Automatic control optimization of deep peak load regulation during trial operation of ultra supercritical units

GAO Kui; ZHAO Hui; HU Gang; GUO Sanhu; WANG Haitao; CHEN Zhigang; TAN Xiangshuai

doi:10.19666/j.rlfd.202005124

English Version Reader LoginJournal Login

您当前的位置：

首页 >

文章列表页 >

Automatic control optimization of deep peak load regulation during trial operation of ultra supercritical units

更新时间：2025-09-28

- Automatic control optimization of deep peak load regulation during trial operation of ultra supercritical units
- Thermal Power Generation Vol. 50, Issue 3, Pages: 158-164(2021)
- 作者机构：
  
  1. 西安热工研究院有限公司
  2. 华能山东发电有限公司
- 作者简介：
- 基金信息：
- DOI：10.19666/j.rlfd.202005124
  CLC： TK323
- Published Online：22 February 2021，
  
  Published：2021
- 稿件说明：
移动端阅览
GAO Kui, ZHAO Hui, HU Gang, et al. Automatic control optimization of deep peak load regulation during trial operation of ultra supercritical units[J]. Thermal power generation, 2021, 50(3): 158-164.
DOI：

GAO Kui, ZHAO Hui, HU Gang, et al. Automatic control optimization of deep peak load regulation during trial operation of ultra supercritical units[J]. Thermal power generation, 2021, 50(3): 158-164. DOI： 10.19666/j.rlfd.202005124.

摘要

为减少机组投产后AGC考核并提高深度调峰自动控制水平

在超超临界机组试运过程中

采用设定值函数优化、汽轮机辅助压力调节、水煤复合控制、动态变负荷前馈、分磨煤机热值校正、闭锁及限制条件完善、阀门特性及汽泵再循环控制优化等一系列优化调整方法

实现了在最低稳燃负荷～50%额定负荷区间的协调控制连续稳定投入

控制指标良好。同时对深度调峰阶段控制特点、难点和注意事项进行了分析

指出超超临界机组低负荷段的控制要点

对超超临界机组深度调峰改造并提高机组安全稳定运行性能具有一定借鉴意义。

Abstract

In order to reduce the AGC assessment and improve the automatic control level of deep peak load regulation units

during the test run process of ultra supercritical units

a series of optimization adjustment methods are adopted

such as optimization of set-point function

auxiliary pressure regulation of steam turbine

composite control of water and coal

feed-forward of dynamic variable load

correction of heat value of grinding

perfection of locking and limiting conditions

optimization of valve characteristics and steam pump recycling control

which realizes the continuous and stable input of coordinated control in the range of minimum stable combustion load ～ 50% rated load

and the control index is good. At the same time

the control characteristics

difficulties and precautions in the deep regulation stage are analyzed

and the control points in low load section of the ultra supercritical unit are pointed out

which has reference value for deep peak regulation transformation of the ultra supercritical units and the improvement of safe and stable operation performance.

关键词

Keywords

references

Views

429

下载量

CSCD

Alert me when the article has been cited

提交

Tools

Publicity Resources

FREQUENCY CONVERSION RETROFIT OF CONDENSATE PUMP FOR 330 MW UNIT AND SYSTEM OPEATION OPTIMIZATION THEREOF

ADAPTABILITY OF 3 000 t/h ULTRA SUPERCRITICAL BOILER FOR MIX BURNING WITH LOW HEAT VALUE COAL

CONTROL STRATEGY OF PRIMARY FREQUENCY REGULATION AND ITS OPTIMIZATION FOR 2×600 MW ULTRA SUPERCRITICAL UNITS IN HEYUAN POWER PLANT

MODELING OF SPRAY DESUPERHEATER IN AN ULTRA SUPERCRITICAL ONCE-THROUGH BOILER

Exhaust coefficient method based analysis on influence of different spray desuperheating modes on unit thermal economy

Related Author

SHENG Xibing

LI Zhenqiang

DU Huazhong

WAGN Jingkuan

ZHANG Jing'e Guodian Heze Power Plant

LU Huaidian

ZENG Biqun

CHEN Weiwu

Related Institution

Guodian Heze Power Plant

Huaneng Haimen Power Plant

Shenneng Hehe Electric Power (Heyuan) Co., Ltd

Northwest Electric Power Design Institute

School of Power and Mechanical Engineering, Wuhan University

AI问答

⁰