Study on calculating methods of soil vertical deformation induced by pipe jacking construction

WEI Gang; CHEN Chun-lai; YU Jian-ying

English Version Journal Login

您当前的位置：

首页 >

文章列表页 >

Study on calculating methods of soil vertical deformation induced by pipe jacking construction

更新时间：2026-06-25

- Study on calculating methods of soil vertical deformation induced by pipe jacking construction
- Vol. 28, Issue 3, (2007)
- 作者机构：
  
  浙江大学城市学院土木工程系,杭州,310015
- 作者简介：
- 基金信息：
- DOI：
  CLC： TU431
- Online First：28 August 2013，
  
  Published：2007
- 稿件说明：
移动端阅览
WEI Gang, CHEN Chun-lai, YU Jian-ying. Study on calculating methods of soil vertical deformation induced by pipe jacking construction[J]. 2007, 28(3).
DOI：

WEI Gang, CHEN Chun-lai, YU Jian-ying. Study on calculating methods of soil vertical deformation induced by pipe jacking construction[J]. 2007, 28(3). DOI：

摘要

对前人工作进行总结，将3个已有的经验公式合并成一个通用经验公式，该公式可以计算由土体损失引起的土体中任一点沉降。假定土体不排水，利用弹性力学的Mindlin解推导了顶管正面附加推力、掘进机和后续管道与土体之间的摩擦力引起的土体垂直变形计算公式。结合土体损失引起的土体变形计算公式，得到顶管施工引起的总的土体垂直变形计算公式，该方法适用于施工阶段。算例分析表明，正面附加推力引起开挖面前方地面隆起，后方地面沉降，以开挖面正上方为轴线呈反对称分布，在正常施工时产生的地面变形较小；掘进机和后续管道与土体之间的摩擦力引起的地面变形分布规律与正面附加推力相似，轴线分别位于掘进机中间部位和后续管道中间部位的正上方。

Abstract

Based on the previous study

general empirical formula to calculate settlement at any point is advanced by combining three existing empirical formulae. Assuming soil is not drained

the computing formulas of soil vertical deformation induced both by bulkhead additive thrust

force of friction between shield and soil

and force of friction between follow-up pipes and soil are derived from the Mindlin solution in elastic mechanics. Combining the formula of ground deformation induced by ground loss

the formula of total soil vertical deformation induced by pipe jacking construction is obtained. This method can be applied to the construction phase. As is shown in analytical calculation

bulkhead additive thrust will make the frontal soil of excavation face heave and the rear soil subside. Surface deformation induced by bulkhead additive thrust is small during normal construction; and the curves are anti-symmetry with axes of excavation face. For the surface deformation induced by force of friction between shield and soil and induced by force of friction between follow-up pipes and soil

both of their curve distributions are similar to that of bulkhead additive thrust with the axes at the middle of shield and at the middle of follow-up pipes respectively.

关键词

Keywords

references

Views

1970

下载量

CSCD

Alert me when the article has been cited

提交

Tools

Publicity Resources

Analysis of superimposed load induced by propulsion of adjacent level parallel pipe-jacking

Study of three-dimensional soil deformation caused by double-line parallel shield tunnel construction

Analysis and calculation of superimposed load induced by double parallel shield tunnelling

Analysis of superimposed stress of surrounding soil due to shield tunneling

Reaction distribution investigation and structural analysis of composite thrust wall of rectangular pipe jacking shaft

Related Author

WEI Gang

WEI Xin-jiang

WEI Gang

PANG Si-yuan

QI Jing-jing

XU Ri-qing

WEI Gang

QI Jing-jing

Related Institution

Department of Civil Engineering, Zhejiang University College City

Shengli Oilfield Technology Inspection Center, Sinopec

College of Civil Engineering and Architecture, Zhejiang University

Department of Civil Engineering, City College, Zhejiang University

College of Civil Engineering and Architecture，Zhejiang University

AI问答

⁰