In-situ stress measurement and its application to Guangdong nuclear power stations
|更新时间:2026-06-25
|
In-situ stress measurement and its application to Guangdong nuclear power stations
Vol. 34, Issue 6, (2013)
作者机构:
中国地质科学院 地质力学研究所,北京,100081
作者简介:
基金信息:
DOI:
CLC:TU459
Online First:14 June 2013,
Published:2013
稿件说明:
移动端阅览
FENG Cheng-jun, CHEN Qun-ce, TAN Cheng-xuan, et al. In-situ stress measurement and its application to Guangdong nuclear power stations[J]. 2013, 34(6).
DOI:
FENG Cheng-jun, CHEN Qun-ce, TAN Cheng-xuan, et al. In-situ stress measurement and its application to Guangdong nuclear power stations[J]. 2013, 34(6).DOI:
In-situ stress measurement and its application to Guangdong nuclear power stations
According to the in-situ stress measurement results with the method of hydraulic fracturing measurement at three nuclear power stations in Guangdong province
the distribution characteristics of current in-situ stress state at each nuclear power station are obtained. The results show that the horizontal stresses are dominant at each nuclear power station; and that horizontal principal stresses increases linearity with the depth at Dayawan and Yangjiang nuclear power station
while the phenomenon is not obvious at Taishan nuclear power station; and that the direction of maximum horizontal principal stress is NW-NWW at Dayawan and Yangjiang; however
is NNW at Taishan. Based on the data of stress and the interrelated theories as well as criterions
it is concluded that major axis orientation of tunnels at Dayawan goes against the stabilities of the tunnels; while these are beneficial to tunnels’ stability at Taishan and Yangjiang; and that the favorite shapes of all tunnels’ cross-section are ellipses with horizontal long axis
vertical short axis and long to short axis ration as lateral pressure coefficient; and that the rock burst is not happened during tunnels excavation at different buried depth. Finally
based on the sliding friction criteria of fault
the stabilities of the active faults are discussed.