Experimental study on spray characteristics of air-assistant desulfurization nozzle

WANG Shaohui; SHI Zhenjing; BAI Shaolin; LEI Ming; NIU Yongjun

doi:10.19666/j.rlfd.202001014

English Version Reader LoginJournal Login

您当前的位置：

首页 >

文章列表页 >

Experimental study on spray characteristics of air-assistant desulfurization nozzle

更新时间：2025-09-28

- Experimental study on spray characteristics of air-assistant desulfurization nozzle
- Thermal Power Generation Vol. 49, Issue 9, Pages: 169-174(2020)
- 作者机构：
  
  西安热工研究院有限公司
- 作者简介：
- 基金信息：
- DOI：10.19666/j.rlfd.202001014
  CLC： X701.3
- Published Online：15 August 2020，
  
  Published：2020
- 稿件说明：
移动端阅览
WANG Shaohui, SHI Zhenjing, BAI Shaolin, et al. Experimental study on spray characteristics of air-assistant desulfurization nozzle[J]. Thermal power generation, 2020, 49(9): 169-174.
DOI：

WANG Shaohui, SHI Zhenjing, BAI Shaolin, et al. Experimental study on spray characteristics of air-assistant desulfurization nozzle[J]. Thermal power generation, 2020, 49(9): 169-174. DOI： 10.19666/j.rlfd.202001014.

摘要

为降低脱硫喷嘴雾化粒径

探索空气助力对脱硫喷嘴雾化性能的影响

本文在喷雾试验平台上试验分析了自行设计的空气助力式脱硫喷嘴的雾化性能

得出不同工况下喷嘴压力、液滴粒径、喷雾角等性能参数的变化规律。结果表明:不通入气相工质时

空气助力配气结构对常规脱硫喷嘴喷雾特性影响不大;在通入一定量气相工质后

喷嘴雾化水平明显提高;当气液质量比达到0.002

液滴索太尔平均粒径SMD可降至1 400μm以下;随着气液质量比的提高

雾化粒径逐渐缩小;气相工质的介入会使喷雾角大幅增加约20°。

Abstract

In order to reduce the atomization particle size of the desulfurization nozzle and explore the effect of air assist on the atomization performance of the desulfurization nozzle

the atomization performance of the selfdesigned air-assisted desulfurization nozzle was tested and analyzed on the spray test platform. The variation of performance parameters such as nozzle pressure

droplet size and spray angle under different operating conditions were obtained. The results show that

when the gas-phase working fluid is not introduced

the air-assisted gas distribution structure has little effect on the spray characteristics of conventional desulfurization nozzles. After a certain amount of gas phase working fluid is introduced

the atomization level of the nozzle is significantly improved. When the gas-liquid mass ratio reaches 0.002

the Sauter mean diameter of droplet may fall below 1 400 μm. With the increase of the gas-liquid mass ratio

the particle size of the atomizing gradually decreases. The intervention of the gas phase working fluid will greatly increase the spray angle by about 20°.

关键词

Keywords

references

Views

下载量

CSCD

Alert me when the article has been cited

提交

Tools

Publicity Resources

TEST STUDY ON RELATIONSHIP BETWEEN DESULFURIZATION EFFICIENCY OF WET LIMESTONE METHOD AND pH VALUE OF ABSORBENT SLURRY

THE MOVING LOCUS OF UREA SOLUTION ATOMIZING PARTICLES IN FURNACE OF BOILER

INFLUENCE OF INCIDENCE ANGLE CHANGE IN GASIFICATION NOZZLE UPON FLOW FIELD AND CONCENTRATION FIELD IN THE FURNACE

WELDING OF DISSIMILAR STEELS IN MANUFACTURING LOW β VALUE FEED-WATER FLOW NOZZLES

Three-dimensional numerical study on corrugated plates separator with double hook

Related Author

FAN Yu-ming21.College of Ekistical Environment and Architectual Engineering

DUAN Jian-zhong1

CEN Ke-faState-level Key Laboratory of Clean Energy Utilization

WANG Zhi-hua

HE Pei

ZHOU Jun-hu

YANG Wei-juan

CHEN Zhen-chao

Related Institution

Beijing Kangrui Jiansheng Environmental Protection Engineering Technology Co., Ltd

School of Human Settlements and Architecture Engineering, Xi'an Jiaotong University

Zhejiang University

State Key Laboratory of Clean Energy Utilization, Zhejiang University

Zehjiang Universlty

AI问答

⁰