With the continuous innovation of construction equipment and technology
non-displacement rock-socketed prestressed high-strength concrete (PHC) pipe pile has been gradually popularized and applied. To reveal the bearing mechanism of pile toe of rock-socketed PHC pipe pile
five groups of static load destructive tests of pile toe of PHC pipe pile with pile diameter of 500 mm in argillaceous siltstone area were carried out under the background of the drilling with prestressed concrete pipe pile. The bearing capacity and macroscopic failure mode of the pile toe of rock-socketed PHC pipe piles under different conditions were analyzed
and the calculation method of the pile toe bearing capacity was proposed. The test results show that when PHC pipe pile with open pile shoe is used and the pile end is not sealed
the open pile shoe weakens the bearing capacity of pile toe of PHC pipe pile. The pile shoe pierces into the bedrock
and the settlement of the pile toe is 11−15 mm under the ultimate load. After pouring concrete to seal the bottom
the bearing capacity of pile toe is significantly improved. The ultimate bearing capacity is 340% higher than that without bottom sealing
and the pile toe resistance share ratios of bottom sealing concrete and pile shoe are 78% and 22%
respectively. The pile toe is subjected to overall shear failure. Finally
based on the Hoek-Brown strength criterion
a simplified calculation method for the bearing capacity of pile toe of rock-socketed PHC pipe piles is put forward. The calculation accuracy of this method has been verified by the tests
and the calculation method can be used as a reference for the design and construction of non-displacement rock-socketed PHC pipe piles.
关键词
Keywords
references
J. G. Gutiérrez-Ch,S. Senent,S. Melentijevic,R. Jimenez.A DEM-Based Factor to Design Rock-Socketed Piles Considering Socket Roughness[J].Rock Mechanics and Rock Engineering,2021.
Huang Bin,Zhang Yuting,Lv Bu,Yang Zhijun,Fu Xudong,Zhang Benjiao.Vertical bearing characteristics of rock-socketed pile in a synthetic soft rock[J].European Journal of Environmental and Civil Engineering,2021.
Pouyan Asem.Base resistance of drilled shafts in soft rock using in situ load tests: A limit state approach[J].Soils and Foundations,2019.
Mustafa Jafari,Haythem Gharsallaoui,Karl Henry Victor,Alain Holeyman.End bearing response of open-ended pipe piles embedded in rock[J].International Journal of Rock Mechanics and Mining Sciences,2019.
original> .Axial Resistance of Bored Piles Socketed into Soft Rock[J].KSCE Journal of Civil Engineering,2019.
Zao Ling.Shaft resistance of pre-bored precast piles in Shanghai clay[J].Proceedings of the Institution of Civil Engineers - Geotechnical Engineering,2018.
Guoliang Dai,Rodrigo Salgado,Weiming Gong,Mingxing Zhu.The effect of sidewall roughness on the shaft resistance of rock-socketed piles[J].Acta Geotechnica,2017.
A. Serrano,C. Olalla,R.A Galindo.Ultimate bearing capacity at the tip of a pile in rock based on the modified Hoek–Brown criterion[J].International Journal of Rock Mechanics and Mining Sciences,2014.
Haofeng Xing,Zhen Zhang,Minghui Meng,Yong Luo,Guanbao Ye.Centrifuge Tests of Superlarge-Diameter Rock-Socketed Piles and Their Bearing Characteristics[J].Journal of Bridge Engineering,2014.
Ming Zhu,Radoslaw L. Michalowski.Shape Factors for Limit Loads on Square and Rectangular Footings[J].Journal of Geotechnical and Geoenvironmental Engineering,2005.
Charles W. W. Ng,Terence L. Y. Yau,Jonathan H. M. Li,Wilson H. Tang.Side Resistance of Large Diameter Bored Piles Socketed into Decomposed Rocks[J].Journal of Geotechnical and Geoenvironmental Engineering,2001.
Lianyang Zhang.End Bearing Capacity of Drilled Shafts in Rock[J].Journal of Geotechnical and Geoenvironmental Engineering,1998.
George Geoffrey Meyerhof.Some Recent Research on the Bearing Capacity of Foundations[J].Canadian Geotechnical Journal,1963.