COMMON PROBLEMS AND CASE STUDY FOR PIPE SUPPORTS AND HANGERS IN POWER GENERATING UNITS
|更新时间:2025-09-28
|
COMMON PROBLEMS AND CASE STUDY FOR PIPE SUPPORTS AND HANGERS IN POWER GENERATING UNITS
Thermal Power GenerationVol. 41, Issue 11, Pages: 80-82(2012)
作者机构:
1. 西安热工研究院有限公司
2. 中核核电运行管理有限公司
作者简介:
基金信息:
DOI:
CLC:TM621
Published:2012
稿件说明:
移动端阅览
AN Hui1, AN Fuli1, HAN Guanghui2, et al. COMMON PROBLEMS AND CASE STUDY FOR PIPE SUPPORTS AND HANGERS IN POWER GENERATING UNITS[J]. Thermal power generation, 2012, 41(11): 80-82.
DOI:
AN Hui1, AN Fuli1, HAN Guanghui2, et al. COMMON PROBLEMS AND CASE STUDY FOR PIPE SUPPORTS AND HANGERS IN POWER GENERATING UNITS[J]. Thermal power generation, 2012, 41(11): 80-82.DOI:
COMMON PROBLEMS AND CASE STUDY FOR PIPE SUPPORTS AND HANGERS IN POWER GENERATING UNITS
摘要
对发电机组管道支吊架检验及调整中的常见问题及其原因进行了分析
结合实际案例
对管道变形、管道下沉、管道热膨胀异常、管道振动等常见问题提出了相应的解决方法和措施。分析认为
新机组支吊架存在的问题主要为设计、安装缺陷
因此机组投运前
应对管道支吊架状态进行全面、系统的检验与调整;若需大范围更换容重相差较大的保温材料或管件时
应对管系应力重新进行计算
对受影响的支吊架进行相应的调整
防止破坏管系的载荷平衡。
Abstract
Based on the examination and adjustment experience of supports and hangers in recent years
the common problems occurred were systematically summarized and the reasons were analyzed.Combined with the actual cases
solution methods were proposed for these problems like pipe settlement
abnormal thermal expansion and vibration etc.Design and installation defects were the main problems for the new unit's supports and hangers.Therefore
systematical examination and complete regulation should be conducted for the supports and hangers before the unit put into service.If a wide range of replacement of insulating material or pipe is needed
the stress in piping system should be recalculated
and to prevent the force equilibrium of pipes from destroying
corresponding adjustment should be done on the affected supports and hangers.