STUDY ON AND PRACTICE OF PIPE-BLOWING USING STEAM UNDER CONDITION WITHOUT BOILER WATER CIRCULATION PUMP FOR ONCE-THROUGH BOILER OF ULTRA-SUPERITICAL 1 000 MW UNIT

CUI Zhendong1; LI Xinhu1; YIN Fengjun2 1.Electric Power Science Research Institute under Guangdong Power Grid Corporation

English Version Reader LoginJournal Login

您当前的位置：

首页 >

文章列表页 >

STUDY ON AND PRACTICE OF PIPE-BLOWING USING STEAM UNDER CONDITION WITHOUT BOILER WATER CIRCULATION PUMP FOR ONCE-THROUGH BOILER OF ULTRA-SUPERITICAL 1 000 MW UNIT

更新时间：2025-09-28

- STUDY ON AND PRACTICE OF PIPE-BLOWING USING STEAM UNDER CONDITION WITHOUT BOILER WATER CIRCULATION PUMP FOR ONCE-THROUGH BOILER OF ULTRA-SUPERITICAL 1 000 MW UNIT
- Thermal Power Generation Vol. 40, Issue 7, Pages: 74-77(2011)
- 作者机构：
  
  1. 广东电网公司电力科学研究院
  2. 广东惠州平海发电厂有限公司
- 作者简介：
- 基金信息：
- DOI：
  CLC： TK229.2
- Published：2011
- 稿件说明：
移动端阅览
CUI Zhendong1, LI Xinhu1, YIN Fengjun2 1.Electric Power Science Research Institute under Guangdong Power Grid Corporation. STUDY ON AND PRACTICE OF PIPE-BLOWING USING STEAM UNDER CONDITION WITHOUT BOILER WATER CIRCULATION PUMP FOR ONCE-THROUGH BOILER OF ULTRA-SUPERITICAL 1 000 MW UNIT[J]. Thermal power generation, 2011, 40(7): 74-77.
DOI：

CUI Zhendong1, LI Xinhu1, YIN Fengjun2 1.Electric Power Science Research Institute under Guangdong Power Grid Corporation. STUDY ON AND PRACTICE OF PIPE-BLOWING USING STEAM UNDER CONDITION WITHOUT BOILER WATER CIRCULATION PUMP FOR ONCE-THROUGH BOILER OF ULTRA-SUPERITICAL 1 000 MW UNIT[J]. Thermal power generation, 2011, 40(7): 74-77. DOI：

摘要

广东平海发电厂有限公司超超临界1 000MW机组直流锅炉采用832t/h最大保护直流流量

因炉水循环泵不能投运

导致机组起动阶段锅炉给水温度仅50℃左右

严重低于设计值(105℃)。对此

通过在锅炉起动排放系统上增加一路到除氧器的临时回收系统

实现了超超临界机组锅炉无炉水循环泵吹管

满足了机组冲转的参数要求。

Abstract

The once-through boiler of ultra-supercritical 1 000 MW unit in Guangdong Pinghai Power Plant Co Ltd

adopts maximum protecting once-through flow rate of 832 t/h

owing to the boiler water circulating pump(BWCP) can't be put into service

the feed-water temperature of boiler in the stage of start-up only can reach about 50 ℃

it is far lower than the designed value 105 ℃.For this

a temporary recovery system to the deaerator was added onto the discharging system during the time of boiler start-up

the pipe-blowing of ultra-supercritical unit under condition without BWCP has been realized

satisfying the requirement of parameters for rotation-impulsing.

关键词

Keywords

references

Views

134

下载量

CSCD

Alert me when the article has been cited

提交

Tools

Publicity Resources

TECHNICAL FEATURES OF PIPE-BLOWING ON ULTRA-SUPERCRITICAL 660 MW UNIT IN JINGGUANGSHAN POWER PLANT

COMPARISON OF STRUCTURAL DESIGN FOR THREE 1000 MW STEAM TURBINES

OPTIMIZATION OF CONTROL LOGIC FOR PREVENTING EXPLOISION IN TOWER TYPE FURNACE OF BOILER EQUIPED FOR 1000 MW UNIT

STUDY ON RETROFITING INDUCED DRAFT FAN AND FGD BOOSTER FAN TOGETHER FOR 1000 MW UNIT

STUDY ON THE CONTROL MODEL OF INTERMEDIARY POINT TEMPERATURE IN BOILER OF ULTRA-SUPERCRITICAL UNIT BASED ON DYNAMIC MECHANISM ANALYSIS

Related Author

FU Longlong

MA Xiaolong

XIN Junfang

ZHAO Jingtao Xi'an Thermal Power Research Institute Co Ltd

ZHU Bao-tianXi'an Thermal Power Research Institute Co Ltd

ZHU Jiang-tao

ZHU Jie-nan

GAO Jin-yao

Related Institution

Xi'an Thermal Power Research Institute Co., Ltd

Guohua Zhejiang Energy Generation Co., Ltd

Guodian Taizhou Power Generation Co., Ltd

Department of Automation, Wuhan University

School of Power and Mechanical Engineering, Wuhan University

AI问答

⁰