Numerical study on a natural draft wet cooling tower with central catheter pipes

ZHOU Lanxin; WU Ruikang; DING Binkai; CHEN Jian

English Version Reader LoginJournal Login

您当前的位置：

首页 >

文章列表页 >

Numerical study on a natural draft wet cooling tower with central catheter pipes

更新时间：2025-09-28

- Numerical study on a natural draft wet cooling tower with central catheter pipes
- Thermal Power Generation Vol. 43, Issue 7, Pages: 27-31(2014)
- 作者机构：
  
  1. 华北电力大学电站设备状态监测与控制教育部重点实验室
  2. 国电蓬莱发电有限公司
  3. 国电山东石横发电厂
- 作者简介：
- 基金信息：
- DOI：
  CLC： TM621
- Published：2014
- 稿件说明：
移动端阅览
ZHOU Lanxin, WU Ruikang, DING Binkai, et al. Numerical study on a natural draft wet cooling tower with central catheter pipes[J]. Thermal power generation, 2014, 43(7): 27-31.
DOI：

ZHOU Lanxin, WU Ruikang, DING Binkai, et al. Numerical study on a natural draft wet cooling tower with central catheter pipes[J]. Thermal power generation, 2014, 43(7): 27-31. DOI：

摘要

针对现有冷却塔中央区域换热效果差的问题

提出了在塔内加装中央补风管的方案。将空气直接送入冷却塔中心区域

加强塔内换热。以某1 000MW机组冷却塔为例

采用Fluent软件建立冷却塔三维热力性能计算模型。计算结果表明

加装补风管后冷却塔出塔水温比改造前平均降低0.433℃

机组发电量增加2~3MW。

Abstract

Aiming at enhancing heat transfer in central area of the present cooling towers

new scheme that installing central catheter pipes in the tower was put forward.In this scheme

the fresh air is directly transported to central area of the cooling tower to enhance the heat and mass transfer.Taking a natural draft wet cooling tower for a 1 000MW unit as the example

its three-D thermal performance calculation model was established by the FLUENT software.The analysis show that

after the catheter pipes were installed

the outlet water temperature of the cooling tower dropped by an average of 0.433℃

and the unit power generation increased by 2to 3MW.

关键词

Keywords

references

Views

下载量

CSCD

Alert me when the article has been cited

提交

Tools

Publicity Resources

THE PRESSURE CONTROL OF HP BY-PASS SYSTEM FOR 1000MW UNIT

Influence of head wind velocity distribution on heat transfer performance of ACC single-row finned tubes

Primary frequency modulation of multivariable co-optimization for 1000MW units

Performance analysis of divergent solar chimney power plant system based on 3D turbine

Low-load operation characteristic analysis and comprehensive optimization of condensate system of a 1000MW unit

Related Author

DI ZhenzhenShanghai Waigaoqiao NO.3 Power Generation Co Ltd

YE Sheng

YANG Jianguo

DAI Shanliang

LIU Hao

GAO Lin

FU Yiwei

WANG Qian

Related Institution

Shanghai Waigaoqiao Third Power Generation Co., Ltd

Institute of Energy and Environment, Harbin Institute of Technology

Xi'an Xire Energy saving Technology Co., Ltd

Xi'an Thermal Power Research Institute Co., Ltd

School of Civil Engineering and Architecture, Wuhan University of Technology

AI问答

⁰