STUDY ON SIZE-ENLARGING TECHNOLOGY OF SEA-WATER DESALINATION EQUIPMENT BY USING LOW-TEMPERATURE MULTI-EFFECT DISTILLATION
|更新时间:2025-09-28
|
STUDY ON SIZE-ENLARGING TECHNOLOGY OF SEA-WATER DESALINATION EQUIPMENT BY USING LOW-TEMPERATURE MULTI-EFFECT DISTILLATION
Thermal Power GenerationVol. 41, Issue 6, Pages: 85-88(2012)
作者机构:
神华国华(北京)电力研究院有限公司
作者简介:
基金信息:
DOI:
CLC:P747.1
Published:2012
稿件说明:
移动端阅览
ZHANG Jianli, DING Tao, ZHOU Hongguang, et al. STUDY ON SIZE-ENLARGING TECHNOLOGY OF SEA-WATER DESALINATION EQUIPMENT BY USING LOW-TEMPERATURE MULTI-EFFECT DISTILLATION[J]. Thermal power generation, 2012, 41(6): 85-88.
DOI:
ZHANG Jianli, DING Tao, ZHOU Hongguang, et al. STUDY ON SIZE-ENLARGING TECHNOLOGY OF SEA-WATER DESALINATION EQUIPMENT BY USING LOW-TEMPERATURE MULTI-EFFECT DISTILLATION[J]. Thermal power generation, 2012, 41(6): 85-88.DOI:
STUDY ON SIZE-ENLARGING TECHNOLOGY OF SEA-WATER DESALINATION EQUIPMENT BY USING LOW-TEMPERATURE MULTI-EFFECT DISTILLATION
摘要
在2.5万t/d低温多效蒸馏(LT-MED)海水淡化试验装置上通过改变工艺参数
考察装置操作温度、工艺流程、蒸发器换热管布置、物料海水流量及其过冷度对淡水产量的影响。结果表明
在工作蒸汽量相同的条件下
低温2效产水量只有高温2效产水量的50%~70%;适当预热物料海水
有利于提高蒸发器的工作效率;换热管倾斜布置
对提高蒸发器换热效果作用不显著;加大物料海水喷淋量将减小淡水产量和造水比
喷淋密度宜保持在0.04~0.06kg/ms范围内。
Abstract
On interim-test equipment of sea-water desalination using low-temperature and multi-effect distillation(LT-MED) with output capacity of 25-thousand t/d
through changing the technological parameters
the influence of working temperature in operation of equipment
technological process
arrangement of heat-exchaning pipes in the evaporater
flow rate of material and sea-water
and degree of over cooling upon the output of fresh water has been investigated.Results show that the water yield under condition of low temperature and two-effect mode is only 50%~70% of that in high-temperature and two-effect mode;suitably preheating material and sea-water is advantageous to enhance the work efficiency of the evaporator;the declination arrangement of heat-exchanging pipes hasn't substantial effectiveness for enhancing the heat-exchanging in evaporator;increasing the spray amount of material and sea-water will decrease the output of fresh water and the water-making ratio;and the spraying density is adequate to maintain in a range of 0.04~0.06 kg/ms.