Experimental and numerical investigation on drying characteristics of wet biomass particles

GU Conghui; FAN Jiabin; YUAN Zhulin

doi:10.19666/j.rlfd.202010245

English Version Reader LoginJournal Login

您当前的位置：

首页 >

文章列表页 >

Experimental and numerical investigation on drying characteristics of wet biomass particles

更新时间：2025-09-28

- Experimental and numerical investigation on drying characteristics of wet biomass particles
- Thermal Power Generation Vol. 50, Issue 2, Pages: 49-54(2021)
- 作者机构：
  
  1. 江苏科技大学能源与动力学院
  2. 东南大学能源与环境学院
- 作者简介：
- 基金信息：
- DOI：10.19666/j.rlfd.202010245
  CLC： TK6
- Published：2021
- 稿件说明：
移动端阅览
GU Conghui, FAN Jiabin, YUAN Zhulin. Experimental and numerical investigation on drying characteristics of wet biomass particles[J]. Thermal power generation, 2021, 50(2): 49-54.
DOI：

GU Conghui, FAN Jiabin, YUAN Zhulin. Experimental and numerical investigation on drying characteristics of wet biomass particles[J]. Thermal power generation, 2021, 50(2): 49-54. DOI： 10.19666/j.rlfd.202010245.

摘要

生物质作为一种新型的绿色清洁可再生燃料

常常因为水分含量过高而大大降低利用效率。本文采用实验与数值模拟相结合的方法

对细丝状生物质颗粒在旋转滚筒内干燥预处理过程展开研究

分析了滚筒倾角、气流温度和气流速度对生物质能量传递和水分迁移过程的影响规律。结果表明:气流速度对颗粒与气流之间的对流换热量影响较大

流速增加强化了颗粒与气流之间的对流换热和水分蒸发过程

降低颗粒与滚筒热内壁面之间导热换热量的比重;滚筒倾角在3.5°～4.5°的范围内

颗粒出口温度和含水率均随滚筒倾角的增加而增加;提高气流入口温度

能够增加促进颗粒与气流之间的对流换热和颗粒表面水分汽化速度

使得颗粒在出口处的温度升高

含水率降低。

Abstract

Biomass resources are widely used as a form of sustainable and renewable energy due to pollution-free and no emission. However

the utilization efficiency of biomass fuels often sharply decreases because of high moisture content. Therefore

the drying characteristics of fibrous biomass particles in a rotating dryer are studied in this paper. Both tests and numerical simulations were employed to investigate the influence of the slopes of drum

temperatures and velocities of gas flow on heat and mass transfer processes of the biomass. The results show that

the heat and mass transfer characteristics were significantly affected by the gas flow velocity. Convective heat and mass transfer between biomass particles and gas flow could be enhanced by increasing the velocity of gas flow. Meanwhile

the proportion of heat conduction between particles and hot inner wall reduced with the increase of gas velocity. The temperature and moisture content of fibrous biomass particles increased with the drum slope at the range of 3.5°～4.5°. Increasing the temperature of gas flow can strengthen the convection heat transfer and increase the evaporation rate of particles surface moisture. As a consequence

the temperature of particles at the outlet increased and the moisture content reduced.

关键词

Keywords

references

Views

下载量

CSCD

Alert me when the article has been cited

提交

Tools

Publicity Resources

Development status and prospect of fluidized bed combustion technology for biomass fuels

Experimental study on co-firing characteristics of coal/biomass blends in O₂/CO₂ atmosphere

STUDY ON PROPERTIES OF TAR PRODUCED FROM BIOMASS PYROLYSIS TEST

CO-COMBUSTION TECHNOLOGY OF BIOMASS WITH COAL

APPLICATION AND PROSPECTS OF POWER GENERATION THCHNOLOGY WITH BIOMASS GASIFICATION IN CHINA

Related Author

ZHAO Pengbo

LIU Jiamiao

WANG Chang'an

CHANG Liujun

LIU Aiping

SHI Zhenghai

LIU Shi'en

CHE Defu

Related Institution

National Key Laboratory of Green Hydrogen Electricity, Xi'an Jiaotong University

Xi'an Xire Boiler Environmental Protection Engineering Co., Ltd

State Power Investment Corporation Jiangxi Electric Power Co., Ltd. Fenyi Power Plant

Central European School of Clean and Renewable Energy, Huazhong University of Science and Technology

State Key Laboratory of Coal Combustion, Huazhong University of Science and Technology

AI问答

⁰