Simulation and Experimental Study on Urea Spray Cone Angle of Selective Catalytic Reduction System for a Generating Set Diesel Engine

王文晓; 朱智富; 赵英良; 王胜; 桂建华; 王继荣

doi:10.13949/j.cnki.nrjgc.2020.01.009

您当前的位置：

首页 >

文章列表页 >

Simulation and Experimental Study on Urea Spray Cone Angle of Selective Catalytic Reduction System for a Generating Set Diesel Engine

更新时间：2026-04-16

- Simulation and Experimental Study on Urea Spray Cone Angle of Selective Catalytic Reduction System for a Generating Set Diesel Engine
- Vol. 41, Issue 1, Pages: 64-69(2020)
- 作者机构：
  
  1. 青岛大学机电工程学院,青岛,266000
  2. 青岛大学物理科学学院,青岛,266000
  3. 山东康钧环保科技有限公司,潍坊,261000
- 作者简介：
- 基金信息：
- DOI：10.13949/j.cnki.nrjgc.2020.01.009
  CLC：
- Published：2020
- 稿件说明：
移动端阅览
王文晓，朱智富，赵英良，王胜，桂建华，王继荣.发电柴油机选择性催化还原系统尿素喷雾锥角的仿真及试验研究[J].内燃机工程,2020,41(1):64-69.

王文晓, 朱智富, 赵英良, et al. Simulation and Experimental Study on Urea Spray Cone Angle of Selective Catalytic Reduction System for a Generating Set Diesel Engine[J]. 2020, 41(1): 64-69.
王文晓，朱智富，赵英良，王胜，桂建华，王继荣.发电柴油机选择性催化还原系统尿素喷雾锥角的仿真及试验研究[J].内燃机工程,2020,41(1):64-69. DOI： 10.13949/j.cnki.nrjgc.2020.01.009.

王文晓, 朱智富, 赵英良, et al. Simulation and Experimental Study on Urea Spray Cone Angle of Selective Catalytic Reduction System for a Generating Set Diesel Engine[J]. 2020, 41(1): 64-69. DOI： 10.13949/j.cnki.nrjgc.2020.01.009.

摘要

对大功率发电柴油机选择性催化还原（selective catalytic reduction

SCR）尿素喷雾锥角进行研究。运用计算流体动力学（computational fluid dynamics

CFD）软件模拟了4种不同喷雾锥角尿素混合管内的结晶风险和NH3 分布均匀性

通过分析仿真结果

优选出60°和70°两种喷雾锥角的尿素喷嘴。使用选定的喷雾锥角进行结晶对比试验和性能对比试验。结晶对比试验结果显示

60°喷雾锥角的结晶风险明显低于70°喷雾锥角的结晶风险。性能对比试验结果显示

两种喷雾锥角的NOx 转化效率基本一致。综合分析仿真结果与试验结果

最终将SCR系统的尿素喷雾锥角优化为60°。

Abstract

The urea spray cone angle of a selective catalytic reduction (SCR) system used on a high-power generating set diesel engine was studied. The crystallization risk and NH3 distribution uniformity in an urea mixing pipe with 4 different spray cone angles were simulated by a computational fluid dynamics software. Through the simulation analysis

two kinds of urea nozzles with spray cone angles of 60° and 70° were selected for the crystallization contrast test and performance comparison test. The results of the crystallization contrast test show that the crystallization risk of the 60° spray cone angle is obviously lower than the 70° spray cone angle. The performance comparison test indicates that the NOx conversion efficiencies of the two spray cone angles are basically the same. After the comprehensive analysis of the simulation calculations and test results

the urea spray cone angle of the SCR system is finally optimised to 60°.

关键词

Keywords

references

Views

956

下载量

CSCD

Alert me when the article has been cited

提交

Tools

Publicity Resources

No data

Related Author

No data

Related Institution

No data

AI问答

⁰