RETROFITTING OF REFRACTORY BELT FOR W-FLAME BOILER
|更新时间:2025-09-28
|
RETROFITTING OF REFRACTORY BELT FOR W-FLAME BOILER
Thermal Power GenerationVol. 41, Issue 8, (2012)
作者机构:
1. 重庆电力高等专科学校
2. 重庆发电厂
3. 华能珞璜电厂
作者简介:
基金信息:
DOI:
CLC:TK223.21
Published:2012
稿件说明:
移动端阅览
ZENG Rong1, FENG Jiyong2, YU Changkai3 1.Chongqing Electric Power College. RETROFITTING OF REFRACTORY BELT FOR W-FLAME BOILER[J]. Thermal power generation, 2012, 41(8).
DOI:
ZENG Rong1, FENG Jiyong2, YU Changkai3 1.Chongqing Electric Power College. RETROFITTING OF REFRACTORY BELT FOR W-FLAME BOILER[J]. Thermal power generation, 2012, 41(8).DOI:
RETROFITTING OF REFRACTORY BELT FOR W-FLAME BOILER
摘要
由于煤质变差
某360MW机组"W"型火焰锅炉燃烧不稳
需大量投油助燃。对此
进行卫燃带改造。改造后
燃烧工况明显改善
火焰稳定性提高;助燃油投入量减少
机组负荷在200MW左右可不投油助燃;锅炉排烟温度由170~180℃降至150~160℃
大渣和飞灰含碳量降低。
Abstract
Poor coal quality causes combustion instability
thus large amount of fuel oil were necessary for a 360 MW unit with W-flame boiler.Therefore
against the low temperature level in the furnace of the boiler
retrofitting of the refractory belt was conducted.After the modification
combustion condition is significantly improved
and the flame stability is also enhanced.Moreover
fuel oil consumption decreases
and no oil is needed when the unit load is about 200 MW.Besides
the exhaust gas temperature reduces from 170~180 ℃ to 150~160 ℃
and the bottom ash and carbon content of fly ash decreases too.