Research on catalytic oxidation of NO from diesel engine using MnOx-CeO2，composite oxides

王攀; 孙川; 张博; 罗鹏; 雷利利

您当前的位置：

首页 >

文章列表页 >

Research on catalytic oxidation of NO from diesel engine using MnOx-CeO2，composite oxides

更新时间：2026-04-16

- Research on catalytic oxidation of NO from diesel engine using MnOx-CeO2，composite oxides
- Vol. 39, Issue 2, Pages: 53-58(2018)
- 作者机构：
- 作者简介：
- 基金信息：
- DOI：
  CLC：
- Published：2018
- 稿件说明：
移动端阅览
王攀，孙川,张博,罗鹏,雷利利.MnOx-CeO2复合氧化物催化氧化柴油机NO性能研究[J].内燃机工程,2018,39(2):53-58.

王攀, 孙川, 张博, et al. Research on catalytic oxidation of NO from diesel engine using MnOx-CeO2，composite oxides[J]. 2018, 39(2): 53-58.
王攀，孙川,张博,罗鹏,雷利利.MnOx-CeO2复合氧化物催化氧化柴油机NO性能研究[J].内燃机工程,2018,39(2):53-58. DOI：

王攀, 孙川, 张博, et al. Research on catalytic oxidation of NO from diesel engine using MnOx-CeO2，composite oxides[J]. 2018, 39(2): 53-58. DOI：

摘要

为了研究MnOx-CeO2复合氧化物催化氧化柴油机NO的性能，采用溶胶凝胶法制备了不同Mn/Ce摩尔比的xMn10Ce/γ-Al2O3（x=5，6，7，8）催化剂。利用X射线衍射（X-ray diffraction，XRD）、X射线光电子能谱（X ray photoelectron spectroscopy，XPS）和H2 程序升温还原（H2temperature programmed reduction，H2-TPR）技术分别对其物相结构、元素价态及还原性能进行了表征。结果表明：CeO2晶粒尺寸随Mn含量增加而逐渐变大，同时添加适量的Mn也有利于提高催化剂中Mn4+的数量，从而促进NO氧化；当x=6时，催化剂的氧化还原性能最好。最后，基于模拟气试验平台考察了不同Mn/Ce比对xMn10Ce/γ-Al2O3催化剂氧化NO性能的影响。结果表明：在350℃时，NO浓度达饱和所需时间和反应速率与Mn添加量呈非线性关系；在250~450℃范围内，6Mn10Ce/γ-Al2O3的NO氧化性能最好，其NO浓度在350℃时最先达到稳定，仅需4 min，但在450 ℃时则延长至6 min，这主要是受热力学平衡及随反应进行活性氧数量及氧空位逐渐饱和共同作用的结果。

Abstract

In order to research into the influence of MnOx-CeO2 composite oxides on catalytic oxidation of NO from diesel engine

a series of xMn10Ce/γ-Al2O3（x=5

8) catalysts with different Mn/Ce mole ratio were prepared by the solgel method. A combination of characterization techniques

namely X-ray diffraction(XRD)

X-ray Photoelectron Spectroscopy（XPS) and H2 Temperature Programmed Reduction（H2-TPR)

was adopted to analysis its phase structure

element valence and reducibility

respectively. Results illustrate that the grain size of ceria gradually increases with the rise in Mn content

and the addition of appropriate amount of Mn is also beneficial to the increase of the number of Mn4+ in the catalyst

so as to promote the oxidation of NO. When x is equal to 6

the catalyst has the best redox properties. Finally

the impact of different Mn/Ce mole ratio on NO oxidation performance of xMn10Ce/γ-Al2O3 catalysts was investigated based on a simulated gas bench test. Test results show that at a temperature of 350 ℃

the time required for NO concentration to reach saturation and the reaction rate are nonlinear with the amount of Mn added when the temperature is between 250 ℃ and 450 ℃

the NO oxidation properties of 6Mn10Ce/γ-Al2O3 are the best. At this time

the timing required for NO concentration to reach stability is only 4 min

but it is extended to 6 min at 450 ℃

which is mainly the result of a combination of the thermodynamic equilibrium as well as the amount of active oxygen and the gradual saturation of oxygen vacancy during the reaction.

关键词

Keywords

references

Views

809

下载量

CSCD

Alert me when the article has been cited

提交

Tools

Publicity Resources

Influences of Injection Strategies on Combustion and Emissions of a Diesel Engine with Two Injectors

Vibro–Acoustic Coupling Characteristics of the Cylinder Liner–Water Jacket System for Diesel Engines

Application Testing of Electrically Heated Catalyst Technology in Future Diesel Engine Aftertreatment Systems

Related Author

WANG Haojin

HE Xiaole

YAN Hao

CHEN Xin

ZHOU Jiahao

WANG Man

CAO Rongxue

LIAO Jianxiong

Related Institution

College of Energy and Power Engineering， Xihua University

College of Electrical and Electronic Information Engineering， Xihua University

Xiangyang Daan Automobile Inspection Center Co.， Ltd.， Xiangyang

Key Laboratory of Fluid and Power Machinery， Ministry of Education， Xihua University

School of Energy and Electrical Engineering， Chang’an University

AI问答

⁰