Example analysis for output decline of nuclear power unit caused by drainage problem

CHU Yingjie; WEI Longwei; LUO Wei; WANG Wanzhang; WU Jiangtao

doi:10.19666/j.rlfd.201910219

English Version Reader LoginJournal Login

您当前的位置：

首页 >

文章列表页 >

Example analysis for output decline of nuclear power unit caused by drainage problem

更新时间：2025-09-28

- Example analysis for output decline of nuclear power unit caused by drainage problem
- Thermal Power Generation Vol. 49, Issue 4, Pages: 77-81(2020)
- 作者机构：
  
  1. 西安交通大学热流科学与工程教育部重点实验室
  2. 福建宁德核电有限公司
- 作者简介：
- 基金信息：
- DOI：10.19666/j.rlfd.201910219
  CLC： TK267
- Published Online：27 March 2020，
  
  Published：2020
- 稿件说明：
移动端阅览
CHU Yingjie, WEI Longwei, LUO Wei, et al. Example analysis for output decline of nuclear power unit caused by drainage problem[J]. Thermal power generation, 2020, 49(4): 77-81.
DOI：

CHU Yingjie, WEI Longwei, LUO Wei, et al. Example analysis for output decline of nuclear power unit caused by drainage problem[J]. Thermal power generation, 2020, 49(4): 77-81. DOI： 10.19666/j.rlfd.201910219.

摘要

针对某核电站疏水问题引起的机组出力下降

建立了故障排查模型和泄漏量的理论计算模型

研究制定了主蒸汽管线泄漏量测量试验。通过机组启停前后同等运行工况下主蒸汽疏水隔离和投用的热功率、给水流量差值

计算疏水系统的泄漏量。同时利用各种测量手段对疏水故障进行定位

确定了热静力型疏水器的失效模型

表明液位计管线布置和疏水器安装不满足要求导致了主蒸汽疏水系统高液位报警的频发。使用新型自由浮球式疏水器

同时取消了SN液位计下游U型布置、上游倒U型布置。应用效果表明

本文故障分析方法可靠

节能效果良好

可为同类核电厂提供参考。

Abstract

A model for troubleshooting and a theoretical calculation model of leakage were established to analyze the output decline caused by drainage problem in a nuclear power plant. The leakage rate was calculated by comparing thermal power and feed water flow before and after the unit startup and shutdown under the same operating conditions. In this study

the measurement of a main steam pipeline leakage was conducted

locating the drainage problem by different ways. In addition

the failure model of the thermostatic trap was determined and showed that the pipeline layout of liquid level gauge and the incorrect installation of steam trap leaded to frequent high level alarm of steam trap. At the same time of correcting the pipeline layout

a new free floating trap was used to replace the previous trap. The application result shows the reliability of the fault analysis and better energy saving effect. The analysis

treatment and suggestions of this abnormal output can provide reference for similar nuclear power plants.

关键词

Keywords

references

Views

下载量

CSCD

Alert me when the article has been cited

提交

Tools

Publicity Resources

Pressure control simulation for once-through steam generators

Safety analysis of HTGR main steam pipe under steam hammer conditions

Hydraulic characteristics of exhaust pipe of direct air cooling system in 1 000 MW level nuclear power units

Study on heat supply scheme for AP1000 nuclear steam turbine

Effects of stress and hydrochemical parameters on intercrystalline corrosion of Incoloy800H alloy

Related Author

MA Xiaoqian

ZHANG Xiaoshen

QUAN Zhengting

WU Jie

XU Zhibin

FU Jiyang

LI Xiaowei

QIAN Qiuyu

Related Institution

Guangdong Key Laboratory of Energy Efficient and Clean Utilization, South China University of Technology

Tsinghua University Institute of Nuclear Energy and New Energy Technology

National Nuclear Power Planning and Design Institute

State Key Laboratory of Multiphase Flow for Power Engineering, Xi'an Jiaotong University

School of Mechanical Engineering, Xi'an Jiaotong University

AI问答

⁰