 能源化工, 2022, 43(1): 1-8. WANG Hua, LIU Bingcheng. Simulation and analysis of high-temperature calcium-based carbon capture indirect heating process[J]. Energy Chemical Industry, 2022, 43(1): 1-8.