Off-design performance of an ultra-supercritical power unit applying MC system
|更新时间:2025-09-28
|
Off-design performance of an ultra-supercritical power unit applying MC system
Thermal Power GenerationVol. 43, Issue 7, Pages: 41-44(2014)
作者机构:
1. 广东电网公司电力科学研究院
2. 华北电力大学能源动力与机械工程学院
作者简介:
基金信息:
DOI:
CLC:TM621
Published:2014
稿件说明:
移动端阅览
KAN Weimin, SONG Jinghui, ZHOU Luyao, et al. Off-design performance of an ultra-supercritical power unit applying MC system[J]. Thermal power generation, 2014, 43(7): 41-44.
DOI:
KAN Weimin, SONG Jinghui, ZHOU Luyao, et al. Off-design performance of an ultra-supercritical power unit applying MC system[J]. Thermal power generation, 2014, 43(7): 41-44.DOI:
Off-design performance of an ultra-supercritical power unit applying MC system
On the basis of thermal system in conventional ultra-supercritical power generation units
a design scheme for a master cycle(MC)system was proposed.In this scheme
the steam extraction from the intermediate pressure(IP)cylinder is replaced by extracting steam from an added regenerative small steam turbine.Taking an ultra-supercritical 1 000MW unit as the example
the EBSILION software was applied to conduct thermodynamic and economic analysis for the conventional system and MC system under different working conditions.The results show that:the power generation efficiency of the unit applying the MC system is 0.15%and 0.24%higher than that using the conventional system
and the coal consumption rate is 0.92g/(kW ·h)and1.61g/(kW·h)lower
under design condition and 30%load condition
respectively.Thus
the ultra-supercritical unit employing MC system is more suitable to work under low-load working conditions.