Analysis and Application of Fast Closing Boundary Conditions for Governing Valves of 1 000 MW Ultra-supercritical Unit

Xiaohui SONG; Heng LIANG; Xinming CHEN; Jianguo PU; Junlin LIAO; Gang WU; Jinliang YIN

doi:10.12096/j.2096-4528.pgt.20004

English Version Reader LoginJournal Login

您当前的位置：

首页 >

文章列表页 >

Analysis and Application of Fast Closing Boundary Conditions for Governing Valves of 1 000 MW Ultra-supercritical Unit

Power Generation and Enviromental Protection | 更新时间：2025-07-04

- Analysis and Application of Fast Closing Boundary Conditions for Governing Valves of 1 000 MW Ultra-supercritical Unit
- Power Generation Technology Vol. 41, Issue 6, Pages: 689-696(2020)
- 作者机构：
  
  1.西安热工研究院有限公司, 陕西省西安市 710054
  2.中国华能集团清洁能源技术研究院有限公司, 北京市昌平区 102209
  3.国家电投集团河南电力有限公司技术信息中心, 河南省郑州市 450000
- 作者简介：
- 基金信息：
  
  National Key Research and Development Program of China(2019YFE0100100)
- DOI：10.12096/j.2096-4528.pgt.20004
  CLC： TK38
- Received：11 March 2020，
  
  Published：31 December 2020
- 稿件说明：
移动端阅览
Xiaohui SONG, Heng LIANG, Xinming CHEN, et al. Analysis and Application of Fast Closing Boundary Conditions for Governing Valves of 1 000 MW Ultra-supercritical Unit[J]. Power Generation Technology, 2020, 41(6): 689-696.
DOI：

Xiaohui SONG, Heng LIANG, Xinming CHEN, et al. Analysis and Application of Fast Closing Boundary Conditions for Governing Valves of 1 000 MW Ultra-supercritical Unit[J]. Power Generation Technology, 2020, 41(6): 689-696. DOI： 10.12096/j.2096-4528.pgt.20004.

摘要

某1 000 MW超超临界机组在冷态冲转过程中出现调阀频繁快关动作，造成阀体支撑晃动大，无法继续升速。针对这一问题，试运现场通过调整冲转参数、检查电磁阀油路、重新化验控制油油质等措施仍未得到解决。为此，从转速控制逻辑出发，分析快关动作发生的条件及调阀快关过程中比例积分（proportion integration，PI）调节量的变化，得出快关过程中影响总流量指令（即最终的阀位开度）最主要的因素是转速调节的前馈量变化，而并非是转速PI输出量的变化。依据这一分析，在不改变冲转参数、阀门流量特性曲线的条件下，计算出转速控制前馈量的边界值。通过多次尝试确立前馈量的最优值，避免控制逻辑中因参数设置不合理而触发调阀快关动作。优化后实际转速跟随设定值平稳上升，调阀开度线性开启，不再出现频繁摆动，达到升速控制的要求。

Abstract

The frequent fast closing action of the governing valve in a 1000 MW ultra-supercritical unit occurred during the cold running process

which caused the valve body to sway greatly and could not continue to speed up. The problem had not been solved by governing the impulse parameters

checking the solenoid valve oil circuit

retesting the control oil quality and other measures. Therefore

starting from the speed control logic

the conditions of fast closing action and the change of proportional integral (PI) regulating quantity were analyzed. It was concluded that the main factor affecting the total flow instruction (the final valve position opening) in the process of fast closing is the feedforward change of speed regulation

not the change of PI output. Based on this analysis

the boundary value of feedforward quantity of speed control was calculated without changing the impulse parameters and the flow characteristic curve of the valve. Through many attempts to establish the optimal value of feedforward quantity

the fast closing action of the governing valve can be avoided due to the unreasonable parameter setting in the control logic. After optimization

the actual speed rises steadily with the set value

the valve opening is opened linearly

and there is no more frequent swing

which meets the requirements of speed up control.

