Analysis of Internal Flow Characteristics of Gas Turbine Ejector Mixer with Valve Plate

Kai WEI; Zhong LUO; Yonghang SUN; Yu WANG

doi:10.12096/j.2096-4528.pgt.21019

English Version Reader LoginJournal Login

您当前的位置：

首页 >

文章列表页 >

Analysis of Internal Flow Characteristics of Gas Turbine Ejector Mixer with Valve Plate

Intelligent Turbine Power Generation Technology | 更新时间：2025-07-04

- Analysis of Internal Flow Characteristics of Gas Turbine Ejector Mixer with Valve Plate
- Power Generation Technology Vol. 42, Issue 4, Pages: 431-436(2021)
- 作者机构：
  
  1.东北大学机械工程与自动化学院, 辽宁省沈阳市 110819
  2.东北大学佛山研究生院, 广东省佛山市 528312
  3.东北大学航空动力装备振动及控制教育部重点实验室, 辽宁省沈阳市 110819
- 作者简介：
- 基金信息：
  
  National Natural Science Foundation of China(11872148);National Natural Science Foundation of China(U1908217);Joint Foundation of Basic and Applied Basic Research of Guangdong Province(2020B1515120015)
- DOI：10.12096/j.2096-4528.pgt.21019
  CLC： TK47
- Received：07 February 2021，
  
  Published：31 August 2021
- 稿件说明：
移动端阅览
Kai WEI, Zhong LUO, Yonghang SUN, et al. Analysis of Internal Flow Characteristics of Gas Turbine Ejector Mixer with Valve Plate[J]. Power Generation Technology, 2021, 42(4): 431-436.
DOI：

Kai WEI, Zhong LUO, Yonghang SUN, et al. Analysis of Internal Flow Characteristics of Gas Turbine Ejector Mixer with Valve Plate[J]. Power Generation Technology, 2021, 42(4): 431-436. DOI： 10.12096/j.2096-4528.pgt.21019.

摘要

引射混合器对燃气轮机的降温降噪具有决定性作用，与传统的引射混合器相比，带有阀片结构的引射混合器性能较好。为了充分探究其内流特性，进而为优化设计提供依据，在有无阀片的引射混合器构型下，基于计算流体动力学(computational fluid dynamics，CFD)数值模拟，对比分析了其引射比、出口平均温度、出口最高温度、出口平均速度等表征引射性能的参数；针对带有阀片的引射混合器，分析了不同阀片开度下的引射性能。结果表明：带有阀片结构的引射混合器的混合性能显著提高，在阀片开度为45°时，其引射性能最佳。

Abstract

The ejector mixer plays a decisive role in the cooling and noise reduction of gas turbine. Compared with the traditional ejector mixer

the ejector mixer with valve plate structure has better performance. In order to fully explore its internal flow characteristics and provide a basis for optimal design

the computational fluid dynamics (CFD) numerical simulation was used to study the ejector configuration with or without valve plate. The ejector performance parameters such as ejector ratio

average outlet temperature

maximum temperature and average outlet velocity were compared and analyzed. The ejector performance with different valve openings was analyzed for the ejector mixer with valve plates. The results show that the mixing performance of the ejector mixer with valve plate structure is significantly improved. The ejection performance is the best when the valve opening is 45°.

关键词

Keywords

references

阳仕柏, 刘艳明, 叶传新, 等. 船舶燃气轮机进气系统排气引射器流动机理数值研究[C]//2019全国工业流体力学会议论文集. 北京, 2019: 85-90.

YANG S B, LIU Y M, YE C X. Numerical study on flow mechanism of exhaust ejector in marine gas turbine intake system[C]//2019 Proceedings of the National Conference on Industrial Fluid Dynamics. Beijing, 2019: 85-90.

张燚. 波瓣喷管引射机理及应用研究[D]. 哈尔滨: 哈尔滨工程大学, 2013.

ZHANG Y. Research on the mechanism and application of lobed nozzle[D]. Harbin: Harbin Engineering University, 2013.

KEENAN J H, NEUMANN E P. A simple air ejector[J]. Journal of Applied Mechanics, 1942, 9(2): 75-81.

KEENAN J H, NEUMANN E P, LUSTWERK F. An investigation of ejector design by analysis and experiment[J]. Journal of Applied Mechanics, 1950, 17: 299-309.

LIAO C, BEST F. Comprehensive gas ejector model[J]. Journal of Thermophysics and Heat Transfer, 2010, 24(3): 516-523.

