Analysis of the mining induced stress rotation influence on fault stability

LU Zhi-guo; JU Wen-jun; ZHAO Yi-xin; WANG Hao; ZHENG Jian-wei; LIU Ai-qing

doi:10.16285/j.rsm.2018.1492

English Version Journal Login

您当前的位置：

首页 >

文章列表页 >

Analysis of the mining induced stress rotation influence on fault stability

更新时间：2026-06-25

- Analysis of the mining induced stress rotation influence on fault stability
- Vol. 40, Issue 11, Pages: 4459-4466(2019)
- 作者机构：
  
  1. 煤炭科学研究总院开采研究分院,北京,100013
  2. 天地科技股份有限公司开采设计事业部,北京,100013
  3. 中国矿业大学（北京）资源与安全工程学院,北京,100083
  4. 河南理工大学能源科学与工程学院,河南,焦作,454000
- 作者简介：
- 基金信息：
- DOI：10.16285/j.rsm.2018.1492
  CLC： TD313
- Online First：01 December 2019，
  
  Published：2019
- 稿件说明：
移动端阅览
LU Zhi-guo, JU Wen-jun, ZHAO Yi-xin, et al. Analysis of the mining induced stress rotation influence on fault stability[J]. 2019, 40(11): 4459-4466.
DOI：

LU Zhi-guo, JU Wen-jun, ZHAO Yi-xin, et al. Analysis of the mining induced stress rotation influence on fault stability[J]. 2019, 40(11): 4459-4466. DOI： 10.16285/j.rsm.2018.1492.

摘要

为探究上、下盘不同开采顺序对断层稳定性影响，基于压力拱理论提出应力偏转概念，运用FLAC3D数值方法，模拟工作面分别从断层上盘和下盘向断层推进的过程，分析接触面应力状态和演化规律，验证采动诱发应力偏转，并与断层损伤变量及其增速进行对比分析。研究表明，工作面自上、下盘不同方向靠近断层，顶板主应力起始偏转位置分别为距离断层120 m和40 m处，相差80 m，且下盘最大偏转角是上盘工作面的1.68倍；断层损伤变量的启滑点分别距断层130 m和40 m，下盘工作面相对上盘工作面提前90 m，二者良好的对应关系表明应力偏转与断层滑移失稳显著相关。采动诱发应力偏转产生附加应力概念可以很好解释上、下盘工作面断层稳定性差异，为断层保护煤柱留设及工作面过断层防灾措施制定提供新思路。

Abstract

To explore the influence of different mining sequences on the fault stability

this paper put forward the hypothesis of stress rotation based on pressure arch theory. Firstly

a numerical model was set up to simulate the process of working face passing through the fault from the hanging wall and footwall to the fault. And then it analyzed the stress state and evolution law of contact surface

and verified the stress rotation induced by mining. Finally

comparative analysis of the fault damage variables and their growth rates was carried in this paper. The results show that during the propulsion process of working face from different directions of hanging wall and footwall of fault

the distance between start position of principal stress rotation in roof and fault is 120 m and 40 m

respectively. The maximum value of principal stress deflection angle when the working face located at footwall is 1.68 times than the value when located at hanging wall. The starting slip points of fault damage variables are 130 m and 40 m from fault

respectively. The fine correspondence between them indicates that stress rotation is significantly related to fault slip instability. The caption of additional stress induced by stress rotation can well explain the difference of fault stability due to different mining sequences

and provide new ideas for the design of fault coal pillar and disaster prevention measures.

关键词

Keywords

references

Views

247

下载量

CSCD

Alert me when the article has been cited

提交

Tools

Publicity Resources

Characterization of charge sensing signals during slip destabilization of faults with different roughness rock interfaces

A formula for calculating additional stresses in interface between geomembrane and sand

Calculation of ground settlement of sparse pile foundations using united solutions

Analysis of additional stresses of soil disturbance induced by propulsion of double-O-tube shield

Evolution of damage and permeability characteristics in roadways under mining disturbance

Related Author

WANG Kai-xing

SI Xu

LIU Yu-chun

ZHANG Li-li

LIANG Qin-feng

GONG Zheng

ZHAO Yang-feng

ZHANG Meng-xi

Related Institution

College of Science, Liaoning Technical University

School of Mechanics and Engineering, Liaoning Technical University

Department of Civil Engineering, Shanghai University

Test Center of Zhejiang Provincial Planning, Design & Research Institute of Communications

Shenzhen Construction Quality Supervision Center

AI问答

⁰