关键词

Keywords

references

高秋海, 沈俭.600 MW汽轮机阀门活动试验的异常分析与处理[J].机电工程技术, 2016, 45(7):102-105.

GAO Q H, SHEN J.600 MW steam turbine valve abnormal activity test of analysis and processing[J].M&E Engineering Technology, 2016, 45(7):102-105.

甘超齐, 李春光, 汪勇刚.汽轮机主汽阀关闭时间超标原因分析及处理措施[J].热力发电, 2014, 43(7):139-142.

GAN C Q, LI C G, WANG Y G.Over standard of mail steam valves closing time in a pressure steam turbine:reason analysis and countermeasures[J].Thermal Power Generation, 2014, 43(7):139-142.

郝帅, 吴昕, 王明远, 等.350 MW超临界机组汽轮机汽流激振分析及处理[J].发电技术, 2019, 40(2):168-174.

HAO S, WU X, WANG M Y, et al.Analysis and processing of the steam-flow exciting vibration in steam turbine of a 350 MW supercritical unit[J].Power Generation Technology, 2019, 40(2):168-174.

盛锴, 魏乐, 江效龙, 等.基于PSASP和Simulink的汽轮机调节系统建模与仿真校核[J].中国电力, 2015, 48(2):1-6.

SHENG K, WEI L, JIANG X L, et al.Modeling simulation and verification of turbine governing system based on PSASP and Simulink[J].Electric Power, 2015, 48(2):1-6.

罗云, 陈雪林, 李瑞东, 等.汽轮机变工况下调节级压力预测模型及应用[J].发电技术, 2019, 40(2):161-167.

LUO Y, CHEN X L, LI R D, et al.Prediction model and application of turbine regulating stage pressure under variable conditions[J].Power Generation Technology, 2019, 40(2):161-167.

黄小军, 杜祥国.600 MW超临界汽轮机延长混合阀运行时间对机组振动的影响[J].发电技术, 2019, 40(2):175-180.

HUANG X J, DU X G.Effect of 600 MW supercritical steam turbine prolonging running time of mixing valve on unit vibration[J].Power Generation Technology, 2019, 40(2):175-180.

何冬辉, 叶振起, 赵奕州.1000 MW超超临界机组ATT试验异常问题分析及改进措施[J].东北电力技术, 2019, 40(3):12-15.

HE D H, YE Z Q, ZHAO Y Z.Analysis and improvement measures of ATT test abnormal problems of 1000 MW ultra-supercritical unit[J].Northeast Electric Power Technology, 2019, 40(3):12-15.

房国成, 赵一丹.1000 MW超超临界机组汽轮机汽门关闭时间调整[J].东北电力技术, 2010, 13(9):11-14.

FANG G C, ZHAO Y D.Time adjusting on steam valve system for 1000 MW ultra-supercritical generating units[J].Northeast Electric Power Technology, 2010, 13(9):11-14.

韩庆祝, 丁建学.汽轮机高调门振荡原因分析及处理[J].科技创新导报, 2016, 13(34):72-73.

HAN Q Z, DING J X.Analysis and treatment of the oscillation of steam turbine high-speed control valve[J].Science and Technology Innovation Herald, 2016, 13(34):72-73.

黄裕恩.高中压调门瞬间关闭故障的分析与处理[J].电力安全技术, 2018, 20(2):32-33.

HUANG Y E.Analysis and treatment of the fault that the oil pump linkage high and medium pressure regulating valve closes instantly[J].Electric Safety Technology, 2018, 20(2):32-33.

颜士伟, 梅雪松, 刘海风, 等.油泵联动过程中调节汽门关闭问题处理[J].汽轮机技术, 2010, 52(6):473-474.

YAN S W, MEI X S, LIU H F, et al.Application of rexa actuator for MEH system retrofit of boiler feedwater pump turbine[J].Turbine Technology, 2010, 52(6):473-474.

赵智慧, 司文波.1000 MW超超临界机组单侧中压调门异常关闭应对策略[J].电力与能源, 2018, 39(1):94-97.

