Thermal performance analysis of supercritical carbon dioxide coal-fired power generation system

HAN Zhonghe; BAI Yaping; CHEN Dongxu; GUO Dongyang; LI Peng

doi:10.19666/j.rlfd.202212297

English Version Reader LoginJournal Login

您当前的位置：

首页 >

文章列表页 >

Thermal performance analysis of supercritical carbon dioxide coal-fired power generation system

更新时间：2025-09-28

- Thermal performance analysis of supercritical carbon dioxide coal-fired power generation system
- Thermal Power Generation Vol. 52, Issue 6, Pages: 81-92(2023)
- 作者机构：
  
  1. 华北电力大学河北省低碳高效发电技术重点实验室
  2. 华北电力大学能源动力与机械工程学院
- 作者简介：
- 基金信息：
- DOI：10.19666/j.rlfd.202212297
  CLC： TM621
- Published：2023
- 稿件说明：
移动端阅览
HAN Zhonghe, BAI Yaping, CHEN Dongxu, et al. Thermal performance analysis of supercritical carbon dioxide coal-fired power generation system[J]. Thermal power generation, 2023, 52(6): 81-92.
DOI：

HAN Zhonghe, BAI Yaping, CHEN Dongxu, et al. Thermal performance analysis of supercritical carbon dioxide coal-fired power generation system[J]. Thermal power generation, 2023, 52(6): 81-92. DOI： 10.19666/j.rlfd.202212297.

摘要

基于热力学第一、第二定律，针对超临界二氧化碳（S-CO_2）再压缩循环、再压缩再热循环、部分冷却循环、部分冷却再热循环燃煤发电系统，采用MATLAB软件分别进行参数计算与分析。随后分别讨论了分流系数，主压缩机出口、入口压力对系统循环效率、各设备及系统?效率的影响，并对4种循环系统进行了对比分析。结果表明：不同循环布局下或同一循环布局，不同运行参数下，循环效率随相同参数的变化规律不同；分流系数存在使循环效率、?效率达到最高的最优值，主压缩机出口、入口压力与分流系数对循环效率的影响存在耦合关系；对于不同参数变化，系统?效率主要受不同设备?效率的影响；再热可提高系统循环效率和?效率，有部分冷却的循环对参数变化敏感度相对较低。

Abstract

Based on the first and second laws of thermodynamics

parameters of the supercritical carbon dioxide(S-CO_2) recompression cycle

recompression reheat cycle

partial cooling cycle

partial cooling reheat cycle coalfired power generation system were calculated and analyzed by using MATLAB software. Then

the impact of shunt coefficient

outlet and inlet pressure of the main compressor on the system circulation efficiency

equipment and exergy efficiency of the system were discussed respectively

and the four types of circulation systems were compared and analyzed. The results show that the cycle efficiency varies with the same parameters under different cycle layout or the same cycle layout and different operating parameters. There is a shunt coefficient for exergy efficiency and exergy efficiency to reach an optimal value. There is a coupling relationship between the influence of outlet and inlet pressure of the main compressor and the shunt coefficient on the circulation efficiency. For different parameter changes

exergy efficiency of system is mainly affected by exergy efficiency of different equipment. Reheat can increase circulation efficiency and exergy efficiency of the system

while some cooling cycles are relatively less sensitive to parameter changes.

关键词

Keywords

references

Views

544

下载量

CSCD

Alert me when the article has been cited

提交

Tools

Publicity Resources

Simulation analysis on performance of supercritical carbon dioxide recompression intercooling split-flow solar power system

Simulation research on thermodynamic performance of supercritical carbon dioxide 600 MW coal-fired power system

AN APPROACH TO ADOPTING NEW TECHNOLOGY OF THERMODYNAMIC CYCLE FOR LOWPRESSURE CYLINDER FOR 300 MW STEAM TURBINE IN XUANWEI POWER PLANT

Performance analysis of organic Rankine cycle for power recovery from geothermal energy

Effect of improving reheat steam temperature on boiler thermal performance and economic analysis

Related Author

ZHANG Chunwei

YU Bin

WANG Weishu

HUANG Zhihao

ZHAO Shifei

CHEN Chang

YAO Zikun

ZHAN Yuxin

Related Institution

Harbin Electric Group Co., Ltd. Central Research Institute

Thermal Engineering Research Center of North China University of Water Resources and Electric Power

Xuanwei Power Generation Co., Ltd. Yunnan Xuanwei

Key Laboratory of Power Station Equipment Status Monitoring and Control, Ministry of Education, North China Electric Power University

Huadian Electric Power Research Institute

AI问答

⁰