Calculation of emergency desuperheating water quantity at inlet of wet FGD system
|更新时间:2025-09-28
|
Calculation of emergency desuperheating water quantity at inlet of wet FGD system
Thermal Power GenerationVol. 42, Issue 6, Pages: 75-77(2013)
作者机构:
大唐王滩发电有限责任公司
作者简介:
基金信息:
DOI:
CLC:X773
Published:2013
稿件说明:
移动端阅览
NIE Pengfei, WANG Yang, ZHANG Hongyu, et al. Calculation of emergency desuperheating water quantity at inlet of wet FGD system[J]. Thermal power generation, 2013, 42(6): 75-77.
DOI:
NIE Pengfei, WANG Yang, ZHANG Hongyu, et al. Calculation of emergency desuperheating water quantity at inlet of wet FGD system[J]. Thermal power generation, 2013, 42(6): 75-77.DOI:
Calculation of emergency desuperheating water quantity at inlet of wet FGD system
摘要
基于某600MW机组锅炉的石灰石-石膏湿法烟气脱硫装置实际运行数据
设定事故烟温和喷淋后烟温
分别采用基于烟气比热容、摩尔焓值、湿度等参数对事故喷淋水量进行计算
并通过计算对应的烟气饱和湿度对3种计算结果进行了校核。根据上述计算结果
对脱硫系统的事故喷淋装置进行了改造。改后实际运行结果表明
3种计算方法准确可靠
可将脱硫入口烟气温度降至饱和温度。
Abstract
On the basis of the actual operation data of a 600 MW unit boiler equipped with limestone-gypsum wet flue gas desulfurization(FGD) device
the emergency glue gas temperature and sprayed gas temperature were set.Such parameters of flue gas as specific heat capacity
enthalpy value per mole and humidity were adopted to calculate the emergency desuperheating water quantity
respectively.Moreover
by calculation of flue gas saturated humidity
the above three results were checked.Based on above calculation results
the accident spray device of the FGD system was modified.The operation results after the improvement indicated that
the above three calculation methods were accurate and reliable
and the temperature of entrance flue gas can be decreased to the saturated temperature dramatically.