ZHAO Z H, SI W B.Abnormal shutdown and countermeasures for one-side medium-pressure governing valve in 1000 MW ultra-supercritical unit[J].Power&Energy, 2018, 39(1):94-97.

王强, 赵彩霞, 唐文岩, 等.上汽西门子汽轮机控制及调试问题简析[J].热里透平, 2017, 46(4):288-292.

WANG Q, ZHAO C X, TANG W Y, et al.Brief analysis of control and commissioning of STP-SIEMENS steam turbines[J].Thermal Turbine, 2017, 46(4):288-292.

吴永海, 秦建新, 冯玉国.西门子660 MW机组调门伺服阀运行中的更换[J].电力安全技术, 2009, 11(4):50-51.

WU Y H, QIN J X, FENG Y G.Replacement of the servo valve of Siemens 660 MW unit in operation[J].Electric Safety Technology, 2009, 11(4):50-51.

阮提, 张俊伟, 吴文杰.华能福州电厂#6汽机ATT试验失败的原因分析及防范措施[J].电气工程与自动化, 2019, 2(5):9-10.

RUAN T, ZHANG J W, WU W J.Cause analysis and preventive measures of ATT test failure of #6 turbine in Huaneng Fuzhou power plant[J].Electrical Engineering and Automation, 2019, 2(5):9-10.

张顺利.某超超临界660 MW机组调节汽门关闭时间超标分析与处理[J].中国设备工程, 2017, 7(5):114-116.

ZHANG S L.Analysis and treatment of excessive closing time of regulating valve of an ultra-supercritical 660 MW unit[J].China Plant Engineering, 2017, 7(5):114-116.

戴锡辉.阀门活动试验时中压调门自动全关的原因分析[J].华电技术, 2013, 35(5):29-32.

DAI X H.Analysis on reason causing medium-pressure regulating valve to close off incorrectly by itself[J].Huadian Technology, 2013, 35(5):29-32.

孟海洋.新型国产1050 MW超超临界机组高压主汽阀卡涩原因分析及改进[J].中国电力, 2018, 51(7):90-93.

MENG H Y.Cause analysis and improvement on jammed high pressure main steam valve of new type domestic 1050 MW ultra-supercritical unit[J].Electric Power, 2018, 51(7):90-93.

谢尉扬.西门子超超临界汽轮机问题分析与改进[J].汽轮机技术, 2015, 57(2):86-88.

XIE W Y.Analysis and improvement of problems for Siemens ultra-supercritical turbine[J].Turbine Technology, 2015, 57(2):86-88.

朱北恒, 李泉.超(超)临界机组协调控制特性与控制策略[J].中国电力, 2008, 41(3):66-69.

ZHU B H, LI Q.Characteristics and control strategies of coordinated control system (CCS) for supercritical and ultra-supercritical power units[J].Electric Power, 2008, 41(3):66-69.

王学根.某超超临界660 MW燃煤机组FCB试验不成功原因分析及改进[J].华东电力, 2014, 42(7):1503-1505.

WANG X G.Cause analysis and improvement of an unsuccessful FCB test on 660 MW ultra-supercritical coal-fired unit[J].East China Electric Power, 2014, 42(7):1503-1505.

中国电机工程学会, 火力发电厂安全性评价[M].北京:中国电力出版社, 2009.

Chinese Society for Electrical Engineering.Safety evaluation of thermal power plant[M].Beijing:China Electric Power Press, 2009.

Views

下载量

CSCD

Alert me when the article has been cited

提交

Tools

Publicity Resources

Research on Deep Peak Shaving Performance of 1 000 MW Ultra-Supercritical Coal-Fired Boiler

Optimization of 700℃ Ultra-supercritical Single Reheat Power Generation System

Related Author

DING Yong

Mei YANG

Yunlong ZHOU

Jinfu YANG

Di WANG

Dongjiang HAN

Jiaxin BAO

Related Institution

China Energy Jiangxi New Energy Industry Co., Ltd.

School of Energy and Power Engineering, Northeast Dianli University

Chinese Academy of Sciences University, Haidian District

AI问答

⁰