Numerical simulation of deep dedusting of three-phase flow in desulfurization absorption tower

GE Chunliang; JIANG Nan; LIU Wenju; LI Xiongfeng; LI Chenlang

doi:10.19666/j.rlfd.202006200

English Version Reader LoginJournal Login

您当前的位置：

首页 >

文章列表页 >

Numerical simulation of deep dedusting of three-phase flow in desulfurization absorption tower

更新时间：2025-09-28

- Numerical simulation of deep dedusting of three-phase flow in desulfurization absorption tower
- Thermal Power Generation Vol. 50, Issue 4, Pages: 103-108(2021)
- 作者机构：
  
  1. 浙江天地环保科技股份有限公司
  2. 中国机械设备工程股份有限公司
- 作者简介：
- 基金信息：
- DOI：10.19666/j.rlfd.202006200
  CLC： X773
- Published：2021
- 稿件说明：
移动端阅览
GE Chunliang, JIANG Nan, LIU Wenju, et al. Numerical simulation of deep dedusting of three-phase flow in desulfurization absorption tower[J]. Thermal power generation, 2021, 50(4): 103-108.
DOI：

GE Chunliang, JIANG Nan, LIU Wenju, et al. Numerical simulation of deep dedusting of three-phase flow in desulfurization absorption tower[J]. Thermal power generation, 2021, 50(4): 103-108. DOI： 10.19666/j.rlfd.202006200.

摘要

脱硫吸收塔内部流场较为复杂

涉及到气液固三相介质流动。采用欧拉(Eluer)多相流模型和DPM(discrete phase model)模型

建立惯性撞击、拦截和热泳捕集作用机制的液滴捕集颗粒物模型;利用CFD数值模拟分析了液滴粒径等6种运行参数对脱硫吸收塔除尘效率的影响规律。结果表明:亚微米级颗粒物的除尘效率较低

全塔对其除尘效率只有10%左右

而微米级颗粒在全塔内的除尘效率在99.98%以上;通过减少液滴粒径

增加烟气流速

适当增加液气比

均能有效提升微米级颗粒的脱除效率

尤其是1.30～2.05μm之间的颗粒物;而通过调节喷淋参数

对颗粒物除尘效率的提升作用并不大。

Abstract

Because of three-phase flow

the internal flow field of desulfurization absorption tower is complex. By adopting the multi-phase Euler model and discrete phase model(DPM)

this paper establishes a model of droplet trapping particles based on the mechanism of inertial impact

interception and thermophoresis. Through numerical simulation using CFD

the influences of six operation parameters including droplet size on the dust removal efficiency of desulfurization absorption tower were analyzed. The results show that

the dedusting efficiency of submicron particles is low and the dedusting efficiency of the whole tower is only about 10%. However

the dedusting efficiency of micron particles in the whole tower is higher than 99.98%. The removal efficiency of micron particles

especially the particles with size of 1.30～2.05 μm

can be effectively enhanced by reducing the droplet size

increasing the flue gas flow rate and properly increasing the liquid gas ratio. Adjusting the spray parameters has little improving effect on the dust removal efficiency of particulate matters.

关键词

Keywords

references

Views

266

下载量

CSCD

Alert me when the article has been cited

提交

Tools

Publicity Resources

Heat-mass transfer and chemical reaction characteristics during carbon dioxide absorption by amine solution in spray scrubber

NUMERICAL ANALYSIS OF AERODYNAMIC FIELD IN WET TYPE NATURAL-DRAFT COOLING TOWER

APPLICATION OF NUMERICAL SIMULATION IN OPTIMIZED DESIGN OF DEMISTOR FOR WET DESULFURATION

NUMERICAL ANALYSIS OF TURBULENT FLOW HEAT TRANSFER ON THE SHELL-SIDE OF SPIRALLY TWISTED FLAT-TUBE HEAT EXCHANGER

Related Author

ZHU Hongqing

GUO Feng

QU Jiangyuan

WANG Kai

SUN Feng-zhong

WANG Wei

LI Wen-yan

XU Yan

Related Institution

National Nuclear Power Planning and Design Institute Co., Ltd

Shandong University

North China Electric Power University

Nanjing University of Technology

China Institute of Metrology

AI问答

⁰