Experimental analysis on heat release performance of pulsating heat pipe phase change heat accumulator

LUO Xiaoxue; ZHANG Xuelai; ZOU Changzhen; HUA Weisan; HAN Xingchao

doi:10.19666/j.rlfd.201707080

English Version Reader LoginJournal Login

您当前的位置：

首页 >

文章列表页 >

Experimental analysis on heat release performance of pulsating heat pipe phase change heat accumulator

更新时间：2025-09-28

- Experimental analysis on heat release performance of pulsating heat pipe phase change heat accumulator
- Thermal Power Generation Vol. 47, Issue 4, Pages: 123-130(2018)
- 作者机构：
  
  1. 钦州学院
  2. 上海海事大学蓄冷技术研究所
- 作者简介：
- 基金信息：
- DOI：10.19666/j.rlfd.201707080
  CLC： TK02
- Published Online：09 April 2018，
  
  Published：2018
- 稿件说明：
移动端阅览
LUO Xiaoxue, ZHANG Xuelai, ZOU Changzhen, et al. Experimental analysis on heat release performance of pulsating heat pipe phase change heat accumulator[J]. Thermal power generation, 2018, 47(4): 123-130.
DOI：

LUO Xiaoxue, ZHANG Xuelai, ZOU Changzhen, et al. Experimental analysis on heat release performance of pulsating heat pipe phase change heat accumulator[J]. Thermal power generation, 2018, 47(4): 123-130. DOI： 10.19666/j.rlfd.201707080.

摘要

为解决能源利用浪费大、效率低、环境污染严重的问题

设计了一套脉动热管型相变蓄放热装置

搭建了实验台

考察了冷却水初始温度、冷却水流量和抽真空充液对脉动热管放热过程的影响

并计算了不同工况下脉动热管蓄热装置的热回收率。结果表明:冷却水初始温度越高

装置放热时间越长

水槽内冷却水最终温度也越高;冷却水流量越大

放热时间越短

但当冷却水流量增大至一定值时

总放热时间几乎不再变化;脉动热管是否抽真空充液对装置的放热性能影响不大;装置的热回收率随着冷却水初始温度的升高而降低

随着冷却水流量的增大仅有小幅增加。

Abstract

To solve the problems of energy waste

low efficiency and serious environmental pollution

a pulsating heat pipe type phase change storage device was designed and a test bench was set up.The effects of initial cooling water temperature

cooling water flow rate and evacuation filling on the exothermic process of pulsating heat pipe were investigated.The heat recovery rate of pulsating heat pipe heat storage device under different operating conditions was calculated.The results show that

the higher the initial temperature of the cooling water

the longer the heat dissipation time of the device is

and the higher the final temperature of the cooling water in the water tank is.The greater the cooling water flow

the shorter the heat release time

but when the cooling water flow increases to a certain value

the total heat release time almost has no change.Whether the pulsating heat pipe is vacuumed has little effect on the exothermic performance of the device.The heat recovery rate of the device decreases with the increase of the initial temperature of the cooling water and only slightly increases with the the cooling water flow rate.

关键词

Keywords

references

Views

197

下载量

CSCD

Alert me when the article has been cited

提交

Tools

Publicity Resources

Experimental research on heat charging and discharging performance of heat pipe phase change energy storage system

Experimental study on waste heat recovery performance of flue gas of ceramic membranes

STUDY ON PERFORMANCE OF A NEW TYPE HIGH-TEMPERATURE LATENT-HEAT THERMAL ENERGY STORAGING SYSTEM

PROGRESS IN RESEARCH OF O₂/CO₂ COMBUSTION TECHNOLOGY Ⅰ:COMBUSTION AND HEAT TRANSFER BEHAVIOR

EXPERIMENTAL INVESTIGATION ON HEAT AND MASS TRANSFER OF PLATE EVAPORATIVE CONDENSER

Related Author

XU Weiwen

DING Lei

ZHANG Xuelai

MAO Fa

CHEN Haiping

ZHANG Heng

CHENG Chao

WEI Xin-li11.Zhengzhou University

Related Institution

Shanghai Maritime University Merchant Marine College

National Thermal Power Engineering Technology Research Center, North China Electric Power University

Henan Tiantai Mining and Metallurgy Safety Engineering Consulting Co., Ltd

Zhengzhou University

State Key Laboratory of Multiphase Flow for Power Engineering, Xi'an Jiaotong University

AI问答

⁰