Direct torque control of doubly fedinduction motor using three-level NPCinverter

Najib El Ouanjli; Aziz Derouich; Abdelaziz El Ghzizal; Mohammed Taoussi; Youness El Mourabit; Khalid Mezioui; Badre Bossoufi

doi:10.1186/s41601-019-0131-7

English Version Journal Login

您当前的位置：

首页 >

文章列表页 >

Direct torque control of doubly fedinduction motor using three-level NPCinverter

Original Research | 更新时间：2026-09-30

- Direct torque control of doubly fedinduction motor using three-level NPCinverter
- Protection and Control of Modern Power Systems Vol. 4, Issue 3, Pages: 1-9(2019)
- 作者机构：
  
  1. Laboratory of Production Engineering, Energy and Sustainable Development, Higher School of Technology, Sidi Mohamed Ben Abdellah University, Fez,Morocco
  2. Laboratory of Systems Integration and Advanced Technologies, Faculty of Sciences Dhar El Mahraz, Sidi Mohamed Ben Abdellah University, Fez,Morocco
  3. Laboratory of Electrical Engineering and Maintenance, ESTO School of Technology, University Mohammed I,Oujda,Morocco
- 作者简介：
- 基金信息：
- DOI：10.1186/s41601-019-0131-7
  CLC：
- Published：01 July 2019
- 稿件说明：
移动端阅览
Najib El Ouanjli, Aziz Derouich, Abdelaziz El Ghzizal, et al. Direct torque control of doubly fedinduction motor using three-level NPCinverter[J]. Protection and Control of Modern Power Systems, 2019, 4(3): 1-9.
DOI：

Najib El Ouanjli, Aziz Derouich, Abdelaziz El Ghzizal, et al. Direct torque control of doubly fedinduction motor using three-level NPCinverter[J]. Protection and Control of Modern Power Systems, 2019, 4(3): 1-9. DOI： 10.1186/s41601-019-0131-7.

摘要

This article presents the direct torque control (DTC) strategy for the doubly fed induction motor (DFIM) connected to two three-level voltage source inverters (3LVSIs) with neutral point clamped (NPC) structure. This control method allows to reduce the torque and flux ripples as well as to optimize the total harmonic distortion (THD) of motor currents. The use of 3LVSI increases the number of generated voltage

which allows improving the quality of its waveform and thus improves the DTC strategy. The system modeling and control are implemented in Matlab/ Simulink environment. The analysis of simulation results shows the better performances of this control

especially in terms of torque and flux behavior

compared to conventional DTC.

Abstract

especially in terms of torque and flux behavior

compared to conventional DTC.

关键词

Keywords

references

Views

下载量

CSCD

Alert me when the article has been cited

提交

Tools

Publicity Resources

Jointly improving energy efficiency and smoothing power oscillations of integrated offshore wind and photovoltaic power: a deep reinforcement learning approach

Improving low-voltage ride-throughcapability of a multimegawatt DFIG basedwind turbine under grid faults

Sliding mode approach applied tosensorless direct torque control of cageasynchronous motor via multi-level inverter

Power Quality Improvement of DSTATCOM Using Fast Hybrid-PLL-Based Control Method for Wind Energy Applications

Low-Carbon Economic Dispatch in Integrated Energy Systems: A Set-Based Interval Optimization with Decision Support Under Uncertainties

Related Author

Xiuxing Yin

Meizhen Lei

Mohamed Nadour

Ahmed Essadki

Tamou Nasser

Soukaina El Daoudi

Loubna Lazrak

Mustapha Ait Lafkih

Related Institution

The State Key Laboratory of Water Resources Engineering and Management, Wuhan University

The School of Information Science and Engineering, Zhejiang Sci-Tech University

Research Center of Engineering and Health Science and Technologies (STIS), High Normal School of Technical Education (ENSET), Mohammed V University

Research Center of Engineering and Health Science and Technologies, Higher National School of Computer Science and Systems Analysis (ENSIAS), Mohammed V University

Faculty of Sciences and Technology, Laboratory of Automatic, Energy Conversion and Microelectronics, Sultan Moulay Slimane University, Beni Mellal

AI问答

⁰