Dongdong QI, Sibu WANG, Wenliang ZHAO, et al. Application of Wet Adhesion in Performance Testing of Anti-Corrosion Coatings[J]. Power Generation Technology, 2019, 40(1): 74-77.
DOI:
Dongdong QI, Sibu WANG, Wenliang ZHAO, et al. Application of Wet Adhesion in Performance Testing of Anti-Corrosion Coatings[J]. Power Generation Technology, 2019, 40(1): 74-77. DOI: 10.12096/j.2096-4528.pgt.18045.
Application of Wet Adhesion in Performance Testing of Anti-Corrosion Coatings
after the anti-corrosion coating is immersed for a certain period of time
if there is no foaming
cracking
falling off
etc.
the evaluation result is qualified. However
the adhesion and the corrosion resistance of some of the qualified coatings are greatly reduced. In this paper
eight kinds of anti-corrosion coatings qualified after soaking were selected
and the dry adhesion and wet adhesion after soaking in acidic environment were tested. The test results showed that the adhesion of some coatings after immersion was greatly reduced or lost
the metal matrix has obvious corrosion characteristics; the adhesion of some coatings was reduced; the adhesion of the two kinds of anti-corrosion coatings cured at room temperature was slightly increased. It can be seen that by comparing the dry/wet adhesion of the coating or tracking the change of adhesion during the coating service
the maintenance performance and development trend of the coating performance can be quantitatively grasped.
Yang Wenbin, Li Qingbiao.Improvement of corrosion protective performance of organic coatingon low carbon steel by PEO pretreatment[J].Progress in Organic Coatings, 2015(89):260-266.
Ramezanzadeh B, Attar M M.An evaluation of the corrosion resistance and adhesion properties of anepoxy-nanocomposite on a hot-dip galvanized steel(HDG) treated by different kinds of conversion coatings[J].Surface&Coatings Technology, 2011(205):4649-4657.
Eckert T.Plant engineering: aging degradation of coating service level 1 coatings-summary of EPRI coating aging project activities[R].USA: Electric Power Research Institute, Inc.2011.
Dene C.Revised wet stack design guide[R].USA: Electric Power Research Institute, Inc.2012.