Research on average particle diameter in numerical simulation of pulverized coal combustion

LIU Zhili; WANG Shuqi; DENG Ping School of Energy and Power Engineering

English Version Reader LoginJournal Login

您当前的位置：

首页 >

文章列表页 >

Research on average particle diameter in numerical simulation of pulverized coal combustion

更新时间：2025-09-28

- Research on average particle diameter in numerical simulation of pulverized coal combustion
- Thermal Power Generation Vol. 42, Issue 5, Pages: 30-37(2013)
- 作者机构：
  
  长沙理工大学能源与动力工程学院
- 作者简介：
- 基金信息：
- DOI：
  CLC： TK229.6
- Published：2013
- 稿件说明：
移动端阅览
LIU Zhili, WANG Shuqi, DENG Ping School of Energy and Power Engineering. Research on average particle diameter in numerical simulation of pulverized coal combustion[J]. Thermal power generation, 2013, 42(5): 30-37.
DOI：

LIU Zhili, WANG Shuqi, DENG Ping School of Energy and Power Engineering. Research on average particle diameter in numerical simulation of pulverized coal combustion[J]. Thermal power generation, 2013, 42(5): 30-37. DOI：

摘要

提出了煤粉燃烧数值计算中煤粉的等燃尽率与等燃烧速度当量直径及其计算方法。运用燃煤锅炉煤粉射流的一维燃烧模型

将符合Rosin-Rammler分布的煤粉颗粒群的燃尽过程作为比较基准

对直径分别为等燃尽率当量直径、等燃烧速度当量直径以及"几何"平均直径的几种单一粒径的煤粉颗粒群在多种燃烧条件下进行了燃烧计算。通过对相同燃烧条件下燃尽率曲线的比较

得出了煤粉燃烧数值计算中煤粉当量直径的最佳计算方法

即采用直径为等燃尽率当量直径的单一粒径颗粒群时

在整个燃烧过程中

燃尽率与分布式粒径的煤粉颗粒群的计算结果十分接近。将等燃尽率当量直径运用在研究或实际运行工作中

有利于减轻煤粉燃烧计算工作量及及时分析煤粉的燃烧情况。

Abstract

The average diameter of equal burning speed and equal burn out rate of pulverized coal and their calculation method in numerical simulation of pulverized coal combustion were presented.The one dimensional combustion model of pulverized coal jet was applied to conduct calculation for coal particles with single diameter which equaled to the equal burn out rate average diameter

the equal burning rate average diameter and geometric average diameter respectively under various conditions

using the burn out process of coal particles which in accordance with Rosin-Rammler distribution as the comparison baseline.By comparison of burn out curves under the same condition

the optimal calculation method for average coal diameter was obtained.When using the equal burn out rate average diameter as the particle's single diameter

the burn out rate was very close to the calculation result of coal particles with distributed diameters during the whole combustion.Applying the equal burn out rate average diameter in the research and actual operation has significant meaning of easing off the combustion calculation and analyzing the combustion situation timely.

关键词

Keywords

references

Views

150

下载量

CSCD

Alert me when the article has been cited

提交

Tools

Publicity Resources

CAUSE ANALYSIS OF LOWER BURN-UP RATIO IN ANTHRACITE FIRING BOILERS WITH W-SHAPED FLAME AND TWIN-ARCH COMBUSTION

APPLICATION OF AIR-STAGED TECHNOLOGY ONTO COAL-WATER SLURRY FIRED UTILITY BOILER

AN APPROACH TO FURNACE CHARACTERISTIC PARAMETERS OF LARGE PULVERIXED-COAL FIRED BOILERS

Research progress of conversion and utilization of upgraded lignite by hydrothermal dewatering

Current status and development of control technologies for PM2.5 and Hg during pulverized coal combustion

Related Author

单凤玲

王新华

ZHAO Chenjie1

ZHOU Junhu2

LIU Jianzhong2

ZHOU Zhijun2

HUANG Zhenyu2

CEN Kefa2 1.Pyneo Co Ltd

Related Institution

Wuhan Boiler Co., Ltd

Wuhan Boiler Co., Ltd.

Zhejiang Baineng Technology Co., Ltd

State Key Laboratory of Clean Energy Utilization, Zhejiang University

AI问答

⁰