Peaking capability and economic analysis for a 330MW cogeneration unit
|更新时间:2025-09-28
|
Peaking capability and economic analysis for a 330MW cogeneration unit
Thermal Power GenerationVol. 43, Issue 6, Pages: 7-10(2014)
作者机构:
1. 广东电网公司电力科学研究院
2. 华南理工大学电力学院
作者简介:
基金信息:
DOI:
CLC:TM611
Published:2014
稿件说明:
移动端阅览
ZHU Yu, LI Qianjun, FENG Yongxin, et al. Peaking capability and economic analysis for a 330MW cogeneration unit[J]. Thermal power generation, 2014, 43(6): 7-10.
DOI:
ZHU Yu, LI Qianjun, FENG Yongxin, et al. Peaking capability and economic analysis for a 330MW cogeneration unit[J]. Thermal power generation, 2014, 43(6): 7-10.DOI:
Peaking capability and economic analysis for a 330MW cogeneration unit
摘要
以某台双抽330MW热电联产机组为例
采用等效焓降法构建其变工况计算模型
利用该模型分别对纯凝工况、抽汽工况进行运行特性分析
计算得到"以热定电"下机组的调峰能力及其运行经济性。结果表明:在纯凝工况下机组负荷为50%时
低压缸内效率为71.1%
相比纯凝工况100%负荷降低了2.9%;纯凝工况调峰能力最强
幅度为163MW
但经济性最低;额定双抽工况的调峰幅度仅为79MW
调峰能力最小;当某一单抽流量为定值时
机组热效率随着另一抽汽流量的增大而增大。
Abstract
Taking a typical double extraction 330MW cogeneration unit as the research object
the variable condition model was built by applying the equivalent enthalpy drop method.On the basis of this model
the operation characteristics of this unit under pure condensing condition and extraction condition were investigated.The economic efficiency and peaking capacity of this unit under above two conditions were obtained.The results show that:under pure condensing condition
the low-pressure cylinder inner efficiency under 50% load condition was 71%
about 2.9% lower than that under 100% condition;the pure condensing condition had the strongest peaking capability(with a rate of 163MW)
but the lowest economy;the peaking rate of double extraction condition was only 79MW
which was the lowest;when one extraction flow rate was constant
the turbine power generation thermal efficiency increased with the other extraction flow rate.