DESIGN OF CONTROL LOGIC FOR PUTTING TWO STEAM-DRIVEN FEED-WATER PUMPS OF SUPERCRITICAL 660 MW UNIT INTO PARALLEL OPERATION OR STOPPING ONE FROM SERVICE
|更新时间:2025-09-28
|
DESIGN OF CONTROL LOGIC FOR PUTTING TWO STEAM-DRIVEN FEED-WATER PUMPS OF SUPERCRITICAL 660 MW UNIT INTO PARALLEL OPERATION OR STOPPING ONE FROM SERVICE
Thermal Power GenerationVol. 41, Issue 1, Pages: 69-73(2012)
作者机构:
1. 山西电力职业学院动力工程系
2. 大同发电有限责任公司
作者简介:
基金信息:
DOI:
CLC:TM621
Published:2012
稿件说明:
移动端阅览
LI Tiecang1, QIN Zhiguo2, BAI Jingping2 1.Department of Power Engineering. DESIGN OF CONTROL LOGIC FOR PUTTING TWO STEAM-DRIVEN FEED-WATER PUMPS OF SUPERCRITICAL 660 MW UNIT INTO PARALLEL OPERATION OR STOPPING ONE FROM SERVICE[J]. Thermal power generation, 2012, 41(1): 69-73.
DOI:
LI Tiecang1, QIN Zhiguo2, BAI Jingping2 1.Department of Power Engineering. DESIGN OF CONTROL LOGIC FOR PUTTING TWO STEAM-DRIVEN FEED-WATER PUMPS OF SUPERCRITICAL 660 MW UNIT INTO PARALLEL OPERATION OR STOPPING ONE FROM SERVICE[J]. Thermal power generation, 2012, 41(1): 69-73.DOI:
DESIGN OF CONTROL LOGIC FOR PUTTING TWO STEAM-DRIVEN FEED-WATER PUMPS OF SUPERCRITICAL 660 MW UNIT INTO PARALLEL OPERATION OR STOPPING ONE FROM SERVICE
Directing against the problem concening large fluctuation of feed-water flow resulted from the process of automatically putting two steam-driven feed-water pumps into parallel operation or stopping one from service during the time of load variation for supercritical 660 MW unit in Datong Power Generation Co Ltd
a control logic for solution of said problem has been designed on the basis of characters of unit no.10
and a control test for said pump's operation being carried out.According to this control logic
the fluctuation of feed-water flow into the boiler is less than 20 t/h during the time of putting two said pumps into parallel operation
and the fluctuation of feed-water flow into the boiler is less than 55 t/h in the event of one pump being stooped.It shows that the said control logic can satisfy the control requirement of the feed-water system
ensuring safety and stability in operation of unit.