SETTING SCHEME OF CONDENSATE POLISHING SYSTEM IN NUCLEAR POWER STATION WITH PRESSURIZED WATER REACTOR

LIN Jianzhong1; CAI Guanping2 1.Guangdong Electric Power Design Institute

English Version Reader LoginJournal Login

您当前的位置：

首页 >

文章列表页 >

SETTING SCHEME OF CONDENSATE POLISHING SYSTEM IN NUCLEAR POWER STATION WITH PRESSURIZED WATER REACTOR

更新时间：2025-09-28

- SETTING SCHEME OF CONDENSATE POLISHING SYSTEM IN NUCLEAR POWER STATION WITH PRESSURIZED WATER REACTOR
- Thermal Power Generation Vol. 41, Issue 11, Pages: 67-70(2012)
- 作者机构：
  
  1. 广东省电力设计研究院
  2. 华东电力设计院
- 作者简介：
- 基金信息：
- DOI：
  CLC： TM623.91
- Published：2012
- 稿件说明：
移动端阅览
LIN Jianzhong1, CAI Guanping2 1.Guangdong Electric Power Design Institute. SETTING SCHEME OF CONDENSATE POLISHING SYSTEM IN NUCLEAR POWER STATION WITH PRESSURIZED WATER REACTOR[J]. Thermal power generation, 2012, 41(11): 67-70.
DOI：

LIN Jianzhong1, CAI Guanping2 1.Guangdong Electric Power Design Institute. SETTING SCHEME OF CONDENSATE POLISHING SYSTEM IN NUCLEAR POWER STATION WITH PRESSURIZED WATER REACTOR[J]. Thermal power generation, 2012, 41(11): 67-70. DOI：

摘要

基于核电机组的设计和运行经验分析各种工况下压水堆核电站凝结水精处理系统运行的技术和经济效益

提出了凝结水精处理系统的设计原则为:核电机组凝结水精处理系统功能应满足机组起动和凝汽器发生冷却水泄漏时凝结水的净化需要

以便在机组正常运行时可不投运该系统;以海水作为冷却水时

应设置全流量的凝结水精处理系统;以淡水作为冷却水时

应根据冷却水含盐量、凝汽器泄漏允许值、二回路水质控制标准、蒸汽发生器排污量等相关因素经综合计算确定设计容量。凝结水精处理系统应采用"阳床-混床"工艺。

Abstract

Based on the design and operation experience of nuclear power unit at home and abroad

the technology and economic benefits of condensate polishing system for nuclear power station with pressurized water reactor(PWR) under various conditions were analyzed

and the design principle of this system was presented.It showed that

the condensate polishing system should meet the requirements of purifying the condensate water when the unit started and the cooling water leaked out.This system should not be operated when the unit ran normally.If using seawater as the cooling water

the polishing system should be set up with full flow.While when using fresh water as the cooling water

the capacity of this polishing system should be determined by comprehensive calculation considering relative factors such as salt content of the cooling water

allowable value of the condenser leakage

quality control standard of water in the secondary circuit

and the discharge capacity of the steam generator.The polishing system should adopt cation-mixed bed.

关键词

Keywords

references

Views

292

下载量

CSCD

Alert me when the article has been cited

提交

Tools

Publicity Resources

AN APPROACH TO APPLICATION OF THE POWDEX AND THE EXISTING PROBLEMS

Low periodic water production of condensate polishing mixed beds in a power plant:reason analysis and treatment

DEVELOPMENT OF BALL COLLECTOR AND DEBRIS FILTER OF THIRD GENERATION

Characteristics of a solar chimney with water production and power generation

Optimization and analysis of cold-end system in thermal power units

Related Author

HAN Li-chunXi'an Thermal Power-Research Institute Co Ltd

ZHOU Zhongkang

ZHENG Mincong

YANG Hao

JIN Hao

LI Jianhua

SUN Yuzhong

HAN Yongxia

Related Institution

Xi'an Thermal Power Research Institute Co., Ltd

Anhui Electric Power Science Research Institute

Datang Luohe Power Plant

Huaihu Coal and Electricity Tianji Power Plant

Guodian Tongling Power Generation Co., Ltd

AI问答

⁰