Thermal performance of 650 ℃ ultra supercritical unit with BEST

WANG Wenhuan; XU Pengjiang; XUE Zhaonan; JU Wenping; ZHOU Bo; DAI Xiaoye; SHI Lin

doi:10.19666/j.rlfd.202212237

English Version Reader LoginJournal Login

您当前的位置：

首页 >

文章列表页 >

Thermal performance of 650 ℃ ultra supercritical unit with BEST

更新时间：2025-09-28

- Thermal performance of 650 ℃ ultra supercritical unit with BEST
- Thermal Power Generation Vol. 52, Issue 8, Pages: 129-136(2023)
- 作者机构：
  
  1. 清华大学能源与动力工程系
  2. 西安热工研究院有限公司
  3. 华能(浙江)能源开发有限公司玉环分公司
- 作者简介：
- 基金信息：
- DOI：10.19666/j.rlfd.202212237
  CLC： TM621
- Published：2023
- 稿件说明：
移动端阅览
WANG Wenhuan, XU Pengjiang, XUE Zhaonan, et al. Thermal performance of 650 ℃ ultra supercritical unit with BEST[J]. Thermal power generation, 2023, 52(8): 129-136.
DOI：

WANG Wenhuan, XU Pengjiang, XUE Zhaonan, et al. Thermal performance of 650 ℃ ultra supercritical unit with BEST[J]. Thermal power generation, 2023, 52(8): 129-136. DOI： 10.19666/j.rlfd.202212237.

摘要

针对超超临界燃煤机组背压抽汽汽轮机（backpressure extraction steam turbine

BEST）方案的研究现状，建立了含BEST的超超临界燃煤机组的变工况计算模型和?分析模型，深入探究了主蒸汽流量、温度、压力，汽轮机背压以及BEST回热抽汽级数对机组热力性能的影响规律。结果表明：机组的?效率随主蒸汽流量先升高后降低，在主蒸汽流量为750 kg/s时达到最大值（52.42%）；机组?效率随主蒸汽温度和压力的增大而提高，随汽轮机背压的增大而降低，在低负荷时机组热力性能受背压的影响更大；此外，BEST回热抽汽级数对机组热力性能的影响十分显著，级数为4级时与系统设计方案匹配度最好，热力性能最优。所述计算方法和BEST回热抽汽级数选择方案，可为超超临界机组方案设计与运行优化提供参考。

Abstract

In view of the research situation of backpressure extraction steam turbine technology for ultrasupercritical power generation units

the off-design condition calculation model and exergy analysis model of the unit was established

and the influences of steam mass flow

temperature

pressure

steam turbine back pressure and the BEST heat extraction stage on the thermal performance of the unit were analyzed. The exergy efficiency of unit increased first and then decreased with main steam flow rate

reaching the maximum value(52.42%) when main steam flow rate was 750 kg/s. Exergy efficiency of unit increased with the increase of main steam temperature and pressure but decreased with the increase of turbine back pressure. The thermal performance of unit was more affected by back pressure at low load. In addition

the BEST series has a significant effect on the thermal performance of the unit

and the BEST match degree with the system design scheme is achieved when the series is 4

and the thermal performance is optimal. The calculation method and BEST series selection scheme can provide reference for the scheme design and operation optimization of ultra-supercritical units.

关键词

Keywords

references

Views

103

下载量

CSCD

Alert me when the article has been cited

提交

Tools

Publicity Resources

Study on off-design characteristics of heating units based on exergy analysis method

Off-design performance optimization of the combined cycle system based on variable back pressure modification

Effect of coupling mode of solar collector on performance of solar-gas combined cycle

Heating temperature characteristics and exergy analysis for high back pressure heating unit

Analysis on typical daily hourly thermodynamic characteristics of integrated solar combined cycle system

Related Author

LI Qiubai

LI Zhiwei

YANG Yongping

ZHANG Guoqiang

ZHANG Heng

LI Yongyi

LIU Hengping

SONG Xiaowei

Related Institution

Guoneng (Quanzhou) Thermal Power Co., Ltd

Guoneng Nanjing Electric Power Test Research Co., Ltd

College of Energy, Power and Mechanical Engineering, North China Electric Power University

Key Laboratory of Power Station Equipment Status Monitoring and Control, Ministry of Education, North China Electric Power University

School of Energy and Power Engineering, Xi'an Jiaotong University

AI问答

⁰