Investigation on Heat Transfer Characteristics of Supercritical Carbon Dioxide in Printed Circuit Heat Exchanger

岳晓明; 王为术; 朱晓静

doi:10.16056/j.2096-7705.2022.01.010

English Version Reader LoginJournal Login

您当前的位置：

首页 >

文章列表页 >

Investigation on Heat Transfer Characteristics of Supercritical Carbon Dioxide in Printed Circuit Heat Exchanger

更新时间：2026-01-19

- Investigation on Heat Transfer Characteristics of Supercritical Carbon Dioxide in Printed Circuit Heat Exchanger
- Issue 1, Pages: 65-70(2022)
- 作者机构：
  
  1. 华北水利水电大学电力学院
  2. 大连理工大学大连理工大学能源与动力学院
- 作者简介：
- 基金信息：
- DOI：10.16056/j.2096-7705.2022.01.010
  CLC： TK172
- Published：2022
- 稿件说明：
移动端阅览
岳晓明, 王为术, 朱晓静. Investigation on Heat Transfer Characteristics of Supercritical Carbon Dioxide in Printed Circuit Heat Exchanger[J]. 2022, (1): 65-70.
DOI：

岳晓明, 王为术, 朱晓静. Investigation on Heat Transfer Characteristics of Supercritical Carbon Dioxide in Printed Circuit Heat Exchanger[J]. 2022, (1): 65-70. DOI： 10.16056/j.2096-7705.2022.01.010.

摘要

采用数值模拟的方法分析不同热工参数对印刷电路板式换热器内超临界二氧化碳进行换热特性研究。在压力8～12 MPa、质量流速800～2 000 kg/(m

·s)和入口温度650～850 K的参数范围内，讨论了压力、温度和质量流速对管内超临界二氧化碳传热特性的影响。研究结果表明：印刷电路板式换热器管内压力升高，传热系数增大；当流体温度升高，管内主流焓值增大，热传递能力增强，传热系数增大；在出口附近区域，随着边界层的厚度沿主流方向增加，传热系数先增大后减小，换热能力降低，传热系数减小；随着质量流速的升高，管内换热能力增强，平均换热系数升高，换热效果强化显著。

Abstract

The numerical simulation method is used to study the heat transfer characteristics of supercritical carbon dioxide in the printed circuit heat exchanger with different thermal parameters. Within the range of pressure from 8 to 12 MPa

mass velocity of fluid from 800 to 2 000 kg/（m~2·s） and fluid temperature from 650 K to 850 K

the heat transfer characteristics of supercritical carbon dioxide in the printed circuit heat exchanger are numerically analyzed. The effects of pressure

temperature and mass flow rate on the heat transfer characteristics of supercritical carbon dioxide in tube were discussed. The results show that the pressure in the tube of printed circuit heat exchanger increases and the heat transfer coefficient increases.When the fluid temperature increases

the mainstream enthalpy increases

the heat transfer capacity increases and the heat transfer coefficient increases; In the area near the outlet

as the thickness of the boundary layer increases along the mainstream direction

the heat transfer coefficient first increases and then decreases

the heat transfer capacity decreases and the heat transfer coefficient decreases; With the increase of mass flow rate

the heat transfer capacity in the tube increases

the average heat transfer coefficient increases

and the heat transfer effect is strengthened significantly.

关键词

Keywords

references

PCHE内轴向导热对局部换热性能的影响研究[J]. 张海燕;郭江峰;淮秀兰;崔欣莹.化工学报,2019(12)

基于CFD方法的PCHE窄小流道内超临界CO_2流动传热特性数值研究[J]. 刘贵军;陈德奇;胡练;王俊峰.核动力工程,2019(03)

不同肋片结构的印刷电路板换热器传热与阻力特性[J]. 褚雯霄;李雄辉;马挺;曾敏;王秋旺.科学通报,2017(16)

双D形流道内超临界二氧化碳传热特性数值研究[J]. 刘生晖;黄彦平;刘光旭;王俊峰;赵大卫;臧金光;昝元锋;郎雪梅;徐建军.核动力工程,2016(02)

