A new method for analyzing influence of pile tip soil properties on single pile settlement considering stress dispersion

WANG Kui-hua; Lü Shu-hui; WU Wen-bing; LUO Yong-jian; WU Deng-hui

English Version Journal Login

您当前的位置：

首页 >

文章列表页 >

A new method for analyzing influence of pile tip soil properties on single pile settlement considering stress dispersion

更新时间：2026-06-25

- A new method for analyzing influence of pile tip soil properties on single pile settlement considering stress dispersion
- Vol. 34, Issue 3, (2013)
- 作者机构：
  
  1. 浙江大学软弱土与环境土工教育部重点实验室,杭州,310027
  2. 中国地质大学（武汉）工程学院,武汉,430074
- 作者简介：
- 基金信息：
- DOI：
  CLC： TU473
- Online First：20 March 2013，
  
  Published：2013
- 稿件说明：
移动端阅览
WANG Kui-hua, Lü Shu-hui, WU Wen-bing, et al. A new method for analyzing influence of pile tip soil properties on single pile settlement considering stress dispersion[J]. 2013, 34(3).
DOI：

WANG Kui-hua, Lü Shu-hui, WU Wen-bing, et al. A new method for analyzing influence of pile tip soil properties on single pile settlement considering stress dispersion[J]. 2013, 34(3). DOI：

摘要

基于虚土桩模型，分析了层状地基中桩端土性对单桩沉降特性的影响。首先，以虚土桩扩散角反映桩端土层应力扩散效应，将桩端一定锥角范围内由桩端至基岩面的土体视为虚土桩，并根据其变截面特性，将虚土桩沿纵向划分为有限个微元段。然后，对桩及虚土桩桩侧土体采用理想弹塑性荷载传递模型，利用荷载传递法，推导了层状地基中以桩侧土塑性发展深度为变量的单桩荷载-沉降递推计算方法，并进一步得到了桩身轴力及桩侧摩阻力递推计算式。在此基础上，给出了荷载传递模型参数选取方法，并分析了虚土桩临界深度的影响因素及由实测荷载-沉降曲线反演虚土桩扩散角的可行性。最后，利用该方法分析了桩端沉渣和软弱下卧层对荷载-沉降曲线的影响。结果表明，考虑桩端土层应力扩散效应时，通过计算得到的桩顶及桩端荷载-沉降曲线与实测曲线吻合较好；当桩端存在沉渣或软弱下卧层时，采用虚土桩模型的单桩沉降计算方法可以在一定程度上反映沉渣特性及软弱下卧层埋深等因素对桩顶荷载-沉降曲线的影响。

Abstract

Based on virtual soil-pile model

the influence analysis of pile tip soil properties on single pile settlement is conducted in terms of layered soils. Firstly

considering stress dispersion in soil medium

the soil between pile tip and bedrock surface is assumed to be virtual soil-pile. Furthermore

the virtual soil-pile with variable cross-section is divided into finite segments. Then

the surrounding soil layers of pile is modeled as ideal elastoplastic transfer model; and regarding the developmental plastic depth as an independent variable

a recursive method for calculating axial force and side friction of pile in layered soil is derived by load transfer method. On this basis

parameters selection of load transfer model is studied; meanwhile

the factors of virtual soil-pile length and the feasibility of acquiring stress dispersion angle through inversion analysis are analyzed. Finally

by means of the presented method

the difference of load-displacement curves has been examined when pile bottom sediment and soft substratum exist. The results show that: the calculated load-displacement curves of pile tip and pile top agree well with the measured curves considering stress dispersion of pile tip soil; the presented method can take the influences of pile bottom sediment and soft substratum on load-displacement curves into consideration.

关键词

Keywords

references

Views

1921

下载量

CSCD

Alert me when the article has been cited

提交

Tools

Publicity Resources

Reliability analysis of pile groups with different lengths in expansive soils with spatial variation considering the effect of rainfall

Settlement calculation of CFG pile composite foundation based on load transfer method

Study of loading characters of pile foundation due to unloading of deep foundation pit excavation

Load bearing capacity analysis of single jacked pile considering lateral squeezing effect in sand ground

Experimental study on the definition and evolution characteristics of unfrozen water retention states in frozen clay

Related Author

WANG Qiao

ZHA Fu-sheng

LIU Shan-wei

TAN Xiao-hui

ZHANG Jun

SUN Qing

LIU Kan

WANG Yuan

Related Institution

School of Resources and Environmental Engineering, Hefei University of Technology

Technical Center, China Construction Third Engineering Division, Co. Ltd.

Key Laboratory of Geotechnical and Underground Engineering of Ministry of Education, Tongji University

Department of Geotechnical Engineering, Tongji University

Institute of Geotechnical Engineering, Hunan University

AI问答

⁰