CAUSE ANALYSIS AND TREATMENT OF EXCESSIVE VIBRATION OF PILOT EXCITER BEARING
|更新时间:2025-09-28
|
CAUSE ANALYSIS AND TREATMENT OF EXCESSIVE VIBRATION OF PILOT EXCITER BEARING
Thermal Power GenerationVol. 41, Issue 12, Pages: 104-105(2012)
作者机构:
1. 神华国能重庆发电厂
2. 重庆电力高等专科学校动力工程系
作者简介:
基金信息:
DOI:
CLC:TM621
Published:2012
稿件说明:
移动端阅览
FENG Jiyong1, ZENG Rong2 1.Chongqing Power Plant. CAUSE ANALYSIS AND TREATMENT OF EXCESSIVE VIBRATION OF PILOT EXCITER BEARING[J]. Thermal power generation, 2012, 41(12): 104-105.
DOI:
FENG Jiyong1, ZENG Rong2 1.Chongqing Power Plant. CAUSE ANALYSIS AND TREATMENT OF EXCESSIVE VIBRATION OF PILOT EXCITER BEARING[J]. Thermal power generation, 2012, 41(12): 104-105.DOI:
CAUSE ANALYSIS AND TREATMENT OF EXCESSIVE VIBRATION OF PILOT EXCITER BEARING
摘要
某200MW机组副励磁机轴承发生漏油及振动突变、超标故障
检查分析结果表明
轴承润滑油进油量过大漏入副励磁机
并与灰尘积聚改变了副励磁机空气间隙
使转子与定子不同心
从而导致副励磁机振动过大。通过采取调整轴承油隙在规定范围内
选用孔径合适的进油缩孔控制进油量
保证副励磁机合格的空气间隙等措施后
振动消除
机组运行正常。
Abstract
Oil leakage
sudden and excessive vibration occurred on the bearing of pilot exciter in a 200 MW unit.Analysis showed that
too much bearing oil inflow caused the oil leaking into the pilot exciter and depositing with the dust
changing the air gap and making the stator centre be not concentric with the rotor centre
therefore over large vibration of the pilot exciter occurred.After such improvement as adjusting the bearing oil gap within the prescribed limit
adopting oil entrance with proper size to control the volume and ensuring the pilot exciter has qualified air gap