Experimental investigation on strength characteristic of coarse-grained materials in three-dimensional stress state

JIANG Jing-shan; CHENG Zhan-lin; ZUO Yong-zhen; DING Hong-shun

doi:10.16285/j.rsm.2017.0234

English Version Journal Login

您当前的位置：

首页 >

文章列表页 >

Experimental investigation on strength characteristic of coarse-grained materials in three-dimensional stress state

更新时间：2026-06-25

- Experimental investigation on strength characteristic of coarse-grained materials in three-dimensional stress state
- Vol. 39, Issue 10, Pages: 3581-3588(2018)
- 作者机构：
  
  1. 南京工程学院建筑工程学院,江苏,南京,211167
  2. 长江科学院水利部岩土力学与工程重点实验室,湖北,武汉,430010
- 作者简介：
- 基金信息：
- DOI：10.16285/j.rsm.2017.0234
  CLC： TU411
- Online First：04 November 2018，
  
  Published：2018
- 稿件说明：
移动端阅览
JIANG Jing-shan, CHENG Zhan-lin, ZUO Yong-zhen, et al. Experimental investigation on strength characteristic of coarse-grained materials in three-dimensional stress state[J]. 2018, 39(10): 3581-3588.
DOI：

JIANG Jing-shan, CHENG Zhan-lin, ZUO Yong-zhen, et al. Experimental investigation on strength characteristic of coarse-grained materials in three-dimensional stress state[J]. 2018, 39(10): 3581-3588. DOI： 10.16285/j.rsm.2017.0234.

摘要

粗粒料所处的应力状态具有随时间和空间而变的特点，往往处于较复杂的三维应力状态下。通过粗粒料大型真三轴各向等压固结等比例加载试验，研究了不同中主应力系数条件下粗粒料的强度特性。试验结果表明：中主应力对粗粒料的强度有重要影响，三维应力状态下，粗粒料的强度比常规三轴应力状态下有较大提高，大小主应力之差与大主应变关系曲线也更加陡峭；中主应力系数b从0增大到0.25时，破坏时大小主应力之差增加了39%～50%；摩尔–库仑强度参数咬合力c和内摩擦角? 均随着中主应力系数b的增大而增大，其中咬合力c的增长较为显著，特别是b从0增大到0.25时；相同小主应力条件下，b = 0时，破坏偏应力与球应力之比最小，b = 0.25时，破坏应力比达到最大值，随着b的增大破坏应力比又有所减小；相同中主应力系数条件下，随着小主应力的增大，破坏应力比逐渐减小。

Abstract

The coarse-grained materials are normally in three-dimensional (3D) stress state which changes with time and location. To investigate the strength characteristic of coarse-grained materials at different coefficients of intermediate principal stress

large-scale true triaxial tests were performed under isotropic consolidation and proportional loading conditions. The results show that the intermediate principal stress has an important effect on the strength of coarse-grained materials. The strength of coarse-grained materials in 3D stress state increases greatly compared to the strength in conventional triaxial stress state. The relationship of the major principal strain and the difference between the maximum and the minimum principal stresses in 3D stress state is steeper than that in conventional triaxial stress state. The difference between the maximum and the minimum principal stresses increases from 39% to 50% when the coefficient of intermediate principal stress increases from 0 to 0.25. Both the interlocking force c and internal friction angle ? increase with the increase of the coefficient of intermediate principal stress b. Especially

the interlocking force c increases significantly when b increases from 0 to 0.25. With the same minimum principal stress

the ratio of deviatoric stress to spheric stress at the failure state is the smallest with b=0

whereas the failure stress ratio reaches the maximum with b=0.25. However

the failure stress ratio decreases with the increase of b from 0.25 to 0.75. The stress ratio at failure state decreases with the increase of the minimum principal stress at the same coefficient of intermediate principal stress.

关键词

Keywords

references

Views

148

下载量

CSCD

Alert me when the article has been cited

提交

Tools

Publicity Resources

In-site test on earth pressure and saturating collapse test for unsaturated loess Q3 on high slope

Relation Between the Geologic Structure Feature and Rock Strength Performance of Red Rocks in Gezhouba

On Model of Big Granular Media

The Interaction Between Confining Rock and Lining in The Viscoelastic-Plastic Rock Media

Bounding surface model for granular aggregates incorporating the concept of fractional calculus

Related Author

LI Jia

HUANG Xue-feng

CHEN Zheng-han

LI Jia-gui

Peng Guangzhong

Yu Xiaosheng

Huang Shengsheng

Guo Jianyang

Related Institution

The Graduate Student Administrant Department of Logistical University Engineering of PLA

Department of Architecture Engineering, Logistical University Engineering of PLA

Institute of Rock and soil Mechanics, Academia Sinica Wuhan

Key Laboratory of Ministry of Education for Geomechanics and Embankment Engineering, Hohai University

State Key Laboratory of Geomechanics and Geotechnical Engineering, Institute of Rock and Soil Mechanics, Chinese Academy of Sciences

AI问答

⁰