Optimization and implementation of CO<sub>2</sub> huff and puff parameters of horizontal wells in Banqiao Oilfield during extra high water cut period

Zhang Tao; Li Dening; Cui Yinan; Liu Yonghe; Che Zhengjia; Wang Shunli

doi:10.13809/j.cnki.cn32-1825/te.2019.03.010

English Version Reader LoginJournal Login

您当前的位置：

首页 >

文章列表页 >

Optimization and implementation of CO₂ huff and puff parameters of horizontal wells in Banqiao Oilfield during extra high water cut period

更新时间：2025-12-05

- Optimization and implementation of CO₂ huff and puff parameters of horizontal wells in Banqiao Oilfield during extra high water cut period
- Petroleum Reservoir Evaluation and Development Vol. 9, Issue 3, Pages: 51-56(2019)
- 作者机构：
  
  1. 中国石油大港油田分公司第四采油厂,天津,300280
  2. 西南石油大学油气藏地质及开发工程国家重点实验室,四川,成都,610500
- 作者简介：
- 基金信息：
- DOI：10.13809/j.cnki.cn32-1825/te.2019.03.010
  CLC： TE357
- Published：2019
- 稿件说明：
移动端阅览
Zhang Tao, Li Dening, Cui Yinan, et al. Optimization and implementation of CO₂ huff and puff parameters of horizontal wells in Banqiao Oilfield during extra high water cut period[J]. Petroleum Reservoir Evaluation and Development, 2019, 9(3): 51-56.
DOI：

Zhang Tao, Li Dening, Cui Yinan, et al. Optimization and implementation of CO₂ huff and puff parameters of horizontal wells in Banqiao Oilfield during extra high water cut period[J]. Petroleum Reservoir Evaluation and Development, 2019, 9(3): 51-56. DOI： 10.13809/j.cnki.cn32-1825/te.2019.03.010.

摘要

目前板桥油田板14-1断块油藏含水率98.1 %

采出程度10.93 %

常规控水稳油技术已无法解决油藏含水高、产能低、经济效益差的问题。和常规控水增油技术相比

吞吐压锥具有工艺简单、施工周期短、成功率较高等优势。采用数值模拟技术研究了CO

吞吐降水增油机理

并在此基础上

优化了CO

吞吐工艺参数

确定了油藏水平井CO

吞吐最优工艺方案。在方案优选基础上

现场实施了CO

吞吐方案。研究结果显示

吞吐通过气驱压锥

萃取原油中间组分

降低原油黏度机理实现了特高含水期水平井控水增油;通过对比不同工艺参数下单井累计增油量及换油率

的最优注入量为600 t、注入速度4.0 t/h、焖井时间17 d、产液量16 m

/d、吞吐轮次2个。45H井现场先导试验显示

45H井产液量为12 m

含水率由98.1 %降低至62.5 %

产油量由1.6 m

/d上升至4.73 m

吞吐控制底水锥进、降低油井含水率和恢复产能效果明显。研究表明

水平井CO

吞吐对板桥油田同类油藏具有较好的适应性和应用推广前景。

Abstract

At present

the water cut of fault block 14-1 reservoir in Banqiao Oilfield is 98.1 % and the recovery degree is 10.93 %. Conventional water control and oil stabilization technology can not solve the problems of high water cut

low productivity and poor economic benefit. Compared with conventional water control and oil enrichment technology

huff and puff cone has the advantages

of simple technology

short construction period and high success rate. The mechanism of precipitation and oil increase by CO

huff and puff is studied by numerical simulation technology. On this basis

the technological parameters of CO

huff and puff are optimized

and the optimal technological scheme of CO

huff and puff for horizontal wells in reservoirs is determined. On the basis of scheme optimization

huff and puff scheme was implemented on site. The results show that CO

huff and puff achieves water control and oil increase in horizontal wells at extra high water cut period by extracting the intermediate components of crude oil through gas drive pressure cone and reducing the viscosity mechanism of crude oil. By comparing the cumulative oil increase and oil exchange rate of single well under different process parameters

the optimal injection rate of CO

is 600 t

injection rate is 4.0 t/h

soaking time is 17 d

fluid production is 16 m

and the number of huff and puff cycles is two. Field pilot test of well 45H shows that the fluid production of well 45H is 12 m

the water cut is reduced from 98.1 % to 62.5 %

and the oil production is increased from 1.6 m

/d to 4.73 m

/d. CO

huff and puff can control bottom water coning

reduce water cut and restore productivity effectively. The results show that horizontal well CO

huff and puff has good adaptability and application prospect for similar reservoirs in Banqiao Oilfield.

关键词

Keywords

references

Views

下载量

CSCD

Alert me when the article has been cited

提交

Tools

Publicity Resources

Dicussion on well selection conditions of CO₂ huff and puff in low permeability reservoir

Optimization of segmented fracturing parameters for coalbed methane horizontal wells based on comprehensive fracability index

Huff-n-puff technology and parameter optimization of large displacement water injection in tight oil reservoir

Key technologies of horizontal well fracturing for deep coal-rock gas: A case study of Jurassic in Baijiahai area, Junggar Basin

Experimental study on CO₂ flooding/huff and puff of medium-deep heavy oil in Xinjiang Oilfield

Related Author

Wang Jun

KONG Xiangwei

XIE Xin

WANG Cunwu

ZHANG Yi

NING Chongru

CHEN Yazhou

JI Yulong

Related Institution

Exploration and Development Research Institute, East China Oil and Gas Company, SINOPEC

CNOOC Research Institute Co., Ltd.

School of Petroleum Engineering, Yangtze University

Hubei Key Laboratory of Drilling and Production Engineering for Oil and Gas, Yangtze University

PetroChina Changqing Oilfield Branch Fourth Oil Production Plant, Jingbian

AI问答

⁰

Optimization and implementation of CO2 huff and puff parameters of horizontal wells in Banqiao Oilfield during extra high water cut period

DOI：10.13809/j.cnki.cn32-1825/te.2019.03.010

摘要

Abstract

关键词

Keywords

references

Optimization and implementation of CO₂ huff and puff parameters of horizontal wells in Banqiao Oilfield during extra high water cut period