Numerical Study on the Gravity Effect on Heat Transfer of Supercritical CO2 in a Vertical Tube[J]. Xiaojing Zhu;Ruizeng Zhang;Xiao Yu;Maoguo Cao;Yongxiang Ren.Energies,2020(13)

Heat transfer of supercritical CO 2 in vertical round tube: A considerate turbulent Prandtl number modification[J]. Xin Du;Zhihao Lv;Xiao Yu;Maoguo Cao;Jianjun Zhou;Yongxiang Ren;Qinggang Qiu;Xiaojing Zhu.Energy,2020(C)

Investigation of buoyancy-enhanced heat transfer of supercritical CO 2 in upward and downward tube flows[J]. Chen-Ru Zhao;Qian-Feng Liu;Zhen Zhang;Pei-Xue Jiang;Han-Liang Bo.The Journal of Supercritical Fluids,2018

Comprehensive performance comparison of airfoil fin PCHEs with NACA 00XX series airfoil[J]. Fei Chen;Lishen Zhang;Xiulan Huai;Jufeng Li;Hang Zhang;Zhigang Liu.Nuclear Engineering and Design,2017

A comparative study of solar heliostat assisted supercritical CO 2 recompression Brayton cycles: Dynamic modelling and control strategies[J]. Dia Milani;Minh Tri Luu;Robbie McNaughton;Ali Abbas.The Journal of Supercritical Fluids,2017

Modeling and analysis of a printed circuit heat exchanger for supercritical CO 2 power cycle applications[J]. Ajinkya Meshram;Ankush Kumar Jaiswal;Sagar D. Khivsara;Jesus D. Ortega;Clifford Ho;Rucha Bapat;Pradip Dutta.Applied Thermal Engineering,2016

Pressure drop and heat transfer characteristics of a high-temperature printed circuit heat exchanger[J]. Minghui Chen;Xiaodong Sun;Richard N. Christensen;Isaac Skavdahl;Vivek Utgikar;Piyush Sabharwall.Applied Thermal Engineering,2016

Design study and cost assessment of straight, zigzag, S-shape, and OSF PCHEs for a FLiNaK–SCO 2 Secondary Heat Exchanger in FHRs[J]. In Hun Kim;Xiaoqin Zhang;Richard Christensen;Xiaodong Sun.Annals of Nuclear Energy,2016

Study on local thermal–hydraulic performance and optimization of zigzag-type printed circuit heat exchanger at high temperature[J]. Ting Ma;Lei Li;Xiang-Yang Xu;Yi-Tung Chen;Qiu-Wang Wang.Energy Conversion and Management,2015

Comparative study on performance of a zigzag printed circuit heat exchanger with various channel shapes and configurations[J]. Sang-Moon Lee;Kwang-Yong Kim.Heat and Mass Transfer,2013(7)

Experimental and numerical investigation of convection heat transfer of CO{sub}2 at supercritical pressures in a vertical tube at low Reynolds numbers[J]. Pei-Xue Jiang;Yu Zhang;Yi-Jun Xu;Run-Fu Shi.International Journal of Thermal Sciences,2008(8)

传热学[M]. 杨世铭,陶文铨编著.高等教育出版社,2006

Views

568

下载量

CSCD

Alert me when the article has been cited

提交

Tools

Publicity Resources

Analysis of Fluid Flow Heat Transfer Performance of Wound Tube Heat Exchangers

Simulation and Application of High Density Electrical Method in Engineering Karst Exploration

Numerical Simulation of Biomass Gas Re-burning Nozzles Swing Angle Change Coupled with Combustion Characteristics of Coal-fired Boiler

Numerical Simulation of Combustion Characteristics of Biomass（Gas） Coupled Coal-fired Boiler

Simulation on Combustion Optimization for Circulating Fluidized Bed Boiler based on CPFD Method

Related Author

何耀辰

朱炳衡

李书金

刘家森

徐启

张晓峰

李强

张程俞

Related Institution

华北水利水电大学能源与动力工程学院

东华理工大学

华北水利水电大学

郑州电力高等专科学校

华中科技大学煤燃烧国家重点实验室

AI问答

⁰