BOTTENHEIM D S, BIRK A M, POIRIER D J. Performance of a longitudinal circular-to-slot gas turbine exhaust duct with a 90 degree bent[C]//Proceedings of ASME Tubo Expo 2004: Power for Land, Sea, and Air. June 14-17, 2004, Vienna, Austria. 2004: 163-170.

MAQSOOD A, BIRK A M. Experimental and CFD study of exhaust ejectors with bent mixing tubes[C]//Proceedings of ASME Tubo Expo 2005: Power for Land, Sea, and Air. June 6-9, 2005, Reno, Nevada. 2005: 155-165.

KIM S, KWON S. Experimental determination of geometric parameters for an annular injection type supersonic ejector[J]. Journal of Fluids Engineering, 2006, 128(6): 1164-1171.

OPGENORTH M J, SEDERSTROM D, MCDERMOTT W, et al. Maximizing pressure recovery using lobed nozzles in a supersonic ejector[J]. Applied Thermal Engineering, 2012, 37: 396-402.

NAMET-ALLAH A, BIRK A M. Experimental investigation of the effects of nozzle length on the performance of low mach number air-air ejector with entraining diffuser[C]//Proceedings of ASME Turbo Expo 2013: Turbine Technical Conference and Exposition. June 3-7, 2013, San Antonio, Texas, USA. 2013: GT2013-94069.

潘丞雄, 张靖周, 单勇. 双级波瓣引射混合器的引射性能[J]. 航空动力学报, 2014, 29(9): 2174-2180.

PAN C X, ZHANG J Z, SHAN Y. Pumping performance for double-stage lobe mixer/ejector[J]. Journal of Aerospace Power, 2014, 29(9): 2174-2180.

刘培启, 王海涛, 武锦涛, 等. 引射器关键结构参数优化设计及验证[J]. 大连理工大学学报, 2017, 57(1): 29-36.

LIU P Q, WANG H T, WU J T, et al. Optimum design and verification of ejector's main structural parameters[J]. Journal of Dalian University of Technology, 2017, 57(1): 29-36.

叶宇琛. 直升机排气引射器配合角度对引射性能的影响[J]. 中国科技信息, 2020(6): 24-27.

YE Y C. Influence of matching angle of helicopter exhaust ejector on ejector performance[J]. China Science and Technology Information, 2020(6): 24-27.

赵芳, 任泽斌, 王海锋, 等. 高温燃气引射系统对接试验验证[J]. 实验流体力学, 2020, 34(3): 111-116.

ZHAO F, REN Z B, WANG H F, et al. Docking test verification of high temperature gas ejector system[J]. Journal of Experiments in Fluid Mechanics, 2020, 34(3): 111-116.

杨文军, 袁惠群, 赵天宇. 基于Kriging模型的数据拟合及多场耦合动力学特性分析[J]. 东北大学学报(自然科学版), 2016, 37(6): 834-838.

YANG W J, YUAN H Q, ZHAO T Y. Multi-field coupling dynamic characteristics and data fitting based on Kriging model[J]. Journal of Northeastern University (Natural Science), 2016, 37(6): 834-838.

WU K, JIN Y, KIM H D. Hysteretic behaviors in counter-flow thrust vector control[J]. Journal of Aerospace Engineering, 2019, 32(4): 04019041.

IM J H, SONG S J. Mixing and entrainment characteristics in circular short ejectors[J]. Journal of Fluids Engineering, 2015, 137(5): 051103.

Views

下载量

CSCD

Alert me when the article has been cited

提交

Tools

Publicity Resources

Uncertainty Analysis of Gas Turbine Overall Performance Based on Monte Carlo Method

Research Progress on Film Cooling Fed by Crossflow Ribbed Passage of Gas Turbine Blades

Research Status and Development Trend of Rotating Internal Cooling Channel in Gas Turbine Blade

Review of Research on Swirl Cooling Technology of Gas Turbine Blades

Impact of Falling Blocks of High Pressure Turbine Rotor Blades With Squealer Tip on the Aerodynamic Performance and Vibration Characteristics

Related Author

KONG Xiangling

LIU Haisong

FU Jinglun

CHEN Yan

LU Wenqiang

TONG Zhiting

FU Jinglun

ZHANG Haichuan

Related Institution

Nanjing Institute of Future Energy System, IET, CAS

Jiangsu Yanhai Chemical Co., Ltd.

Advanced Gas Turbine Laboratory, Institute of Engineering Thermophysics, Chinese Academy of Sciences, Haidian District

Research Center of Fluid Machinery Engineering and Technology, Jiangsu University

University of Chinese Academy of Sciences, Haidian District

AI问答

⁰