CAUSE ANALYSIS AND TEST STUDY ON SOMEHAT LOWER STEAM TEMPERATURE FOR A 2008t/h CORNER TANGENTIAL FIRING BOILER[J]. Thermal power generation, 2004, (11): 32-35.
DOI:
CAUSE ANALYSIS AND TEST STUDY ON SOMEHAT LOWER STEAM TEMPERATURE FOR A 2008t/h CORNER TANGENTIAL FIRING BOILER[J]. Thermal power generation, 2004, (11): 32-35. DOI: 10.19666/j.rlfd.2004.11.010.
CAUSE ANALYSIS AND TEST STUDY ON SOMEHAT LOWER STEAM TEMPERATURE FOR A 2008t/h CORNER TANGENTIAL FIRING BOILER
摘要
针对某电厂 2 0 0 8t/h锅炉存在汽温偏低问题
对锅炉进行了热力计算和燃烧调整试验
进而进行了锅炉燃烧器布置调整
增加了后屏再热器的受热面积。计算和试验结果表明 :保持炉膛沾污系数为0 .3 5至 0 .4 5
过量空气系数为 1 .3左右
燃烧器上摆 8°至 1 6°
关闭上层燃尽风
维持低氧量 ( 3 .0 % )运行
可有效地提高蒸汽温度
Abstract
Directing against the problem of somewhat lower steam temperature existing on a 2008t/h boiler of one power plant
the arrangement of burners in the boiler has been adjusted
increasing the heating surface area of rear panel reheater
carrying out thermal calculation and combustion adjustment test for the said boiler. The results of calculation and test show that the following conditions are most helpful to enhance the main steam temperature: (1) contamination factor in the furnace to be maintained at 0.35~0.45; (2) coefficient of excess air to be about 1.3; (3) the upswing angle of the burner to be 8°~16°; (4) burnoff air in upper level to be closed
and oxygen content to be maintained at low level(3.0%). By means of adjusting swing angle of the burners and the spray type desuperheater
the said problems of main steam and reheated steam have been solved
enhancing the safety and economic behavior in operation of the unit.