Analysis of fluid flow through a rough joint considering effect of contact area

XIAO Wei-min; XIA Cai-chu; WANG Wei; BIAN Yue-wei

English Version Journal Login

您当前的位置：

首页 >

文章列表页 >

Analysis of fluid flow through a rough joint considering effect of contact area

更新时间：2026-06-25

- Analysis of fluid flow through a rough joint considering effect of contact area
- Vol. 34, Issue 7, (2013)
- 作者机构：
  
  1. 同济大学岩土及地下工程教育部重点实验室,上海,200092
  2. 同济大学地下建筑与工程系,上海,200092
  3. 上海市闵行区建设工程安全质量监督站,上海,201100
- 作者简介：
- 基金信息：
- DOI：
  CLC： TU452
- Online First：15 July 2013，
  
  Published：2013
- 稿件说明：
移动端阅览
XIAO Wei-min, XIA Cai-chu, WANG Wei, et al. Analysis of fluid flow through a rough joint considering effect of contact area[J]. 2013, 34(7).
DOI：

XIAO Wei-min, XIA Cai-chu, WANG Wei, et al. Analysis of fluid flow through a rough joint considering effect of contact area[J]. 2013, 34(7). DOI：

摘要

节理中接触面积的存在使得渗流曲折效应更加明显，将对渗流产生显著影响。为了研究节理接触面积对节理渗流的影响，建立节理渗流概念模型，推导得到了节理渗流的接触面积影响系数；然后在节理渗流计算公式中引入该影响系数，得到了考虑接触面积影响的渗流计算公式。同时，由于接触面积的存在使得渗流曲折因子的计算更为复杂，在获得节理隙宽分布的基础上提出了计算节理渗流曲折因子的五点比较法。然后以人工大理岩节理试件为研究对象，在获得其三维表面形貌的基础上，一方面对其进行不同接触状态下5级法向应力作用下的渗流试验；另一方面，在根据节理试件的三维表面形貌数据计算节理的渗流平均曲折因子和接触面积比的基础上，分别采用考虑接触面积影响的渗流计算公式和Zimmerman计算公式对节理试件在不同法向应力作用下的渗流体积流量进行计算，并将计算结果与实测值进行比较。结果表明：考虑接触面积影响的渗流计算公式计算结果与实测值吻合较好，从而验证了考虑接触面积影响的渗流计算公式的正确性，而Zimmerman计算公式高估了节理的渗流流量。

Abstract

The contact area will make flow tortuosity more obvious and influence the flow rate significantly. In order to investigate the effect of contact area on fluid flow through joint

a conceptual flow model is established to obtain the contact influential coefficient. And the influential coefficient is introduced into the equation for flow rate calculation considering the effect of tortuosity; a new equation considering the effect of contact area is derived. As the contact area makes the calculation of tortuosity coefficient more complicated

an algorithm for calculating the average tortuosity coefficient is proposed based on the joint aperture distribution. An artificial marble joint is taken as an object and the surface topography data are scanned. In one hand

flow tests are carried out on the joint specimen under five levels of normal stresses. In the other hand

on the basis of the average tortuosity coefficients and contact area ratios of joint specimen under five levels of normal stresses calculated according to the joint surface topography data

the volumetric flow rates through joint specimen are predicted by the new equation considering contact area presented in this paper and Zimmerman's equation

respectively. Then the predictions of the two equations are compared with experimental observations. It is shown from the comparison results that the predictions of the new equation agree well with experimental observations

while Zimmerman's equation overestimates the flow rate through the joint

thus validating the veracity of the new equation.

关键词

Keywords

references

Views

1838

下载量

CSCD

Alert me when the article has been cited

提交

Tools

Publicity Resources

Investigation of contact characteristics of sandstone joint under normal stress using pressure-sensitive film

Rockburst criterion for deep-buried tunnels based on rock integrity failure criterion

Effect of enzyme-induced calcium carbonate precipitation on mechanical properties and microstructure of 3D printed sandstone-like specimens

Discussion on key issues of TBM construction for long and deep tunnels

Experimental validation of modified Maksimovic peak shear strength criterion for rock fractures

Related Author

GONG Geng

PAN Jia

ZHAO Li-chun

XIONG Feng

ZHANG Guo-hua

TANG Zhi-cheng

WEI Shi-yan

GUO Jian-qiang

Related Institution

Faculty of Engineering, China University of Geosciences

Jarud Banner Zhahanaoer Coal Industry Co., Ltd.

Key Laboratory of Geological Survey and Evaluation of Ministry of Education, China University of Geosciences

School of Civil Engineering, Guizhou University

School of Civil Engineering, Chang’an University

AI问答

⁰